Search NASA⌕ Search

Engineering topics

Ries, J.

Publications and source records attributed to Ries, J..

The proposed international DORIS service

The goal of this paper is to discuss the status of the DORIS Pilot experiment, to analyze the progress made during the past two years and to propose the official creation within the IAG of an International DORIS Service (IDS).

DORIS IDS International DORIS Service IGGOS↗

Orbit determination requirements for TOPEX

The error sensitivity of orbit calculations in support of the NASA Ocean Surface Topography Mapping Experiment (TOPEX), which require an accuracy on the order of 5 cm, is investigated. The contributions of errors in the gravitational, atmospheric drag and solar radiation pressure models to the computed orbit are analyzed for the cases of an ideal data distribution and realistic laser ranging data coverage. It is found that the major contributor to radial orbital error is the error in the geopotential model, accounting for orbital errors of 30 to 70 cm, with the effects of solar radiation pressure, drag modeling, tracking station coordinate errors making lesser contributions. It is concluded that TOPEX accuracy goals cannot be met using ground-based laser ranging data without improving the geopotential model.

Tapley, B. D.↗

Polar motion results from GEOS 3 laser ranging

The observability of polar motion from laser range data has been investigated, and the contributions from the dynamical and kinematical effects have been evaluated. Using 2-day arcs with GEOS 3 laser data, simultaneous solutions for pole position components and orbit elements have been obtained for a 2-week interval spanning August 27 to September 10, 1975, using three NASA Goddard Space Flight Center stations located at Washington, D.C., Bermuda, and Grand Turk. The results for the y-component of pole position from this limited data set differenced with the BIH linearly interpolated values yield a mean of 39 cm and a standard deviation of 1.07 m. Consideration of the variance associated with each estimate yields a mean of 20 cm and a standard deviation of 81 cm. The results for the x-component of pole position indicate that the mean value is in fair agreement with the BIH; however, the x-coordinate determination is weaker than the y-coordinate determination due to the distribution of laser sites (all three are between 77 deg W and 65 deg W) which results in greater sensitivity to the data distribution. In addition, the sensitivity of these results to various model parameters is discussed.

Schutz, B. E.↗

Polar motion from laser range measurements of GEOS-3

Using two-day arcs of GEOS-3 laser data, simultaneous solutions for pole position components, x sub p and y sub p, and orbit elements have been obtained for the period spanning 3 February to 6 March 1976 using three NASA Goddard Space Flight Center laser stations located near Washington, D.C. (STALAS) and on the islands of Bermuda and Grand Turk. The results are in general agreement with the BIH results. However, because of the locations of the laser sites, the x sub p solution is weaker than the y sub p solution. The x sub p and y sub p estimates were smoothed with a straight line by weighted least squares using the variance associated with the pole estimates as weights in order to reflect the effect of widely different data distributions. The smoothed y sub p differs by one meter with respect to the BIH smoothed values and the smoothed x sub p differs by about two meters. Spectral analysis of the results has identified frequencies associated with the orbital motion indicating the need for further improvements in the model of the physical system.

Schutz, B. E.↗