Search NASA⌕ Search

Engineering topics

Reed, L. E.

Publications and source records attributed to Reed, L. E..

At least 19 records

Restriction of pursuit eye movement range during a concurrent auditory task

A two-part experiment was performed using 10 naive adult male subjects to determine the effects of a concurrent auditory dot/dash identification task on pursuit eye movements. Results indicated there was a significant (20 percent) but transitory task-induced restriction of the range of both an 18 deg horizontal and a 14 deg vertical pursuit eye movement visual angle. Furthermore, doubling the presentation rate of the concurrent task accounted for an additional 5 percent restriction of pursuit eye movement range. Results also indicated that the eye movement range is unaffected by both prior knowledge of the task and four consecutive practice trials. It is suggested that both the rapidity of target movement and the presence of concurrent mental tasks could significantly shrink an operator's pursuit eye movement ranges during viewing of dynamic visual displays such as airborne low-level television and forward-looking infrared.

Malmstrom, F. V.↗

Visual fatigue - The need for an integrated model

Two experiments were conducted to examine possible decrements in performance over time on two visual tracking tasks. In Experiment 1, six subjects tracked a horizontal, sinusoidally moving target in the picture plane for 6.5 min. In Experiment 2, six subjects tracked a target sinusoidally changing focus in the depth plane between 0 and 4 D over 6.5 min. Results indicated a linearly decreasing amplitude of both pursuit eye movements (.29 deg of visual angle per minute) and accommodation (.11 D/min). These visual fatigue effects are discussed in the context of several competing explanations.

Malmstrom, F. V.↗

Skylab/EREP application to ecological, geological, and oceanographic investigations of Delaware Bay

Skylab/EREP S190A and S190B film products were optically enhanced and visually interpreted to extract data suitable for; (1) mapping coastal land use; (2) inventorying wetlands vegetation; (3) monitoring tidal conditions; (4) observing suspended sediment patterns; (5) charting surface currents; (6) locating coastal fronts and water mass boundaries; (7) monitoring industrial and municipal waste dumps in the ocean; (8) determining the size and flow direction of river, bay and man-made discharge plumes; and (9) observing ship traffic. Film products were visually analyzed to identify and map ten land-use and vegetation categories at a scale of 1:125,000. Digital tapes from the multispectral scanner were used to prepare thematic maps of land use. Classification accuracies obtained by comparison of derived thematic maps of land-use with USGS-CARETS land-use maps in southern Delaware ranged from 44 percent to 100 percent.

Klemas, V.↗

Skylab/EREP application to ecological, geological, and oceanographic investigations of Delaware Bay

The author has identified the following significant results. Skylab/EREP S190A and S190B film products were optically enhanced and visually interpreted to extract data suitable for mapping coastal land use; inventorying wetlands vegetation; monitoring tidal conditions; observing suspended sediment patterns; charting surface currents; locating coastal fronts and water mass boundaries; monitoring industrial and municipal waste dumps in the ocean; and determining the size and flow direction of river, bay, and man-made discharge plumes. Film products were visually analyzed to identify and map ten land use and vegetation categories at a scale of 1:125,000. Thematic maps were compared with CARETS land use maps, resulting in classification accuracies of 50 to 98%. Digital tapes from S192 were used to prepare thematic land use maps. The resolutions of the S190A, S190B, and S192 systems were 20-40m, 10-20m, and 70-100m, respectively.

Klemas, V.↗

Coastal zone classification from satellite imagery

The author has identified the following significant results. Studies of cover distribution along Delaware's coast, especially in tidal wetlands, were made, utilizing semi-automated analysis of LANDSAT-1 MSS digital data. Cover maps with eleven vegetation and other cover categories were produced with accuracy of identification above 80% in all categories. Recent studies have tested a new technique for training automated analysis which uses ground measured reflectance and atmospheric correction techniques to derive signatures for specific categories in preference to the relative radiance signatures derived from training sets within LANDSAT data itself. Initial tests using a four category scheme indicate that training data based on absolute measured reflectance and atmospheric correction of LANDSAT data can produce comparable accuracy of categorization to that achieved using more conventional relative radiance training. The analysis of the same four categories produced average categorization accuracies of 82.1% by conventional reflative radiance training and 81.9% by use of absolute reflectance signatures.

