Search NASA⌕ Search

Engineering topics

Rex K Kincaid

Publications and source records attributed to Rex K Kincaid.

TPSAS-NF1676L-12321-DND

The operation of some networks, such as air transportation networks, can be complicated by congestion through a small subset of nodes. The congestion may be influenced by the connectivity of the network, or by the presence of constraints restricting the flow through particular nodes. This work investigates the effects of both connectivity and node flow constraints on the operation of a network. We develop the Minimax Node Load Problem (MNLP), a multicommodity flow model which minimizes the worst-case flow through any node in a given input network. The optimal solution to this problem provides us with the minimax node load, which we propose as a measure of network congestion. Keeping the number of nodes fixed, we first increase connectivity in a series of networks, and observe that topologies with more distributed connections result in a reduction in the minimax node load. However, when connectivity is increased further, the reductions diminish and are accompanied by solutions with undesirable qualities such as longer commodity paths. We then perform a second set of experiments over the same network, constraining flow through different subsets of nodes at different magnitudes of flow restriction, finding that (1) more constrained nodes lead to the largest increases in minimax node load and (2) constraints on the most connected nodes have the greatest effect on both congestion and commodity path length.

Douglas W Lee↗

Optical Sensor/Actuator Locations for Active Structural Acoustic Control

Researchers at NASA Langley Research Center have extensive experience using active structural acoustic control (ASAC) for aircraft interior noise reduction. One aspect of ASAC involves the selection of optimum locations for microphone sensors and force actuators. This paper explains the importance of sensor/actuator selection, reviews optimization techniques, and summarizes experimental and numerical results. Three combinatorial optimization problems are described. Two involve the determination of the number and position of piezoelectric actuators, and the other involves the determination of the number and location of the sensors. For each case, a solution method is suggested, and typical results are examined. The first case, a simplified problem with simulated data, is used to illustrate the method. The second and third cases are more representative of the potential of the method and use measured data. The three case studies and laboratory test results establish the usefulness of the numerical methods.

Piezoelectric actuators↗