Search NASASearch

Engineering topics

Rendell, Alistair P.

Publications and source records attributed to Rendell, Alistair P..

Investigation of a Diagnostic for Perturbation Theory: Comparison to the T(sub 1) Diagnostic of Coupled-Cluster Theory

A diagnostic for perturbation theory calculations, S(sub 2), is defined and numerical results are compared to the established T(sub 1) diagnostic from coupled-cluster theory. S(sub 2) is the lowest order non-zero contribution to a perturbation expansion of T(sub 1). S(sub 2) is a reasonable estimate of the importance of non-dynamical electron correlation, although not as reliable as T(sub 1). S(sub 2) values less than or equal to 0.012 suggest that low orders of perturbation theory should yield reasonable results; S(sub 2) values between 0.012-0.015 suggest that caution is required in interpreting results from low orders of perturbation theory; S(sub 2) values greater than or equal to 0.015 indicate that low orders of perturbation theory are not reliable for accurate results. Although not required mathematically, S(sub 2) is always less than T(sub 1) for the examples studied here.

Lee, Timothy J.

Coupled-Cluster Theory Employing Approximate Integrals: An Approach to Avoid the Input/Output and Storage Bottlenecks

By representing orbital products in an expansion basis, certain classes of two-electron integrals are approximated for use in CCSD(T) calculations (singles and doubles coupled-cluster plus a perturbational estimate of the effects of connected triple excitations). This leads to a very large reduction in disk storage and input/output requirements, with usually only a modest increase in computational effort. The new procedure will allow very large CCSD(T) calculations to be undertaken, limited only by available processor time. Using the molecular basis as the expansion basis, explicit numerical comparisons of equilibrium geometries, harmonic frequencies, and energy differences indicate that the error due to the use of approximate integrals is less than the error associated with truncation of the molecular basis set.

Rendell, Alistair P.

Ab initio characterization of ClOOH - Implications for atmospheric chemistry

The equilibrium structure, dipole moment, harmonic vibrational frequencies, and infrared intensities of ClOOH are determined using the CCSD(T) (singles and doubles coupled-cluster theory plus a perturbational estimate of the effects of connected triple excitations) electronic structure method in conjunction with a TZ2P (triple xi plus double polarization) basis set. The heat of formation of CIOOH is determined (using two different isodesmic reactions) to be +1.5 +/- 1 kcal/mol at 0 K or +0.2 +/- 1 kcal/mol at 298.15 K. Using the computed heat of formation, we examined the stability of ClOOH with respect to the ClO + OH, ClOO + H, and HOO + Cl dissociation limits. Since ClOOH is found to be quite stable, it is argued that the chemistry of ClOOH should be included in any accurate modeling of the stratosphere.

Lee, Timothy J.

The structures, binding energies and vibrational frequencies of Ca3 and Ca4: An application of the CCSD(T) method

The Ca3 and Ca4 metallic clusters have been investigated using state-of-the-art ab initio quantum mechanical methods. Large atomic natural orbital basis sets have been used in conjunction with the singles and doubles coupled-cluster (CCSD) method, a coupled-cluster method that includes a perturbational estimate of connected triple excitations, denoted CCSD(T), and the multireference configuration interaction (MRCI) method. The equilibrium geometries, binding energies and harmonic vibrational frequencies have been determined with each of the methods so that the accuracy of the coupled-cluster methods may be assessed. Since the CCSD(T) method reproduces the MRCI results very well, cubic and quartic force fields of Ca3 and Ca4 have been determined using this approach and used to evaluate the fundamental vibrational frequencies. The infrared intensities of both the e' mode of Ca3 and the t2 mode of Ca4 are found to be small. The results obtained in this study are compared and contrasted with those from our earlier studies on small Be and Mg clusters.

Lee, Timothy J.

An efficient formulation and implementation of the analytic energy gradient method to the single and double excitation coupled-cluster wave function - Application to Cl2O2

The analytic energy gradient for the single and double excitation coupled-cluster (CCSD) wave function has been reformulated and implemented in a new set of programs. The reformulated set of gradient equations have a smaller computational cost than any previously published. The iterative solution of the linear equations and the construction of the effective density matrices are fully vectorized, being based on matrix multiplications. The new method has been used to investigate the Cl2O2 molecule, which has recently been postulated as an important intermediate in the destruction of ozone in the stratosphere. In addition to reporting computational timings, the CCSD equilibrium geometries, harmonic vibrational frequencies, infrared intensities, and relative energetics of three isomers of Cl2O2 are presented.

