Search NASA⌕ Search

Engineering topics

Richardson, Thomas J

Publications and source records attributed to Richardson, Thomas J.

Visualization of Charge Distribution in a Lithium Battery Electrode

We describe a method for direct determination and visualization of the distribution of charge in a composite electrode. Using synchrotron X-ray microdiffraction, state-of-charge profiles in-plane and normal to the current collector were measured. In electrodes charged at high rate, the signatures of nonuniform current distribution were evident. The portion of a prismatic cell electrode closest to the current collector tab had the highest state of charge due to electronic resistance in the composite electrode and supporting foil. In a coin cell electrode, the active material at the electrode surface was more fully charged than that close to the current collector because the limiting factor in this case is ion conduction in the electrolyte contained within the porous electrode.

25 ENERGY STORAGE↗

Overcharge Protection for 4 V Lithium Batteries at High Rates and Low Temperature

Overcharge protection for 4 V Li{sub 1.05}Mn{sub 1.95}O{sub 4}/lithium cells at charging rates in excess of 1 mA/cm{sup 2} (3C) and at temperatures as low as -20 C was achieved using a bilayer separator coated with two electroactive polymers. High rate and low temperature overcharge protection and discharge performance were improved by employing a design in which the polymer-coated portion of the separator is in parallel with the cell rather than between the electrodes. The effects of different membrane supports for the electroactive polymers are also examined.

25 ENERGY STORAGE↗

Continuity and Performance in Composite Electrodes

It is shown that the rate performance of a lithium battery composite electrode may be compromised by poor internal connectivity due to defects and inhomogeneities introduced during electrode fabrication or subsequent handling. Application of a thin conductive coating to the top surface of the electrode or to the separator surface in contact with the electrode improves the performance by providing alternative current paths to partially isolated particles of electroactive material. Mechanistic implications are discussed and strategies for improvement in electrode design and fabrication are presented.

25 ENERGY STORAGE↗