Search NASA⌕ Search

Engineering topics

Reichhardt, Cynthia Jane

Publications and source records attributed to Reichhardt, Cynthia Jane.

14 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Analytical model for the motion and interaction of two-dimensional active nematic defects

Here, we develop an approximate, analytical model for the velocity of defects in active nematics by combining recent results for the velocity of topological defects in nematic liquid crystals with the flow field generated from individual defects in active nematics. Importantly, our model takes into account the long-range interactions between defects that result from the flows they produce as well as the orientational coupling between defects inherent in nematics. Our work complements previous studies of active nematic defect motion by introducing a linear approximation that allows us to treat defect interactions as two-body interactions and incorporates the hydrodynamic screening length as a tuning parameter. We show that the model can analytically predict bound states between two +1/2 winding number defects, effective attraction between two –1/2 defects, and the scaling of a critical unbinding length between ±1/2 defects with activity. The model also gives predictions for the trajectories of defects, such as the scattering of +1/2 defects by –1/2 defects at a critical impact parameter that depends on activity. In the presence of circular confinement, the model predicts a braiding motion for three +1/2 defects that was recently seen in experiments, as well as stable and ergodic trajectories for four or more defects.

36 MATERIALS SCIENCE↗
DOE OSTI2024

Active nematic ratchet in asymmetric obstacle arrays

We numerically investigate the effect of an asymmetric periodic obstacle array in a two-dimensional active nematic. We find that activity in conjunction with the asymmetry leads to a ratchet effect or unidirectional flow of the fluid along the asymmetry direction. The directional flow is still present even in the active turbulent phase when the gap between obstacles is sufficiently small. We demonstrate that the dynamics of the topological defects transition from flow mirroring to smectic-like as the gap between obstacles is made smaller, and explain this transition in terms of the pinning of negative winding number defects between obstacles. This also leads to a nonmonotonic ratchet effect magnitude as a function of obstacle size, so that there is an optimal obstacle size for ratcheting at fixed activity.

36 MATERIALS SCIENCE↗
DOE OSTI2024

Sliding Dynamics for Bubble Phases on Periodic Modulated Substrates

We analyze a bubble-forming system composed of particles with competing long-range repulsive and short range attractive interactions driven over a quasi-one-dimensional periodic substrate. We find various pinned and sliding phases as a function of substrate strength and drive amplitude. When the substrate is weak, a pinned bubble phase appears that depins elastically into a sliding bubble lattice. For stronger substrates, we find anisotropic bubbles, disordered bubbles, and stripe phases. Plastic depinning occurs via the hopping of individual particles from one bubble to the next in a pinned bubble lattice, and as the drive increases, there is a transition to a state where all of the bubbles are moving but are continuously shedding and absorbing individual particles. This is followed at high drives by a moving bubble lattice in which the particles can no longer escape their individual bubbles. The transition between the plastic and elastic sliding phases can be detected via signatures in the velocity-force curves, differential conductivity, and noise. When the bubbles shrink due to an increase in the attractive interaction term, they fit better inside the pinning troughs and become more strongly pinned, leading to a reentrant pinning phase. For weaker attractive terms, the size of the bubbles becomes greater than the width of the pinning troughs and the depinning becomes elastic with a reduced depinning threshold.

36 MATERIALS SCIENCE↗
DOE OSTI2024

Vortex Lattices in Active Nematics with Periodic Obstacle Arrays

Here, we numerically model a two-dimensional active nematic confined by a periodic array of fixed obstacles. Even in the passive nematic, the appearance of topological defects is unavoidable due to planar anchoring by the obstacle surfaces. We show that a vortex lattice state emerges as activity is increased, and that this lattice may be tuned from “ferromagnetic” to “antiferromagnetic” by varying the gap size between obstacles. We map the rich variety of states exhibited by the system as a function of distance between obstacles and activity, including a pinned defect state, motile defects, the vortex lattice, and active turbulence. We demonstrate that the flows in the active turbulent phase can be tuned by the presence of obstacles, and explore the effects of a frustrated lattice geometry on the vortex lattice phase.