Klemas, V.↗

Computer mapping of LANDSAT data for environmental applications

The author has identified the following significant results. Land cover overlays and maps produced from LANDSAT are providing information on existing land use and resources throughout the 208 study area. The overlays are being used to delineate drainage areas of a predominant land cover type. Information on cover type is also being combined with other pertinent data to develop estimates of sediment and nutrients flows from the drainage area. The LANDSAT inventory of present land cover together with population projects is providing a basis for developing maps of anticipated land use patterns required to evaluate impact on water quality which may result from these patterns. Overlays of forest types were useful for defining wildlife habitat and vegetational resources in the region. LANDSAT data and computer assisted interpretation was found to be a rapid cost effective procedure for inventorying land cover on a regional basis. The entire 208 inventory which include acquisition of ground truth, LANDSAT tapes, computer processing, and production of overlays and coded tapes was completed within a period of 2 months at a cost of about 0.6 cents per acre, a significant improvement in time and cost over conventional photointerpretation and mapping techniques.

Rogers, R. H.↗

Coastal Zone Classification from Satellite Imagery

The author has identified the following significant results. Studies of cover distribution along Delaware's coast, especially in tidal wetlands, were made utilizing semi-automated analysis of LANDSAT-1 MSS digital data. Cover maps with eleven vegetation and other cover categories were produced with accuracy of identification above 80% in all categories. Recent studies have tested a new technique for training automated analysis which uses ground measured reflectance and atmospheric correction techniques to derive signatures for specific categories in preference to the relative radiance signatures derived from training sets within the LANDSAT data itself. Initial tests using a four category scheme indicate that training data based on absolute measured reflectance and atmospheric correction of LANDSAT data can produce comparable accuracy of categorization to that achieved using more conventional relative radiance training.

Klemas, V.↗

Environmental monitoring from spacecraft data

The author has identified the following significant results. LANDSAT was used as a basis for inventorying land use within each of the Ohio-Kentucky-Indiana regional commissions, 225 drainage areas, and nine counties. Computer tabulations were produced to obtain the area covered by each of 16 land use categories within 225 drainage areas. The 16 categories were merged into ten categories and mapped at a scale of 1 inch = 5,000 ft, with detail to 0.44 hectares for the 2,700 sq mi region. These products were produced in less than 90 days, at a cost of $20,000.

Rogers, R. H.↗

Automatic categorization of land-water cover types of the Green Swamp, Florida, using Skylab multispectral scanner (S-192) data

The techniques used and the results achieved in the successful application of Skylab Multispectral Scanner (EREP S-192) high-density digital tape data for the automatic categorizing and mapping of land-water cover types in the Green Swamp of Florida were summarized. Data was provided from Skylab pass number 10 on 13 June 1973. Significant results achieved included the automatic mapping of a nine-category and a three-category land-water cover map of the Green Swamp. The land-water cover map was used to make interpretations of a hydrologic condition in the Green Swamp. This type of use marks a significant breakthrough in the processing and utilization of EREP S-192 data.

Coker, A. E.↗

Computer mapping of turbidity and circulation patterns in Saginaw Bay, Michigan from LANDSAT data

The author has identified the following significant results. LANDSAT was used as a basis for producing geometrically-corrected, color-coded imagery of turbidity and circulation patterns in Saginaw Bay, Michigan (Lake Huron). This imagery shows nine discrete categories of turbidity, as indicated by nine Secchi depths between 0.3 and 3.3 meters. The categorized imagery provided an economical basis for extrapolating water quality parameters from point samples to unsample areas. LANDSAT furnished a synoptic view of water mass boundaries that no amount of ground sampling or monitoring could provide.