Rendell, Alistair P.

Analytic gradients for coupled-cluster energies that include noniterative connected triple excitations - Application to cis- and trans-HONO

An efficient formulation of the analytic energy gradient for the single and double excitation coupled-cluster method that includes a perturbational estimate of the effects of connected triple excitations is presented. The formulation has a small computational cost, and the algebraic manipulations may be applied generally to the analytic gradient of Moller-Plesset perturbation theory energies. The new formulation has been implemented in an efficient set of programs that utilize highly vectorized algorithms and has been used to investigate the equilibrium structures, harmonic vibrational frequencies, IR intensities, and energy separation of cis- and trans-HONO.

Lee, Timothy J.

A parallel vectorized implementation of triple excitations in CCSD(T) - Application to the binding energies of the AlH3, AlH2F, AlHF2 and AlF3 dimers

An efficient method for various noniterative estimates of connected triple excitations in coupled-cluster theory is outlined and related to a similar expression occurring in Moller-Plesset perturbation theory. The method is highly vectorized and capable of utilizing multiple processors on a shared-memory machine, leading to computational rates in excess of one billion floating-point operations per second on four processors of a CRAY Y-MP. Using the new procedure, the binding energies of the D(2h) diborane-type dimers of AlH3, AlH2F, AlHF2, and AlF3 have been determined to be 32, 40, 20, and 47 kcal/mol, respectively. For Al2F6, the correlation procedure includes 232 molecular orbitals and over 1.5 x 10 to the 6th single and double coupled-cluster amplitudes, effectively accounting for over 2 x 10 to the 9th connected triple excitations.

Rendell, Alistair P.

The structure and energetics of the HCN-HNC transition state

The optimum geometries and quadratic force constants of HCN, HNC and the transition state connecting them have been determined at the single- and double-excitation coupled-cluster (CCSD) and CCSD(T) levels of theory. Energy differences were evaluated using the CCSD and CCSD(T) methods in conjunction with large atomic natural orbital basis sets containing g-type basis functions on the heavy atoms and f-type functions on hydrogen. The most reliable structure obtained for the transition state has bond distances of 1.194, 1.188, and 1.389 A for r(CN), r(CH), and r(NH), respectively. Including a correction for zero-point vibrational energies, the transition state is predicted to be 44.6 + or - 1.0 kcal/mol above the HCN isomer, while HNC is predicted to be 14.4 + or - 1.0 kcal/mol above HCN. The latter value is in excellent agreement with the most recent experimental determination (14.8 + or - 2.0 kcal/mol).

Lee, Timothy J.

Triple and quadruple excitation contributions to the binding in Be clusters: Calibration calculations on Be3

The contribution of connected triple and quadruple excitations to the binding in Be3 is investigated by comparing various coupled-cluster (CC) and truncated configuration interaction (CI) treatments with multireference CI (MRCI) and full CI(FCI) calculations. The CC method with single and double excitations (CCSD) produces results that differ substantially from more elaborate treatments, but most extensions to CCSD that account approximately for connected triple excitations perform very well. In constrast, good agreement with FCI for Be2 can be achieved only with the highest level CC and MRCI methods.

Watts, John D.

Triple and quadruple excitation contributions to the binding in Be clusters - Calibration calculations on Be3

The contribution of connected triple and quadruple excitations to the binding in Be3 is investigated by comparing various coupled-cluster (CC) and truncated configuration-interaction (CI) treatments with multireference CI (MRCI) and full CI (FCI) calculations. The CC method with single and double excitations (CCSD) produces results that differ substantially from more elaborate treatments, but most extensions to CCSD that account approximately for connected triple excitations perform very well. In contrast, good agreement with CFI for Be2 can be achieved only with the highest level CC and MRCI methods.

Watts, John D.