36 MATERIALS SCIENCE↗
DOE OSTI2023

Friction-mediated phase transition in confined active nematics

Using a minimal continuum model, we investigate the interplay between circular confinement and substrate friction in active nematics. Upon increasing the friction from low to high, we observe a dynamical phase transition from a circulating flow phase to an anisotropic flow phase in which the flow tends to align perpendicular to the nematic director at the boundary. We demonstrate that both the flow structure and dynamic correlations in the latter phase differ from those of an unconfined, active turbulent system and may be controlled by the prescribed nematic boundary conditions. Here, our results show that substrate friction and geometric confinement act as valuable control parameters in active nematics.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗
DOE OSTI2021

Dynamics and nonmonotonic drag for individually driven skyrmions

Here, we examine the motion of an individual skyrmion driven through an assembly of other skyrmions in the absence of quenched disorder. The skyrmion behavior is determined by the ratio of the damping and Magnus terms, known as the intrinsic skyrmion Hall angle. For fixed drive in the damping dominated regime, the effective viscosity decreases monotonically with increasing skyrmion density. In contrast, in the Magnus dominated regime, the velocity varies nonmonotonically with density, and there is a regime in which the skyrmion moves faster with increasing density, as well as a pronounced speed-up effect in which a skyrmion traveling through a dense medium moves more rapidly than for low densities or the single-particle limit. The velocity-force curves in the Magnus-dominated regime exhibit an overshoot effect and other differences from the damping-dominated regime. We find a finite threshold force for skyrmion motion which increases with density as well as a drive-dependent skyrmion Hall angle. We map dynamic phase diagrams showing the threshold for motion, nonlinear flow, speed-up, and saturation regimes. In some cases, increasing the density can reduce the skyrmion Hall angle while producing a velocity boost, which could be valuable for applications.

36 MATERIALS SCIENCE↗
DOE OSTI2021

Clogging, dynamics, and reentrant fluid for active matter on periodic substrates

Here, we examine the collective states of run-and-tumble active matter disks driven over a periodic obstacle array. When the drive is applied along a symmetry direction of the array, we find a clog-free uniform liquid state for low activity, while at higher activity, the density becomes increasingly heterogeneous and an active clogged state emerges in which the mobility is strongly reduced. For driving along nonsymmetry or incommensurate directions, there are two different clogging behaviors consisting of a drive-dependent clogged state in the low activity thermal limit and a drive-independent clogged state at high activity. These regimes are separated by a uniform flowing liquid at intermediate activity. There is a critical activity level above which the thermal clogged state does not occur, as well as an optimal activity level that maximizes the disk mobility. Thermal clogged states are dependent on the driving direction while active clogged states are not. In the low activity regime, diluting the obstacles produces a monotonic increase in the mobility; however, for large activities, the mobility is more robust against obstacle dilution. We also examine the velocity-force curves for driving along nonsymmetry directions and find that they are linear when the activity is low or intermediate but become nonlinear at high activity and show behavior similar to that found for the plastic depinning of solids. At higher drives, the active clustering is lost. For low activity, we also find a reentrant fluid phase, where the system transitions from a high mobility fluid at low drives to a clogged state at higher drives and then back into another fluid phase at very high drives. We map the regions in which the thermally clogged, partially clogged, active uniform fluid, clustered fluid, active clogged, and directionally locked states occur as a function of disk density, drift force, and activity.

