Search NASA⌕ Search

Engineering topics

Reed, M.

Publications and source records attributed to Reed, M..

Demonstration of the HeRALD superfluid helium detector concept

The SPICE/HeRALD collaboration is performing research and development to enable studies of sub-GeV dark matter models using a variety of target materials. Here we report our recent progress on instrumenting a superfluid 4 He target mass with a transition-edge sensor based calorimeter to detect both atomic signals (scintillation) and 4 He quasiparticle (phonon and roton) excitations. The sensitivity of HeRALD to the critical “quantum evaporation” signal from 4 He quasiparticles requires us to block the superfluid film flow to the calorimeter. We have developed a heat-free film-blocking method employing an unoxidized Cs film, which we implemented in a prototype “HeRALD v0.1” detector of ~10 g target mass. This article reports initial studies of the atomic and quasiparticle signal channels. Here, a key result of this work is the measurement of the quantum evaporation channel’s gain of 0.15±0.01, which will enable 4 He-based dark matter experiments in the near term. With this gain the HeRALD detector reported here has an energy threshold of 145 eV at 5⁢σ, which would be sensitive to dark matter masses down to 220 MeV/c 2 .

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Calibration and Data Analysis Recommendations for Three-Component Moment Balances

Fundamental characteristics of design, calibration, and application of three-component moment balances are investigated in great detail. These balances are typically used to determine loads on control surfaces, canards, or other parts that are attached to a wind tunnel model. First, three different descriptions of the load state of a moment balance are reviewed. Then, load transformations between different load formats and the combined load diagram for two of the three load components are discussed. An error analysis showed that it is critical to maximize the product of the distance between the bending moment gages and their sensitivities in order to minimize the overall error in the normal force prediction. In addition, it is important to apply a sufficient number of calibration loadings near the first bending moment gage. Then, unwanted near-linear dependencies between the two bending moment gage outputs can be avoided. The error in the bending moment prediction is also investigated that results from the elastic deformation of the metric part of the balance under load. Finally, the application of the Non-Iterative Method to three-component moment balance calibration data is described in order to obtain regression models that can be used to predict loads from measured outputs during a wind tunnel test.

Strain-Gage Balance↗

Condensation phase of the Martian south polar cap

One type of database that can be useful in limiting models of the Mars surface-atmosphere system is the time dependent boundary of CO2 frost for the polar caps. Data acquired by the thermal infrared sensors on spacecraft are not limited by the lighting problems that hamper visual observations. The surface temperature of solid CO2 is limited by Clapeyron's equation as a function of the local partial pressure of CO2 gas. The growth was studied of the Martian south polar cap using the Viking IRTM dataset. These data are available in five bands, four of which should correspond to surface radiation in clear conditions; the 20 micron data was examined in the first phase.

Capuano, J.↗

The application of Seasat-1 radar altimetry to continental shelf circulation modeling

Seasat-1 radar altimetry data have been used to verify a continental shelf circulation model subjected to tidal forcing on the open boundary. The model makes use of the semi-implicit mode of time integration, removing the surface gravity wave time step restriction. Both the altimetry and the model predictions are compared with empirically determined tidal fluctuations and generally good agreement is obtained.

Cornillon, P.↗

A practical obstacle detection system for the Mars Rover

Discussion of an obstacle detection system which uses a laser range finder as the principal sensing device. The laser scans the scene ahead and stores the range data for the terrain in a matrix form. This matrix can be thought of as a 'range image'. This range varies from point to point, but sharp changes are caused by the presence of obstacles. Some existing algorithms and one developed by the authors were used to obtain the outlines of obstacles from the 'range image'. All these algorithms end with a thresholding operation. A theoretical analysis shows how a proper value of the threshold may be chosen, given the type of irregularity of the terrain to be detected. The analysis also shows how large the statistics of measurement noise can be allowed without leading to false alarms.

Reed, M.↗