Search NASASearch

Engineering topics

Redd, L. T.

Publications and source records attributed to Redd, L. T..

Evaluation of a wind-tunnel gust response technique including correlations with analytical and flight test results

A wind tunnel technique for obtaining gust frequency response functions for use in predicting the response of flexible aircraft to atmospheric turbulence is evaluated. The tunnel test results for a dynamically scaled cable supported aeroelastic model are compared with analytical and flight data. The wind tunnel technique, which employs oscillating vanes in the tunnel throat section to generate a sinusoidally varying flow field around the model, was evaluated by use of a 1/30 scale model of the B-52E airplane. Correlation between the wind tunnel results, flight test results, and analytical predictions for response in the short period and wing first elastic modes of motion are presented.

Redd, L. T.

A comparison of the results of dynamic wind-tunnel tests with theoretical predictions for an aeromechanical gust-alleviation system for light airplanes

Dynamic wind tunnel tests have been conducted on a 1/6-scale model of a general aviation airplane equipped with an all-mechanical gust alleviation system which uses auxiliary aerodynamic surfaces to drive the flaps. The longitudinal short period motions were studied under simulated gust conditions in order to verify the mathematical model used in a previous study to predict the performance of the full scale system and determine the amount of normal acceleration alleviation which could be attained. The model responses were measured for different configurations with the system active and without the system active for comparison. The tests confirmed the general relationships between the experimental variables and the model responses predicted by the mathematical model, but there were significant differences in the magnitudes of the responses. The experimental results for the model were used to estimate a reduction of 30 percent in the rms normal acceleration response of a similar full scale airplane in atmospheric turbulence.

Stewart, E. C.

A wind-tunnel investigation of a B-52 model flutter suppression system

Flutter modeling techniques have been successfully extended to the difficult case of the active suppression of flutter. The demonstration was conducted in a transonic dynamics tunnel using a 1/30 scale, elastic, dynamic model of a Boeing B-52 control configured vehicle. The results from the study show that with the flutter suppression system operating there is a substantial increase in the damping associated with the critical flutter mode. The results also show good correlation between the damping characteristics of the model and the aircraft.

Redd, L. T.

Stability analysis and trend study of a balloon tethered in a wind, with experimental comparisons

A stability analysis and trend study for a balloon tethered in a steady wind are presented. The linearized, stability-derivative type analysis includes balloon aerodynamics, buoyancy, mass (including apparent mass), and static forces resulting from the tether cable. The analysis has been applied to a balloon 7.64 m in length, and the results are compared with those from tow tests of this balloon. This comparison shows that the analysis gives reasonable predictions for the damping, frequencies, modes of motion, and stability boundaries exhibited by the balloon. A trend study for the 7.64-m balloon was made to illustrate how the stability boundaries are affected by changes in individual stability parameters. The trends indicated in this study may also be applicable to many other tethered-balloon systems.

Redd, L. T.

Experimental and analytical determination of stability parameters for a balloon tethered in a wind

Experimental and analytical techniques for determining stability parameters for a balloon tethered in a steady wind are described. These techniques are applied to a particular 7.64-meter-long balloon, and the results are presented. The stability parameters of interest appear as coefficients in linearized stability equations and are derived from the various forces and moments acting on the balloon. In several cases the results from the experimental and analytical techniques are compared and suggestions are given as to which techniques are the most practical means of determining values for the stability parameters.

Redd, L. T.

Computer Programs for Calculating and Plotting the Stability Characteristics of a Balloon Tethered in a Wind

Computer programs for calculating the stability characteristics of a balloon tethered in a steady wind are presented. Equilibrium conditions, characteristic roots, and modal ratios are calculated for a range of discrete values of velocity for a fixed tether-line length. Separate programs are used: (1) to calculate longitudinal stability characteristics, (2) to calculate lateral stability characteristics, (3) to plot the characteristic roots versus velocity, (4) to plot the characteristic roots in root-locus form, (5) to plot the longitudinal modes of motion, and (6) to plot the lateral modes for motion. The basic equations, program listings, and the input and output data for sample cases are presented, with a brief discussion of the overall operation and limitations. The programs are based on a linearized, stability-derivative type of analysis, including balloon aerodynamics, apparent mass, buoyancy effects, and static forces which result from the tether line.

Bennett, R. M.