Engineering topics

Reilly, H. F.

Publications and source records attributed to Reilly, H. F..

5 records

NASA NTRS1993

Performance of the X-/Ka/KABLE-band dichroic plate in the DSS-13 beam waveguide antenna

The first Ka-band downlink demonstration was recently carried out by the Ka-Band Link Experiment (KABLE) in association with the Mars Observer spacecraft. In order to support the mission, a dichroic plate was required in the DSS-13 beam waveguide antenna to allow simultaneous X- and Ka-band operation. An X-/ Ka-/ KABLE-band dichroic plate was designed to transmit Ka-band downlink (31.8-32.3 GHz), Ka-band uplink (34.2-34.7 GHz), and KABLE (33.6-33.8 GHz) frequencies, while reflecting X-band (8.4-8.5 GHz). A computer program was developed for the analysis of a dichroic plate with rectangular apertures by using the mode-matching method. The plate was then fabricated and tested. The reflection, group delay, and noise temperature in the antenna system due to the dichroic plate were measured. The experimental results show good agreement with theoretical prediction.

Chen, J. C.↗

NASA NTRS1993

HRMS sky survey wideband feed system design for DSS 24 beam waveguide antenna

The High-Resolution Microwave Survey (HRMS) Sky Survey project will be implemented on the DSS 24 beam waveguide (BWG) antenna over the frequency range of 2.86 to 10 GHz. Two wideband, ring-loaded, corrugated feed horns were designed to cover this range. The horns match the frequency-dependent gain requirements for the DSS 24 BWG system. The performance of the feed horns and the calculated system performance of DSS 24 are presented.

Stanton, P. H.↗

NASA NTRS1986

A prototype DSN X/S-band feed: Model 3 development

The development of a prototype X/S-band common aperture Cassegrain feedhorn for Deep Space Network (DSN) use is discussed. A Model 3 combiner has been developed to increase S-band bandwidth to include the Highly Elliptical Earth Orbiter band from 2025 to 2110 MHz, and to provide a 400-kW CW S-band uplink and a possible planetary radar band near 2320 MHz. The combiner uses eight S-band waveguide injection slots arranged in four pairs. The problems of this design geometry associated with rejection filtering and X/S-band matching are discussed.

Bathker, D. A.↗

NASA NTRS1985

Efficient Reflector Antenna

Efficient antenna applicable to systems where main reflector diameter is at least 500 wavelengths. Design provides 2-to-3-dB improvement in gain divided by noise temperature (G/T) over centerline symmetric designs. Performance improvement largely due to clear-aperture, off-axis dual-reflector design.

Bathker, D. A.↗

NASA NTRS1977

Electro-optically-indexed microwave switch

Mechanical parts used in conventional switches to index stepper motor that drives switch elements are replaced by optoelectronic indexing device that controls magnetic-detent motor. Unit eliminates major source of wear and maintains detent accuracy longer. Design of device achieves reduction of insertion loss, crosstalk, and wave guide reflections when receiving and transmitting.

Neff, D. E.↗