36 MATERIALS SCIENCE↗
DOE OSTI2021

Vortex Ordering and Dynamics of Santa Fe Artificial Ice Pinning Arrays

We numerically examine the ordering, pinning, and flow of superconducting vortices interacting with a Santa Fe artificial ice pinning array. We find that as a function of magnetic field and pinning density, a wide variety of vortex states occur, including ice rule obeying states and labyrinthine patterns. In contrast to square pinning arrays, we find no sharp peaks in the critical current due to the inherent frustration effect imposed by the Santa Fe ice geometry; however, there are some smoothed peaks when the number of vortices matches the number of pinning sites. For some fillings, the Santa Fe array exhibits stronger pinning than the square array due to the suppression of one-dimensional flow channels when the vortex motion in the Santa Fe lattice occurs through the formation of both longitudinal and transverse flow channels.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗
DOE OSTI2021

Structure and dynamical properties of two-dimensional dusty plasmas on one-dimensional periodic substrates

In the presence of the substrate, various structural and dynamical properties of two-dimensional dusty plasma (2DDP) were investigated using Langevin dynamical simulations. This paper reviews a series of results of the structural and dynamical properties of 2DDP modified by one-dimensional periodic substrates (1DPSs) as follows. First, when the depth of the 1DPS increases gradually, it is found that the static structural order of 2DDP along each potential well of the 1DPS increases first, and then decreases gradually. When the width of the 1DPS increases gradually, the particle arrangement in each potential well of the 1DPS changes from one straight row gradually to two rows, including the stable zigzag structure. Second, when there are two rows in each potential well of the 1DPS, the phonon spectra are split into two branches, corresponding to the breathing and sloshing modes, respectively. In addition, due to the pure repulsion between dust particles, from the obtained phonon spectra, the sloshing wave propagates backward at small wave numbers. Third, the calculated mean-square displacement (MSD) shown that, at the intermediate timescale between the initial ballistic and final diffusive motions, the particle motion tends to be more subdiffusive while the depth of the 1DPS increases. While the width of the 1DPS increases gradually, the long-time diffusive motion first increases, then decreases, and finally increases again, exhibiting the oscillation-like diffusion, due to the stable zigzag structure. Finally, when an external direct-current driving force is applied on all particles of 2DDP, three different depinning phases are discovered, which are the pinned, disordered plastic flow, and moving ordered states, respectively, as the driving force increases from zero. In addition, the continuous/discontinuous property of the phase transition between these different depinning states is investigated, showing that the transition property is modulated by the depth of the applied 1DPS

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2021

Active matter commensuration and frustration effects on periodic substrates

In this report we show that self-driven particles coupled to a periodic obstacle array exhibit active matter commensuration effects that are absent in the Brownian limit. As the obstacle size is varied for sufficiently large activity, a series of commensuration effects appear in which the motility induced phase separation produces commensurate crystalline states, while for other obstacle sizes we find frustrated or amorphous states. The commensuration effects are associated with peaks in the amount of sixfold ordering and the maximum cluster size. When a drift force is added to the system, the mobility contains peaks and dips similar to those found in transport studies for commensuration effects in superconducting vortices and colloidal particles.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗
DOE OSTI2020

Continuous and discontinuous transitions in the depinning of two-dimensional dusty plasmas on a one-dimensional periodic substrate

We report Langevin dynamical simulations are performed to study the depinning dynamics of two-dimensional dusty plasmas on a one-dimensional periodic substrate. From the diagnostics of the sixfold coordinated particles P 6 and the collective drift velocity V x , three different states appear, which are the pinning, disordered plastic flow, and moving ordered states. It is found that the depth of the substrate is able to modulate the properties of the depinning phase transition, based on the results of P 6 and V x , as well as the observation of hysteresis of V x while increasing and decreasing the driving force monotonically. When the depth of the substrate is shallow, there are two continuous phase transitions. When the potential well depth slightly increases, the phase transition from the pinned to the disordered plastic flow states is continuous; however, the phase transition from the disordered plastic flow to the moving ordered states is discontinuous. When the substrate is even deeper, the phase transition from the pinned to the disordered plastic flow states changes to discontinuous. When the depth of the substrate further increases, as the driving force increases, the pinned state changes to the moving ordered state directly, so that the disordered plastic flow state disappears completely.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