Engineering topics

Reese, Matthew O

Publications and source records attributed to Reese, Matthew O.

3 records

DOE OSTI2020

Combinatorial Study of MZO Emitters for CdTe-Based Solar Cells

Precise band alignment at the front interface of CdTe-based solar cells is necessary to reduce photoexcited charge carrier recombination and to enable higher energy conversion efficiencies. Magnesium zinc oxide is not only transparent but also offers the ability to tune the conduction band offset with CdTe at the front of the device stack. In this work, we describe reactive sputtering of Mg 1-x Zn x O using metal targets and its application in CdTe photovoltaics. Combinatorial libraries of Mg 1-x Zn x O were created to tune the conduction band alignment for the optimal performance of CdTe solar cells. Band gap variation of more than 0.4 eV is achieved across a 3-inch substrate. Kelvin probe measurements demonstrate variance of work function across the substrate. Device performance is optimized at band gaps of 3.5 eV for the CdTe device processing conditions employed in this study.

14 SOLAR ENERGY↗

DOE OSTI2020

Doping of CdTe Using CuCl2 Solution for Highly Efficient Photovoltaic Devices

Here, we report doping of cadmium telluride (CdTe) thin film solar cells using copper (II) chloride (CuCl 2 ) solution in deionized water. The CdTe thin films were immersed in 0.1 mmol CuCl 2 solution in water and annealed in the temperature range of 180-240 degrees C for various time durations. The devices were completed using thermally evaporated gold (Au) and measured under simulated AM1.5G spectrum. The average device efficiency of CuCl 2 treated CdTe devices increased to 13.7 % (best cell reaching 14.0%) with significant improvement on open-circuit voltage (VOC ) as compared with 12.4% (best cell 12.7%) for thermally evaporated Cu doped CdTe devices. For CuCl 2 treated CdTe devices, we found higher photoluminescence (PL) intensity and longer carrier life time at room temperature indicating solution based doping offers better control of Cu doping density as compared with evaporated Cu.

14 SOLAR ENERGY↗

DOE OSTI2020

Oxidative Segregation of Group V Dopants in CdTe Solar Cells

Transparent conductive oxides are used in many technologies and it is important to understand their interfacial chemical reactions. Here, we use recently developed thermomechanical cleaving and X-ray photoelectron spectroscopy to probe oxidation states at the SnO 2 interface of CdTe solar cells. We show that tin oxide promotes the formation of nanometer-scale oxides of tellurium and sulfur, largely during CdCl 2 /O 2 activation. Surprisingly, in copper-doped devices, relatively low temperature anneals (180-260 degrees C) to diffuse and activate copper acceptors also cause significant oxidation changes at the front interface, providing a heretofore missing aspect of how back contact processes can modify device transport, recombination, and performance. For Group V-doped devices, this same oxidation process causes segregation of the dopants to the SnO 2 interface in their oxidized states, implying that adjacent regions in the absorber have been depleted of dopants. Intriguingly, we demonstrate that because of their layered, van der Walls-bonded crystal structure, spatially segregated Group V oxides may represent a mechanically weak layer in a finished device.

14 SOLAR ENERGY↗