Search NASA⌕ Search

Engineering topics

Roides, R G

Publications and source records attributed to Roides, R G.

Near-Diffraction-Limited Operation of Step-Index Large-Mode-Area Fiber Lasers Via Gain Filtering

We present, for the first time to our knowledge, an explicit experimental comparison of beam quality in conventional and confined-gain multimode fiber lasers. In the conventional fiber laser, beam quality degrades with increasing output power. In the confined-gain fiber laser, the beam quality is good and does not degrade with output power. Gain filtering of higher-order modes in 28 μm diameter core fiber lasers is demonstrated with a beam quality of M^2 = 1.3 at all pumping levels. Theoretical modeling is shown to agree well with experimentally observed trends.

Marciante, J R↗

An Optical Replicator for Single-Shot Measurements at 10 GHz With a Dynamic Range of 1800:1

High-dynamic-range, single-shot pulse shapes were measured by temporally stacking pulses in a passive, fiber-optic network. The 256 replicas were combined to produce optical shapes with a bandwidth of 10 GHz and a dynamic range of 1800:1. The high fidelity of this system enabled the characterization of arbitrary electrical pulses that were used to shape the optical pulse via an electro-optic modulator with a reduced dynamic range of about 60:1.

electro-optic effects, microwave measurements, opt↗

Cryogenic Target-Implosion Experiments on OMEGA

The University of Rochester’s Laboratory for Laser Energetics has been imploding thick cryogenic targets for six years. Improvements in the Cryogenic Target Handling System and the ability to accurately design laser pulse shapes that properly time shocks and minimize electron preheat, produced high fuel areal densities in deuterium cryogenic targets (202+/-7 mg/cm^2). The areal density was inferred from the energy loss of secondary protons in the fuel (D2) shell. Targets were driven on a low final adiabat (alpha = 2) employing techniques to radially grade the adiabat (the highest adiabat at the ablation surface). The ice layer meets the target-design toughness specification for DT ice of 1-um rms (all modes), while D2 ice layers average 3.0-um-rms roughness. The implosion experiments and the improvements in the quality and understanding of cryogenic targets are presented.

Harding, D R↗