Engineering topics

Reeves, R. D.

Publications and source records attributed to Reeves, R. D..

5 records

NASA NTRS1985

Testing Machine for Biaxial Loading

Standard tensile-testing machine applies bending and tension simultaneously. Biaxial-loading test machine created by adding two test fixtures to commercial tensile-testing machine. Bending moment applied by substrate-deformation fixture comprising yoke and anvil block. Pneumatic tension-load fixture pulls up on bracket attached to top surface of specimen. Tension and deflection measured with transducers. Modified test apparatus originally developed to load-test Space Shuttle surface-insulation tiles and particuarly important for composite structures.

Demonet, R. J.↗

NASA NTRS1982

Optical measurement of the velocity of dielectric surface arcs

Surface flashover arc discharge velocities on electron-beam-charged polymer sheets have been measured directly by detecting the light emitted at two points along a straight arc and measuring the time interval between light pulses. For Mylar, the average velocity is 1.2 x 10 to the 6th m/s, and for Teflon the average velocity is approximately 7.3 x 10 to the 5th m/s independent of sheet thickness. These velocities are about two to four times higher than previous measurements. The techniques employed to produce single, straight surface arcs are described.

Balmain, K. G.↗

NASA NTRS1982

Phenomenology of surface arcs on spacecraft dielectric materials

For electron beam incidence on large specimens of Kapton thermal blanket material, surface arc discharges are shown to cause damage consisting of punchthrough holes which act as focal points for other types of damage, including subsurface tunnels, blowout holes and surface breakup. Under electron bombardment, dielectric sheet specimens separated by a gap are shown to discharge simultaneously. Teflon specimens which have been brushed or rubbed are shown to exhibit directional guidance of discharge arcs, and this phenomenon has been used to generate straight arcs whose velocities have been measured optically.

Balmain, K. G.↗

NASA NTRS1981

Two-dimensional electron beam charging model for polymer films

A two-dimensional model is developed to describe the charging of strips of thin polymer films above a grounded substrate exposed to a uniform mono-energetic electron beam. The study is motivated by the observed anomalous behavior of geosynchronous satellites, which has been attributed to differential charging of the satellite surfaces exposed to magnetospheric electrons. Surface and bulk electric fields are calcuated at steady state in order to identify regions of high electrical stress, with emphasis on behavior near the material's edge. The model is used to study the effects of some of the experimental parameters, notably beam energy, beam angle of incidence, beam current density, material thickness and material width. Also examined are the consequences of a central gap in the material and a discontinuity in the material thickness.

Reeves, R. D.↗

NASA NTRS1981

Two-dimensiosnal electron beam charging model for polymer films

A two dimensional model was developed to describe the charging of thin polymer films exposed to a uniform mon-energetic electron beam. The study was motivated by observed anomalous behavior of geosynchronous satellites which was attributed to electrical discharges associated with the differential charging of satellite surfaces of magnetospheric electrons. Electric fields both internal and external to the irradiated specimen were calculated at steady state in order to identify regions of high electrical stress. Particular emphasis was placed on evaluating the charging characteristics near the material's edge. The model was used to identify and quantify the effects of some of the experimental parameters notably: beam energy; beam angle of incidence; beam current density; material thickness; and material width. Simulations of the following situations were also conducted: positive or negative precharging over part of the surface; a central gap in the material; and a discontinuity in the material's thickness.

Reeves, R. D.↗