Engineering topics
Publications and source records attributed to Ricker, George.
A viewgraph presentation on the development of silicon detectors for high energy astrophysics missions is presented. The topics include: 1) Background: Motivation for Event-Driven CCD; 2) Report of Grant Activity; 3) Packaged EDCCD; 4) Measured X-ray Energy Resolution of the Gen1 EDCCDs Operated in "Conventional Mode"; and 5) EDCCD Gen 1.5-Lot 1 Planning.
We report preliminary results of Advanced Satellite for Cosmology and Astrophysics (ASCA) observations of two high-redshift quasars (zeta approximately 3) PKS 0438-436 and PKS 2126-158. We find spectral flattening towards low energies in both sources, first found with Roentgen Satellite (ROSAT) and interpreted as being due to excess X-ray absorption. However, the ROSAT data lacked the bandpass and sensitivity to unambiguously support this interpretation. We find that for PKS 2126-158, absorption in intervening low-redshift material along the line-of-sight provides a statistically better description of the data than absorption in material intrinsic to the quasar. The redshift of the putative absorber is required to be less than a few tenths. Given the redshift constraints and the fact that absorption is not common in lower redshift quasars, this result is not easily explained by a simple model. Either the absorber may be complex or else the intrinsic X-ray spectrum may be complex, or both. Compton-reflection dominated models are ruled out but a broken power-law model provides good fits to the data without requiring excess absorption. The break energy is at approximately 6-8 keV in the quasar frame and the energy index of the soft component is required to be extremely flat. This may mean that the X-ray emission in these objects is dominated by synchrotron losses as in BL Lac objects.
We report preliminary results of an Advanced Satellite for Cosmology and Astrophysics (ASCA) observation of 3C 273. There is no spectral variability within the ASCA observation, in contrast to the longer term behavior found with European X-ray Observatory Satellite (EXOSAT) and Ginga which established significant changes in the spectral index of the power-law continuum on timescales of a week or more, uncorrelated with luminosity. Comparison of the ASCA data with a simultaneous Roentgen Satellite (ROSAT) Ginga observation in 1990 December shows that while the shape of the spectrum above approximately 1 keV is essentially the same, the flux in the soft component, below approximately 1 keV, considerably weaker relative to the hard component in the ASCA observation. The 2-10 keV luminosity is at least a factor of approximately 1.5 greater in the ASCA observation than in the ROSAT/Ginga observation while the ratio of 2-10 keV luminosity to 0.4-1.0 keV luminosity increases by a factor of approximately 1.2. Thus the spectral shape of the hard component appears to be independent of the relative magnitude of the soft component and is an important constraint on emission and reprocessing models. We find no significant Fe K line-emission in this observation. The data also highlight very well some of the outstanding problems in the instrumental responses.
We report the first X-ray observations of the Seyfert 1 galaxy MCG-6-30-15 obtained at medium spectral resolution. The partially-ionized, 'warm' absorber is resolved and shown to be due to O VII and O VIII. The main absorption edge agrees with that of O VII at the redshift of the galaxy to within 1%. The column density of the absorbing material is greater by a factor of 2 in the first of our two obsevations, which were 3 weeks apart, while the mean flux is slightly lower and the ionization parameter slightly higher. We also discuss the flourescent iron emssion line seen in the source, which is at 6.40 keV. The line is significantly broadened, with a Full Width at Half Maximum (FWHM) of about 0.4 keV.
We have used the CCD X-ray spectrometers on ASCA and resolved the X-ray emission line from the jet of SS 433 both into Doppler-shifted components with two distinct velocities, and into emission from different ionization states of iron, i.e., Fe XXV and Fe XXVI. This is the first direct detection of the two Doppler shifted beams in the X-ray spectra of SS 433 and allows the radial velocity of the jet along the line of sight to be determined with an accuracy comparable to the optical spectroscopy. We also found pairs of emission lines from other atomic species, such as ionized silicon and sulfur, with the Doppler shifts consistent with each other. This confirms the origin of the X-ray emission in the high temperature plasma in the jets.
Since the inception of the ETC program, a wide range of new technologies was developed to support this astronomical instrument. The prototype unit was installed at ETC Site 1. The first partially automated observations were made and some major renovations were later added to the ETC hardware. The ETC was outfitted with new thermoelectrically-cooled CCD cameras and a sophisticated vacuum manifold, which, together, made the ETC a much more reliable unit than the prototype. The ETC instrumentation and building were placed under full computer control, allowing the ETC to operate as an automated, autonomous instrument with virtually no human intervention necessary. The first fully-automated operation of the ETC was performed, during which the ETC monitored the error region of the repeating soft gamma-ray burster SGR 1806-21.
The search for the optimum CCD to be used at the focal surface of the Advanced X-ray Astrophysics Facility (AXAF) is described. The physics of the interaction of X-rays in silicon through the photoelectric effect is reviewed. CCD technology at the beginning of the AXAF definition phase is summarized, and the results of the CCD enhancement program are discussed. Other sources of optimum CCDs are examined, and CCD enhancements made at MIT Lincoln Laboratory are addressed.