Search NASA⌕ Search

Engineering topics

Romanov, Gennady

Publications and source records attributed to Romanov, Gennady.

15 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Strategies for mitigating residual magnetic field effect on pre-production PIP-II SSR2 cryomodule performance

This paper outlines the strategy aimed at mitigating the adverse effects of residual magnetic fields on the performance of pre-production SSR2 superconducting cavities within the context of the PIP-II project at Fermilab. Residual magnetic fields can significantly impact cavity performance, leading to reduced quality factor. To address this challenge, our strategy integrates various approaches including magnetic shielding, careful selection of materials, quality controls aimed at measuring magnetic permeability, magnetic hygiene to reduce residual magnetic field at the installation phase. Additionally, experimental studies are being planned to analyze the behavior of the cavities under different magnetic field conditions, and the effectiveness of advanced demagnetization procedures.

43 PARTICLE ACCELERATORS↗
DOE OSTI2024

Simulations of field emitters and multipacting in PIP-II Single Spoke Resonator Type-2

It has been found in benchmark tests that some Single Spoke Resonator Type-2 (SSR2) cavities have early field emission onset as well as strong multipacting barriers. A longstanding hypothesis is that field-emitted electrons in the high electric field accelerating gap can migrate and ignite multipacting bands in the low electric field regions of the cavity periphery. In this study, we use simulation techniques to examine multipacting behavior in SSR2 cavities from electrons seeded in common field emitter locations. Additionally, we investigated seed locations for areas in SSR2 cavities which may have poor coverage during high pressure water rinsing and compared the multipacting behavior.

43 PARTICLE ACCELERATORS↗
DOE OSTI2024

Logistic function as a characteristic of multipactor development

Simulations of multipacting with or without space charge effect bring out a different behavior of particle number growth, namely, the exponential growth of particle number in the simulations without space charge effect and the saturation of particle number (or collision and emission currents) when space charge is considered. That creates a certain confusion in evaluation and comparison of overall danger of multipactor between the approaches. On the other hand, both growth rate and total multipactor current loading at saturation are important for multipactor barriers evaluation. It was noticed and then verified that the logistic function, widely used in chemistry, biology, and ecosystem study, reproduces the particle number growth curves remarkably well. The function contains the parameters, which can be interpreted as particle number growth rate and multipactor current saturation level, so both become correlated and obtained simultaneously in one run. In this work it is shown how the logistic function can be used for characterization of the multipactor barriers and how it can be used for possible reduction of simulation time in the simulations with space charge effect.

Romanov, Gennady↗
DOE OSTI2024

Results from extended range SRF cavity tuner tests for LCLS-II-HE

The LCLS-II HE superconducting linac can produce multi-energy beams by supporting multiple undulator lines simultaneously. This could be achieved by using the cavity SRF tuner in the off-frequency detune mode. This off-frequency operation method was tested in 8 cryomodules at Fermilab at 2 K. In all the tests the tuners successfully achieved a frequency shift of -565±80 kHz from the 1.3 GHz value. This study discusses the cavity frequency during each stage of assembly from the cryomodule string to when they are finally tested at 2 K. Monitoring the cavity frequency from this initial stage contributed in reaching this large frequency shift. The specific procedures of tuner setting during assembly will be presented.

43 PARTICLE ACCELERATORS↗
DOE OSTI2024

Analysis of multipacting threshold sensitivity to the random distributions of the secondary electron yield parameters

The way multipacting develops, depends strongly on the secondary emission property of the surface material. The knowledge of secondary electron yield is crucial for accurate prediction of the multipacting threshold. Variations in secondary electron yield parameters from experimental measurements create uncertainty, stemming from handling and surface preparation, and these uncertainties significantly affect multipacting threshold predictions. Despite their significance, the previous studies on the multipacting phenomenon did not adequately address the effect of an assumed random distribution of the secondary emission parameters on the multipacting threshold. Therefore, this paper aims to provide a comprehensive statistical study on how the different random distributions of the secondary emission parameters and, as a result, the uncertainty in the secondary electron yield affect multipacting thresholds. We focus on three commonly used distributions, namely uniform, normal, and truncated normal distributions, to define the uncertainty of random inputs. We use the chaos polynomial expansion method to determine how much each of the random parameters contributes to the multipacting threshold uncertainty. Additionally, we calculate Sobol sensitivity indices to evaluate the impact of the individual parameters or groups of parameters on the model outputs and study how different random distributions of these parameters affected the Sobol index results.

physics↗
DOE OSTI2023

The Evaluation of Mechanical Properties of LB650 Cavities

The 650 MHz cavities have a stronger requirement of niobium mechanical properties because of the geometric shape of the cavity due to reduced beta. The mechanical property of the niobium half-cell was measured following various heat treatments. The 5-cell cavities were tested in a controlled drop test fashion and the real-world road test. The result showed that the 900C heat treatment was compatible with cavity handling and transportation during production. The test provides the bases of the transportation specification and shipping container design guidelines.

