Search NASA⌕ Search

Engineering topics

Rolls, L Stewart

Publications and source records attributed to Rolls, L Stewart.

15 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1954

An evaluation of two cooling-air ejectors in flight at transonic speeds

Flight tests conducted on the YF-93 airplane afforded an opportunity to evaluate two cooling-air ejectors of widely different geometry. One ejector had a diameter ratio (fuselage-exit diameter divided by tail-pipe diameter) of 1.58 and a spacing ratio (distance from tail-pipe exit to fuselage exit divided by tail-pipe diameter) of 0.73 while the other ejector had a diameter ratio of 1.33 and a spacing ratio of 0.30. The larger tail exhibited poor net thrust performance due to excessive quantity of secondary air flow. The second engine-ejector combination had superior characteristics; however, an undesirable characteristic existed in that a region of reversed flow was present in the exit. This reversed flow caused a decrease in the performance of the ejector. Correlation of the flight data with cold-jet-model ejector data has demonstrated to what extent the model tests can be used as a design tool. When comparing the ejector with reversed flow with the model tests, it was necessary to consider the effect the reversed flow had on reducing the effective diameter ratio. Airplane drag measurements as determined for the widely different configurations indicated a good over-all precision for the method used in this investigation.

Rolls, L Stewart↗
NASA NTRS1949

Investigation of a Thin Straight Wing of Aspect Ratio 4 by the NACA Wing-flow Method : Lift and Pitching-moment Characteristics of the Wing Alone

This report presents measurements of the lift and pitching-moment characteristics of a straight wing of aspect ratio 4, taper ratio 0.5, having a symmetrical double-wedge airfoil section with a maximum thickness of 4.4-percent chord. The tests were conducted in the Mach number range 0.51 to 1.20, Reynolds numbers 380,000 to 660,000, by the NACA wing-flow method. The results are compared with theory and with wind-tunnel tests of a similar model. It is indicated that in the Mach number range 0.82 to 1.00 the model surface, profile, and test Reynolds number all would be very important considerations in any attempt to study or predict full-scale characteristics from small-model tests.

MACH NUMBER EFFECTS - COMPLETE WINGS↗
NASA NTRS1946

Measurements in Flight of the Pressure Distribution on the Right Wing of a Pursuit-Type Airplane at Several Values of Mach Number

Pressure-distribution measurements were made on the right wing of a pursuit-type airplane at values of Mach number up to 0.80. The results showed that a considerable portion of the lift was carried by components of the airplane other than the wings, and that the proportion of lift carried by the wings may vary considerably with Mach number, thus changing the bending moment at the wing root whether or not there is a shift in the lateral position of the center of pressure. It was also shown that the center of pressure does not necessarily move outward at high Mach numbers, even though the wing-thickness ratio decreases toward the wing tip. The wing pitching-moment coefficient increased sharply in a negative direction at a Mach lift-curve slope increased with Mach number up to values of above the critical value. Pressures inside the wing were small and negative.

Clousing, Lawrence A↗