Engineering topics
Publications and source records attributed to Righi, Gaia.
Here we describe the details of a digital holographic microscopy diagnostic capable of quantifying both the topography and velocity of a km/s object with adjustable temporal sensitivity. This technique involves spatially multiplexing a double pulse reflected from a target with reference beams of precisely known temporal separation.
The extreme response of polycrystalline iron at high pressures and high strain rates is revealed by means of high-power laser pulses. The compression portion of the pulse coupled with x-ray diffraction identifies the expected body-centered cubic (α) to hexagonal close packed (ε) displacive transformation. Upon release, observation shows that the complete reverse transformation takes approximately 8 ns and that the structure returns to its initial microstructural configuration, in a reversible transformation path. This is in good agreement with molecular dynamics (MD) simulations which predict an inverse dependence between transformation time and strain rate. The grain size is reduced from μm to nm range during compression and begins increasing back to the original grain size on decompression. The kinetics of the transition is dictated by heterogenous nucleation as it follows the Johnson-Mehl-Avrami-Kolmogorov equation with the appropriate time exponent of ~1. This is confirmed by MD simulations which also identify profuse twinning and dislocation generation. Here, the tensile pulse generated upon reflection at the free surface is captured by time-resolved free surface velocity measurements from which a peak tensile stress of 7 GPa is obtained, in stark contrast with its quasi-static value of ~200 MPa. At these strain rates, the strength of grain interiors, which is determined by twinning and slip exceeds the strength of the boundaries, and failure initiates preferentially in the latter.
Iron is an important metal, scientifically and technologically. It is a common metal on Earth, forming the main constituent of the planet's inner core, where it is believed to be in solid state at high pressure and high temperature. It is also the main component of many important structural materials used in quasistatic and dynamic conditions. Laser-driven Rayleigh–Taylor instability provides a means of probing material strength at high pressure and high temperature. The unavoidable phase transition in iron at relatively low pressure induces microstructural changes that ultimately affect its strength in this extreme regime. This inevitable progression can make it difficult to design experiments and understand their results. Here, we address this challenge with the introduction of a new approach: a direct-drive design for Rayleigh–Taylor strength experiments capable of reaching up to 400 GPa over a broad range of temperatures. We use 1D and 2D hydrodynamic simulations to optimize target components and laser pulse shape to induce the phase transition and compress the iron to high pressure and high temperature. At the simulated pressure–temperature state of 350 GPa and 4000 K, we predict a ripple growth factor of 3–10 depending on the strength with minimal sensitivity to the equation of state model used. The growth factor is the primary observable, and the measured value will be compared to simulations to enable the extraction of the strength under these conditions. These experiments conducted at high-energy laser facilities will provide a unique way to study an important metal.