Search NASA⌕ Search

Engineering topics

Riddle, D. W.

Publications and source records attributed to Riddle, D. W..

Performance studies on the application of four-engine and two-engine USB propulsive lift to the E-2C aircraft

A study has been completed of the performance benefits to be derived from applying advanced upper-surface blowing (USB) propulsive-lift technology to the E-2C aircraft. The results of comparing four-engine with two-engine USB configurations are discussed, and engine sizing and aerodynamic/structural considerations pertaining to the E-2C/USB modification are examined. The effects of the modification on performance are described in detail with regard to takeoff distance and landing distance estimation in free-deck operations, operations using catapult and arresting gear, ceiling and radar surveillance missions, and range and endurance capability.

Riddle, D. W.↗

Applications of advanced upper surface blowing propulsive-lift technology

The success of the Quiet Short-Haul Research Aircraft led to studies of this technology for a business jet and a Short-Haul Transport. The studies showed that the Short-Haul Transport could operate from a 762.0-m runway with 95 passengers at low noise levels. Design range was 500 n. mi. but with maximum fuel load the runway length is only increased to 883.9 m while the range is increased to more than 1000 n. mi. Two business jet designs were studied; one design was based on a 457.2-m field length and the other was designed for a 760.0-m field length. The business jet designed for a 457.2-m field length can also be loaded to maximum fuel capacity. In this case the range increases from 500 n. mi. to 1400 n. mi. while the runway length increases from 457.2 m to 632.5 m. The business jet studies showed that the application of advanced propulsive-lift technology to this class aircraft can result in payload-range-speed performance comparable to current aircraft with about one-half the runway length requirement.

Cochrane, J. A.↗

Quiet Short-Haul Research Aircraft - The first 3 years of flight research

NASAs first three years of flight research in an investigation of terminal area flight operation with the Quiet Short-Haul Research Aircraft (QSRA) are presented. An initial flight and modification program was devoted to improving the capabilities of the QSRA and measuring its performance. Later programs included a joint program with the US Navy, a guest pilot program involving 23 pilots from 16 organizations, and a program to measure benefits of propulsive-lift to CTOL aircraft. Development flight research, complemented by the aircraft modification program, has resulted in improvements in the maximum lift coefficient of more than two units, and has greatly improved flight characteristics and handling qualities.

Cochrane, J. A.↗

Powered-lift takeoff performance characteristics determined from flight test of the Quiet Short-haul Research Aircraft /QSRA/

A powered-lift, reduced thrust takeoff performance program utilizing quiet short-haul research aircraft has been conducted. It has been shown that the powered-lift upper surface blowing concept greatly enhances aircraft takeoff performance. The improvements include: (1) takeoff field lengths may be shortened by approximately 30%; (2) Air Force critical field lengths may be shortened by approximately 60%; (3) powered lift upper surface blowing aircraft have better handling and performance characteristics than comparable conventional aircraft; and (4) the low speeds associated with powered-lift takeoff enhance safety margins.

Riddle, D. W.↗

Powered-lift STOL aircraft shipboard operations - A comparison of simulation, land-based and sea trial results for the QSRA

A moving base carrier landing flight simulation using NASA's Quiet Short-Haul Research Aircraft (QSRA) was conducted during the design and fabrication of the QSRA. After completing its initial flight testing, the QSRA flew simulated carrier landings on land, followed by actual carrier landings at sea. This paper compares the simulated flight characteristics used in the flight simulation (using an aircraft math model based on wind tunnel data) with the aircraft flight characteristics obtained from flight test data. This paper also compares the results of the QSRA flight simulation carrier landings, the land based simulated carrier landings, and the actual carrier landings.

Stevens, V. C.↗

Measurements of surface-pressure and wake-flow fluctuations in the flow field of a whitcomb supercritical airfoil

Measurements of surface pressure and wake flow fluctuations were made as part of a transonic wind tunnel investigation into the nature of a supercritical airfoil flow field. Emphasis was on a range of high subsonic Mach numbers and moderate lift coefficients corresponding to the development of drag divergence and buffeting. Fluctuation data were analyzed statistically for intensity, frequency content, and spatial coherence. Variations in these parameters were correlated with changes in the mean airfoil flow field.

Roos, F. W.↗

Separated-flow unsteady pressures and forces on elastically responding structures

Broadband rms, spectral density, and spatial correlation information that characterizes the fluctuating pressures and forces that cause aircraft buffet is presented. The main theme is to show the effects of elasticity. In order to do so, data are presented that were obtained in regions of separated flow on wings of wind-tunnel models of varying stiffness and on the wing of a full-scale aircraft. Reynolds number effects on the pressure fluctuations are also discussed.

Coke, C. F.↗

Separated-flow unsteady pressures and forces on elastically responding structures

Broadband rms, spectral density, and spatial correlation information that characterizes the fluctuating pressures and forces that cause aircraft buffet is presented. The main theme of the paper in describing buffet excitation is to show the effects of elasticity. Data are presented that were obtained in regions of separated flow on wings of wind-tunnel models of varying stiffness and on the wing of a full scale aircraft. Reynolds number effects on the pressure fluctuations are also discussed.

Coe, C. F.↗

Development and evaluation of a new method for predicting aircraft buffet response

The buffet prediction method uses rigid wind tunnel model fluctuating pressure data to form a buffet forcing function. The response is then calculated with a mathematical dynamic model of the airplane developed for gust response analysis. By including the extremes of phasing and contribution of symmetric and antisymmetric airplane responses, the upper and lower bounds are established for buffet response. F-111A flight test data show good agreement with predicted bounds for a variety of flight conditions.

Cunningham, A. M., Jr.↗

Wind-tunnel investigation of surface-pressure fluctuations associated with aircraft buffet

Fluctuating pressures and forces that cause aircraft buffeting have been measured on a semispan rigid-wing model of a typical variable-sweep fighter-type aircraft at transonic speeds. The rms spectral and spatial correlation characteristics of wing fluctuating pressures, fluctuating pressure summations, and structural responses are presented and discussed for a Mach number of 0.85, wing sweep angles of 26 and 72 deg, and angles of attack up to 12 deg. The fluctuating pressure characteristics beneath wing shock waves and leading-edge vortices and in regions of attached and separated flows are presented. Results indicate that: (1) the mean and fluctuating static pressure characteristics are related; (2) a circulation oscillation exists for attached flow conditions below buffet onset; and (3) a significant coupling exists between the wing shock-wave oscillation and the wing first torsional mode when shock-induced separation is present.

Riddle, D. W.↗