Engineering topics

Rizzi, P.

Publications and source records attributed to Rizzi, P..

3 records

NASA NTRS1976

Optimization of multi-constrained structures based on optimality criteria

A weight-reduction algorithm is developed for the optimal design of structures subject to several multibehavioral inequality constraints. The structural weight is considered to depend linearly on the design variables. The algorithm incorporates a simple recursion formula derived from the Kuhn-Tucker necessary conditions for optimality, associated with a procedure to delete nonactive constraints based on the Gauss-Seidel iterative method for linear systems. A number of example problems is studied, including typical truss structures and simplified wings subject to static loads and with constraints imposed on stresses and displacements. For one of the latter structures, constraints on the fundamental natural frequency and flutter speed are also imposed. The results obtained show that the method is fast, efficient, and general when compared to other competing techniques. Extensions to the generality of the method to include equality constraints and nonlinear merit functions is discussed.

Rizzi, P.↗

NASA NTRS1976

Optimization of continuous one-dimensional structures under steady harmonic excitation

The paper examines some questions relating to the optimal design of continuous one-dimensional structures driven by harmonically oscillating loads. Optimal-control methods are applied to a cantilever bar driven sinusoidally by an axial force at its tip to illustrate the minimum-weight design of one-dimensional structures under dynamic excitation. Realistic constraints are imposed during the optimizations, including a maximum allowable stress amplitude at any point along the bar and a minimum cross-sectional area. It is shown that in the absence of damping, the design space may contain many disjoint feasible regions, and multiple optima can exist. Detailed solutions are obtained for continuous bars with an excitation frequency less than, and then greater than, the fundamental free-vibration frequency. It is found that above a certain excitation frequency, two or more arcs with different constraints characterize the optimal designs. It is concluded that when more than two different constrained arcs characterize the optimal solution, the continuum approach may be impractical, and finite-element approximations may offer the only alternative.

Johnson, E. H.↗

NASA NTRS1975

Properties of axial or torsional free-vibration frequency of rods

The investigation reported shows that for a clamped rod with an odd number of degrees of freedom, the middle frequency is independent of any nonuniformity in the area distribution. The frequencies in the lower half of the spectrum of a rod are found to be conjugate to the frequencies in the upper half. In the case of a design modification which leaves a certain frequency in the lower half spectrum unchanged, the conjugate frequency in the upper half will also remain unchanged.

Segenreich, S. A.↗