Search NASA⌕ Search

Engineering topics

Richards, Jason M.

Publications and source records attributed to Richards, Jason M..

7 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Studies of Helium Behavior in Uranium Hexafluoride

Several issues have arisen from experimental observations and/or theoretical postulation related to the behavior of helium in uranium hexafluoride (UF 6 ) matrices and how it may impact the ability to use this noble gas to quantify the fill date of the cylinder. A series of experiments was conducted to address several such issues, and the results and implications are reported here. Two issues relate to bias in the helium measurement due to ambient air from extraneous sources such as atmospheric air or from potential holdup in a large, activated alumina chemical trap. These issues are really a question of differential retention of helium versus three other inert gas isotopes (representative of other noble gases found in air) used as a calibration for air in leakage. Discernable bias was not detected in either case. Another issue had to do with helium potentially brought into the cylinder by a liquid UF 6 fill and subsequently released as the material solidifies and/or during storage. The solubility of helium in liquid UF 6 was measured to investigate this theory. The experiment quantified the potential magnitude of the initial helium contribution if present. The final issue was that of retention of helium in solid UF 6 . Investigation of this theory necessitated quantifying both the solubility and the diffusivity of helium in UF 6 . In one experiment, the solubility was measured at cryogenic temperature, allowing quantification of helium in solid UF 6 such as would be found in a cold trap. In a second experiment, transport of helium into and through a macroscopic plug of solid UF 6 was examined. The transport was very slight although apparently detectible. Effectively, only an upper limit to the transport could be determined, but that limit implied that helium holdup in solid UF 6 is a real possibility.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2021

Thermal impacts on nondestructive analysis measurements of uranium hexafluoride

A series of nondestructive assay measurements were performed before, during, and after localized heating of an industrial standard 12B cylinder of uranium hexafluoride to replicate dose variations previously observed on commercial 30B cylinders. While cylinders represent a closed system, enrichment measurements may be impacted by altered uranium and daughter product distributions due to sublimation. A series of measurements were performed to examine localized heating impacts on dose rates, ratios of uranium and daughter product distributions, and measured 235 U enrichment as calculated by two different approaches. The less complex enrichment meter approaches were found to be more robust and less prone to deviation than isotope ratio approaches such as FRAM, but the impact can be minimized by using observable dose changes to avoid impacted areas.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗
DOE OSTI2021

UO 2 F 2 particulate formation in an impinging jet gas reactor

Computational fluid dynamics (CFD), chemical kinetics, and aerosol dynamics were combined to model the formation of uranyl fluoride particles from the hydrolysis of uranium hexafluoride gas. This chemical process has been studied for many decades, however, detailed measurements of aerosol formation have only become available in the past few years which provide a basis for model comparison. Here, CFD simulations predicted complicated flow patterns in the impinging jet gas reactor. Aerosol formation simulations also predicted higher mass concentrations than were observed experimentally. This suggested that experimental data provided a partial representation which was subsequently enhanced by modeling and simulation.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2021

Formation of Aerosol Nanoparticles by Gas-Phase Hydrolysis Reaction of Uranium Hexafluoride

The aerosol physics of uranyl particle formation has been addressed in this research using advanced aerosol instrumentation and an aerosol dynamics model. Based on the research works, we conclude that the formation and growth of aerosol particles by gas-phase UF6 hydrolysis strongly depends on the availability of water molecules in our reactor conditions. The total number concentration of the UO 2 F 2 particulate material that could be produced in the hydrolysis reaction is also regulated primarily by the availability of water molecule concentration. The higher the water molecule concentration, the higher the number and the larger the size of UO 2 F 2 aerosol particles that could be produced in a reactor custom-built at ORNL. Although the aerosol reactor was enabling the study of particle formation kinetics, the instrumentation was still insufficient in characterizing the chemical composition of the produced particles as well as the time-dependent evolution of the particulate species. The temporal evolution could impact the eventual fate of the particles upon release to the environment (i.e., the physio-chemical transformation, transport, and removal). On uranyl particle formation kinetics, we found that the growth rates of aerosol particles appeared to approach a single number in the range of 0.05 ± 0.03 - 0.08 ± 0.04 nm/s, statistically, as the ω value becomes smaller than 1. The size of primary particles from the UF6 hydrolysis at water-deprived condition was estimated to be 3.6 ± 0.4 nm; the higher the availability of water molecules, the larger the primary particles. The ability to precisely control the availability of water molecules in the reaction could lead to the production of nearly monodispersed aerosol particles. In other words, the result suggests that one can precisely manipulate the size of UO 2 F 2 aerosol particles by controlling the water vapor availability and interaction of water molecules with U F6 in the reaction. This finding has significant implications in the engineering manufacturing of fuel powder materials and possibly to future development and deployment of an environmental sampling apparatus.

74 ATOMIC AND MOLECULAR PHYSICS↗
DOE OSTI2020

Experimental and computational study of particle formation kinetics in UF6 hydrolysis

The formation and growth of UO 2 F 2 particles by gas-phase UF 6 hydrolysis remains of interest to actinide chemistry researchers. The total number concentration of the UO 2 F 2 aerosol particles that can be produced in the reaction is regulated primarily by the availability of water molecules under our reactor conditions. An increase in water molecule concentration corresponds with a higher amount and larger size of UO 2 F 2 aerosol particles produced. The growth rates of aerosol particles appear to approach a single number in the range of [0.05 ± 0.03–0.08 ± 0.04] (nm s -1 ), as the molar ratio of water to UF 6 decreases below 1. The size of primary particles produced from the UF 6 hydrolysis under water-deprived conditions was estimated to be 3.6 ± 0.4 nm. As the molar ratio became greater than 1.7, the size of primary particles increased with increased availability of water molecules. The primary particle model developed in this work predicted a size range for the UO 2 F 2 primary particles similar to that estimated based on the data from gas-phase UF 6 hydrolysis experiments. This result suggests that the volume-driven coalescence process assumption used in the derivation of the primary particle model was reasonable. The ability to precisely control the availability of water molecules and reaction time could lead to the production of nearly monodispersed aerosol particles. This finding has significant implications in the engineering and manufacturing of fuel powder materials and possibly the future development and deployment of environmental sampling apparatus.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