Search NASA⌕ Search

Engineering topics

Renner, O

Publications and source records attributed to Renner, O.

Laser-produced aluminum plasma expansion inside a plastic plasma envelope

Previous experimental results demonstrated that the plasma pressure decreases with the growing atomic number of the target material. In this context, a question arose if the Al plasma outflow could be collimated using the plastic plasma as a compressor. To solve this problem, an experiment using a plastic target with an Al cylindrical insert was performed. The focal spot diameter substantially larger than that of the insert ensured simultaneous heating both target materials. This experiment proved that a production of Al plasma jets collimated by an action of outer plastic plasma is feasible [Kasperczuk et al., Laser Part. Beams 30, 1 (2012)]. The results of investigations presented here provide additional information on distributions of electron temperature in the outflowing plasma and time and space characteristics of ion emission, both registered at bare and constrained-flow Al targets. The experiment was carried out at the Prague asterix laser system iodine laser facility. The laser provided a 250 ps (full width at half maximum) pulse with the energy of 130 J at the third harmonic frequency ({lambda}{sub 3} = 0.438 {mu}m). A plastic target with an Al cylindrical insert of 400 {mu}m in diameter as well as a bare Al target (for comparison) was used. The focal spot diameter ({Phi}{sub L}) 1200 {mu}m ensured the lateral pressure effect of the plastic plasma strong enough to guarantee the effective Al plasma compression. The electron temperature measurements have shown that such Al plasma compression is accompanied by the increase of its temperature, dominance of which starts at distance of 0.5 mm from the target surface. Measurements of ion emission characteristics confirm the earlier numerical simulation prediction that in these conditions the plasma expansion geometry is closer to planar. The constrained Al plasma jet is very narrow and its axial velocity is considerably larger than the velocity of freely expanding Al plasma stream. It means that the plastic plasma envelope, besides the Al plasma compression, also strongly accelerates the Al plasma in its axial motion.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Plasma-wall interaction studies with optimized laser-produced jets

The production of the laser-produced plasma jets at burnt-through low-Z foils was optimized by using three-frame interferometry. When striking secondary targets, these jets of energetic particles represent an efficient tool for the investigation of transient phenomena at surfaces of the plasma-exposed solids. Two sets of precisely measured x-ray spectroscopic data demonstrate diagnostic potential of the collimated jets in the plasma-wall interaction studies: Blue Doppler shifts of the Al jet self-emission visualize ion deceleration in the near-wall region. Local depressions found in Al Ly{gamma} profiles emitted from Al/Si(PMMA) targets indicate charge exchange between the Al XIII and fully stripped C ions.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Stark Profiles In Plasmas Interacting With A Strong Oscillatory Quasi-Monochromatic Electric Field

This paper presents an advanced analysis of the spectroscopic signatures of the interaction of a strong oscillating Quasi-monochromatic Electric Field (QEF), generated by a high-power short-pulse laser, with a preformed laser-produced plasma. The computation of a synthetic spectrum emitted by such plasmas requires the calculation of the Stark line shape in the presence of a QEF and the evaluation of the QEF intensity profile throughout the line of sight in the plasma. As for the Stark profiles in hot dense plasmas submitted to a strong QEF, they are calculated using the so-called Floquet-Liouville formalism. In this formalism, the Liouville space, usually used for the calculation of Stark profiles in dense plasmas, and the Floquet theory, developed to solve time-periodic problems, have been joined together to solve the time-dependent Liouville equation. A second kind of simulations involving Particle-In-Cell PIC kinetic simulations is required for the calculation of the QEF inhomogeneous intensity and the exotic features exhibited in the spectroscopic diagnostic. The global synthetic profile is obtained integrating all individual contributions for every time and location in the plasma. Finally, a spectroscopic analysis of the experimental Al He {beta} line is performed using the tools presented in this work. The spectroscopic signatures of the QEF show up as prominent satellites, non symmetrical with respect to the unperturbed line and distinguishable from the di-electronic satellites.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