Rogers, R. H.↗

Automatic mapping of strip mine operations from spacecraft data

The author has identified the following significant results. Computer techniques were applied to process ERTS tapes acquired over coal mining operations in southeastern Ohio on 21 August 1972 and 3 September 1973. ERTS products obtained included geometrically-correct map overlays, at scales from 1:24,000 to 1:250,000, showing stripped earth, partially reclaimed earth, water, and natural vegetation. Computer-generated tables listing the area covered by each land-water category in square kilometers were also produced. By comparing these mapping products, the study demonstrates the capability of ERTS to monitor changes in the extent of stripping and reclamation. NASA C-130 photography acquired on 7 September 1973 when compared with the ERTS products generated from the 3 September 1973 tape established the categorization accuracy to be better than 90%. It is estimated that the stripping and reclamation maps and data were produced from the ERTS CCTs at a tenth of the cost of conventional techniques.

Rogers, R. H.↗

Automatic classification of eutrophication of inland lakes from spacecraft data

The author has identified the following significant results. Spacecraft data and computer techniques can be used to rapidly map and store onto digital tapes watershed land use information. Software is now available by which this land use information can be rapidly and economically extracted from the tapes and related to coliform counts and other lake contaminants (e.g. phosphorus). These tools are basic elements for determining those land use factors and sources of nutrients that accelerate eutrophication in lakes and reservoirs.

Rogers, R. H.↗

Automated strip mine and reclamation mapping from ERTS

In response to the urgent need for a faster and more economical means of generating strip mine and reclamation maps, a study was conducted to evaluate the suitability of using ERTS computer compatible tape for automatic mapping. The procedure uses computer target spectral recognition techniques as a basis for classification. The area encompassed by this investigation includes five counties in eastern Ohio that comprise nearly 7,500 square kilometers (3,000 square miles). The counties have been disrupted by coal mining since the early 1800's, and strip mining has been practiced in all of them. The environmental effects of strip mining are also discussed.

Pettyjohn, W. A.↗

Automated strip-mine and reclamation mapping from ERTS

The author has identified the following significant results. Computer processing techniques were applied to ERTS-1 computer-compatible tape (CCT) data acquired in August 1972 on the Ohio Power Company's coal mining operation in Muskingum County, Ohio. Processing results succeeded in automatically classifying, with an accuracy greater than 90%: (1) stripped earth and major sources of erosion; (2) partially reclaimed areas and minor sources of erosion; (3) water with sedimentation; (4) water without sedimentation; and (5) vegetation. Computer-generated tables listing the area in acres and square kilometers were produced for each target category. Processing results also included geometrically corrected map overlays, one for each target category, drawn on a transparent material by a pen under computer control. Each target category is assigned a distinctive color on the overlay to facilitate interpretation. The overlays, drawn at a scale of 1:250,000 when placed over an AMS map of the same area, immediately provided map locations for each target. These mapping products were generated at a tenth of the cost of conventional mapping techniques.

Rogers, R. H.↗

ERTS-1: Automated land-use mapping in lake watersheds

The author has identified the following significant results. ERTS-1 computer compatible tapes were used as a basis to generate land use maps in lake watersheds in southeastern Michigan. These maps, generated on a repetitive basis, provide information essential to governmental agencies concerned with planning and control of lake eutrophication. The ERTS mapping products included geometrically current land use map overlays at 1:250,000 and 1:48,000 scale and area measurement printouts. The printouts provide, within the watershed boundaries and by land use category, a quantitative measure of the amount of land, in square kilometers and acres. This quantitative measure of land use in watersheds is essential to the development and application of deterministic models, which compute nutrient flows into lakes and establish lake eutrophication rates.

Chase, P. E.↗

Automated land-use mapping from spacecraft data

The author has identified the following significant results. In response to the need for a faster, more economical means of producing land use maps, this study evaluated the suitability of using ERTS-1 computer compatible tape (CCT) data as a basis for automatic mapping. Significant findings are: (1) automatic classification accuracy greater than 90% is achieved on categories of deep and shallow water, tended grass, rangeland, extractive (bare earth), urban, forest land, and nonforested wet lands; (2) computer-generated printouts by target class provide a quantitative measure of land use; and (3) the generation of map overlays showing land use from ERTS-1 CCTs offers a significant breakthrough in the rate at which land use maps are generated. Rather than uncorrected classified imagery or computer line printer outputs, the processing results in geometrically-corrected computer-driven pen drawing of land categories, drawn on a transparent material at a scale specified by the operator. These map overlays are economically produced and provide an efficient means of rapidly updating maps showing land use.

Chase, P. E.↗