Vibrations in small Mg clusters

The equilibrium geometries, binding energies, and harmonic frequencies of Mg3 and Mg4 have been determined using large atomic natural orbital basis sets in conjunction with high levels of electron correlation. The correlation treatments comprise multireference configuration interaction (MRCI), singles and doubles coupled-cluster (CCSD) theory and the CCSD(T) extension that includes a perturbational estimate of connected triple excitations. As with previous studies of small Be clusters, the CCSD(T) method is found to reproduce the MRCI results with a remarkable degree of accuracy and at a fraction of the computational cost. Using the CCSD(T) method, full quartic force fields for Mg3 and Mg4 have been determined and anharmonic analyses have been performed using second-order perturbation theory. Vibration-rotation interaction constants and centrifugal distortion constants have also been determined.

Lee, Timothy J.

Vibrational frequencies for Be3 and Be4

The harmonic frequencies of Be3 and Be4, evaluated by multireference configuration-interaction (MRCI) and singles and doubles coupled-cluster (CCSD) methods, are reported, as are IR intensities evaluated by using the double harmonic approximation. A comparison of the results shows that the CCSD method augmented with a correction for connected triple excitations, CCSD(T), can be a viable alternative to MRCI for determining the ground-state properties of small Be clusters (other than the dimer). Results of normal mode analyses indicate that the anharmonic vibrational frequencies of Be3 and Be4 are reasonably consistent at the CCSD, CCSD(T), or MRCI levels of treatment.

Rendell, Alistair P.

Theoretical investigations of the structures and binding energies of Be(n) and Mg(n) (n = 3-5) clusters

The equilibrium geometries and binding energies of Be and Mg trimers, tetramers and pentamers have been determined using single and double excitation coupled cluster (CCSD) and complete active space self-consistent-field (CASSCF) multireference configuration interaction (MRCI) wave functions in conjunction with extended atomic basis sets. The best estimates of the cluster binding energies are 24, 83, and 110 kcal/mol for Be3, Be4, and Be5; and 9, 31, and 41 kcal/mol for Mg3, Mg4, and Mg5, respectively. A comparison of the MRCI and CCSD results shows that even the best single-reference approach (limited to single and double excitations) is not capable of quantitative accuracy in determining the binding energies of Be and Mg clusters.

Lee, Timothy J.

Comparison of the quadratic configuration interaction and coupled cluster approaches to electron correlation including the effect of triple excitations

The recently proposed quadratic configuration interaction (QCI) method is compared with the more rigorous coupled cluster (CC) approach for a variety of chemical systems. Some of these systems are well represented by a single-determinant reference function and others are not. The finite order singles and doubles correlation energy, the perturbational triples correlation energy, and a recently devised diagnostic for estimating the importance of multireference effects are considered. The spectroscopic constants of CuH, the equilibrium structure of cis-(NO)2 and the binding energies of Be3, Be4, Mg3, and Mg4 were calculated using both approaches. The diagnostic for estimating multireference character clearly demonstrates that the QCI method becomes less satisfactory than the CC approach as non-dynamical correlation becomes more important, in agreement with a perturbational analysis of the two methods and the numerical estimates of the triple excitation energies they yield. The results for CuH show that the differences between the two methods become more apparent as the chemical systems under investigation becomes more multireference in nature and the QCI results consequently become less reliable. Nonetheless, when the system of interest is dominated by a single reference determinant both QCI and CC give very similar results.

Taylor, Peter R.

Theoretical investigations of the structures and binding energies of Be(sub n) and Mg(sub n) (n = 3-5) clusters

Researchers determined the equilibrium geometries and binding energies of Be and Mg trimers, tetramers and pentamers using single and double excitation coupled cluster (CCSD) and complete active space self-consistent-field (CASSCF) multireference configuration interaction (MRCI) wave functions in conjunction with extended atomic basis sets. Best estimates of the cluster binding energies are 24, 83 and 110 kcal/mole for Be3, Be4 and Be5; and 9, 31 and 41 kcal/mole for Mg3, Mg4 and Mg5, respectively. A comparison of the MRCI and CCSD results shows that even the best single-reference approach (limited to single and double excitations) is not capable of quantitative accuracy in determining the binding energies of Be and Mg clusters.

Lee, Timothy J.