Search NASA⌕ Search

Engineering topics

Rausch, Kent D.

Publications and source records attributed to Rausch, Kent D..

Data for Coprocessing Corn Germ Meal for Oil Recovery and Ethanol Production, a Process Model for Lipid-Producing Energy Crops

Efforts to engineer high-productivity crops to accumulate oils in their vegetative tissue present the possibility of expanding biodiesel production. However, processing the new crops for lipid recovery and ethanol production from cell wall saccharides is challenging and expensive. In a previous study using corn germ meal as a model substrate, we reported that liquid hot water (LHW) pretreatment enriched the lipid concentration by 2.2 to 4.2 fold. This study investigated combining oil recovery with ethanol production by extracting oil following LHW and simultaneous saccharification and co-fermentation (SSCF) of the biomass. Corn germ meal was again used to model the oil-bearing energy crops. Pretreated germ meal hydrolysate or solids (160 °C and 180 °C for 10 minutes) were fermented, and lipids were extracted from both the spent fermentation whole broth and fermentation solids, which were recovered by centrifugation and convective drying. Lipid contents in spent fermentation solids increased 3.7 to 5.7 fold compared to the beginning germ meal. The highest lipid yield achieved after fermentation was 36.0 mg lipid g−1 raw biomass; the maximum relative amount of triacylglycerol (TAG) was 50.9% of extracted oil. Although the fermentation step increased the lipid concentration of the recovered solids, it did not improve the lipid yields of pretreated biomass and detrimentally affected oil compositions by increasing the relative concentrations of free fatty acids.

Conversion↗

Improving ethanol yields with deacetylated and two-stage pretreated corn stover and sugarcane bagasse by blending commercial xylose-fermenting and wild type Saccharomyces yeast

Corn stover and sugarcane bagasse are the most widely available agriculture processing biomass and could serve as feedstocks for production of biofuel. In this study, three different technologies are combined to develop a more efficient conversion process for each of these feedstocks. The three technologies are diluted alkaline deacetylation process, combined thermochemical and mechanical shear pretreatment, and fermentation using a combined inoculum of two commercial Saccharomyces yeast strains. The two yeast strains used were a non-GMO and GMO strain engineered for xylose fermentation. The final ethanol concentrations obtained were 35.7 g/L from deacetylated corn stover and 32.9 g/L from sugarcane bagasse. Blending the two yeast reduced residual xylose content from 1.24 g/L to 0.48g/L and increased ethanol production by 6.5% compared to solely using the C5/C6 yeast. In conclusion, the optimized yeast blend also lowered the amount of C5/C6 yeast required for inoculation by 80%.

09 BIOMASS FUELS↗

Ethanol Production from Corn Fiber Separated after Liquefaction in the Dry Grind Process

Conversion of corn fiber to ethanol in the dry grind process can increase ethanol yields, improve coproduct quality and contribute to process sustainability. This work investigates the use of two physio-chemical pretreatments on corn fiber and effect of cellulase enzyme dosage to improve ethanol yields. Fiber separated after liquefaction of corn was pretreated using (I) hot water pretreatment (160 °C for 5, 10 or 20 min) and (II) wet disk milling and converted to ethanol. The conversion efficiencies of hot water pretreated fiber were higher than untreated fiber, with highest increase in conversion (10.4%) achieved for 5 min residence time at 160 °C. Disk milling was not effective in increasing conversion compared to other treatments. Hydrolysis and fermentation of untreated fiber with excess cellulase enzymes resulted in 33.3% higher conversion compared to untreated fiber.

09 BIOMASS FUELS↗

Increasing ethanol yield through fiber conversion in corn dry grind process

Conversion of corn fiber to ethanol in the dry grind process could increase ethanol yields, reduce downstream processing costs and improve overall process profitability. In this work, we investigate the in-situ conversion of corn fiber into ethanol (cellulase addition during simultaneous saccharification and fermentation) during dry grind process. Addition of 30 FPU/g fiber cellulase resulted in 4.6% increase in ethanol yield compared to the conventional process. Use of excess cellulase (120 FPU/g fiber) resulted in incomplete fermentation and lower ethanol yield compared to the conventional process. Lastly, multiple factors including high concentrations of ethanol and phenolic compounds were responsible for yeast stress and incomplete fermentation in excess cellulase experiments.

09 BIOMASS FUELS↗

Cellulosic Ethanol Potential of Feedstocks Grown on Marginal Lands

To examine the chemical composition and ethanol production of feedstocks grown on marginal lands, prairie cordgrass and switchgrass from waterlogged land, saline land, and saline water irrigated land were evaluated. Samples were pretreated using 1% w w -1 dilute acid at 160°C for 10 min, and simultaneous saccharification and cofermentation was conducted using industrial engineered . Samples grown on land irrigated with saline water had 2.8-fold higher total ash content compared to the other types of land, resulting in lower carbohydrate concentrations. Yeast fermented glucose and xylose simultaneously; almost all of the sugars were consumed, indicating that salts present in biomass ash did not inhibit yeast performance. Ethanol production from the waterlogged and saline lands was 2,500 to 4,700 L ha -1 , which is comparable to that of samples grown on other agricultural lands. Finally, prairie cordgrass and switchgrass grown on marginal lands could be potential feedstocks for cellulosic biofuel. Keywords: Irrigation, Marginal land, Prairie cordgrass, Saline, Simultaneous saccharification and cofermentation, Switchgrass, Waterlogging.

54 ENVIRONMENTAL SCIENCES↗