43 PARTICLE ACCELERATORS↗
DOE OSTI2023

Resonant dynamics of one-side multipactor on dielectric

Breakdown of dielectric radio frequency (RF) windows is an important issue for particle accelerators and high-power RF sources. One of the common reasons for RF window failure is the multipactor on a dielectric surface. The multipactor may be responsible for excessive heating of the dielectric and discharge of charges that accumulated in the ceramic due to secondary emission. In this study, comprehensive self-consistent particle-in-cell simulations with space charge effect were performed. This was to better understand the dynamic of one-side multipactor development and floating potential on the dielectric induced by the emission. The important correlations between the multipactor parameters at saturation, the secondary emission properties of dielectric, and the applied RF field parameters have been found, which led to the conclusion that the dynamics of one-side multipactor on dielectric is a resonant phenomenon.

43 PARTICLE ACCELERATORS↗
DOE OSTI2023

The influence of secondary electron yield uncertainty on the single-sided multipacting in dielectrics

Multipacting is an electrical discharge caused by the emission of secondary electrons which can occur in vacuum radio frequency systems. Generally multipacting is highly undesirable obstacle, which increases the noise level as well as the return loss of radio frequency systems. Therefore, a prediction of multipacting is necessary to avoid it during radio frequency system design. In this regard, the accurate evaluation of the factors that affect multipacting is required. One of the critical factors determining the multipacting development is the secondary electron yield of the material. In practice the emission properties of materials are not known very accurately. There are uncertainties in the measured values of this yield. In this paper, the generalized Polynomial Chaos (gPC) method is used to quantify uncertainty of the secondary electron yield. This method is verified by Monte Carlo simulation. The effect of uncertainty for two secondary electron yield parameters is then investigated on the multipacting using gPC method.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗
DOE OSTI2022

SRF Cavity Tuners for 3.9 GHz Cryomodules for LCLS-II Project

Fermilab conducted testing of three 3.9 GHz cryomodules for the LCLS-II project that will operate in continuous wave mode. A fast/fine tuning component was added to the LCLS-II 3.9 GHz tuner design due to the cavity bandwidth of 130 Hz which consists of two encapsulated piezos. Several cavities faced problems with fast-tuner operations after cooldown to 2 K and tuning the cavities to 3.9 GHz in cryomodule 2. All the piezo actuators were in working conditions but the slow tuner ranges required to stretch some of the cavities to the operational 3.9 GHz frequency were too small to deliver the required preload on the piezos. This behavior can be attributed to several factors: setting the initial warm cavity frequency during production too high, pressure tests of the warm cryomodule could have changed cavity frequency; and the small bending and twisting of the cavity-tuner system during the cooldown and warmup of the cavities. A decision was made to inelastically retune the warm cavities to decrease the unrestrained frequency by 200-300 kHz, this was done via the slow tuner. The results for this retuning method of three 3.9GHz cryomodules will be discussed.

43 PARTICLE ACCELERATORS↗
DOE OSTI2021

Novel Magnetron Operation and Control Methods for Superconducting RF Accelerators

High power magnetrons designed and optimized for industrial heating, being injection-locked, have been suggested to power superconducting RF cavities for accelerators due to lower cost and higher efficiency. However, standard operation methods do not provide high efficiency with wideband control suppressing microphonics. We have developed and experimentally verified novel methods of operating and controlling the magnetron that provide stable RF generation with higher efficiency and lower noise than other RF sources. By our method the magnetrons operate with the anode voltage notably lower than the self-excitation threshold improving its performance. This is also a promising way to increase tube reliability and longevity. A magnetron operating with the anode voltage lower than the self-excitation threshold, in so-called stimulated coherent generation mode has special advantage for pulse operation with a gated injection-locking signal. This eliminates the need for expensive pulsed HV modulators and additionally increases the magnetron RF source efficiency due to absence of losses in HV modulators.

43 PARTICLE ACCELERATORS↗
DOE OSTI2021

A New Design of a Dressed Balloon Cavity with Superior Mechanical Properties

Superconducting spoke cavities are prone to multipactor - resonant raise of a number of electrons due to secondary emission. Recently proposed and tested by TRIUMF balloon-type spoke cavity showed an outstanding multipactor (MP) suppression property but unfortunately serious Q degradation at high fields. A new fully developed design of a dressed balloon cavity which can be used for any proton linac SSR2 section is developed. The design incorporates additional EP ports for high Q-factor demonstration. Superior properties are demonstrated, such as effective multipactor suppression, 40% lower Lorentz force coefficient, zero sensitivity to external pressure. This paper presents the results of coupled structural Multiphysics analysis, and engineering design of the dressed balloon cavity with EP ports.

43 PARTICLE ACCELERATORS↗
DOE OSTI2021

Status of PIP-II 650 MHz Prototype Dressed Cavity Qualification

Low-beta and high-beta sections of PIP-II linac will use nine low-beta cryomodules with four cavities each and four high-beta cryomodules with six cavities each. These cavities will be produced and qualified in collaboration between Fermilab and the international partner labs. Prior to their installation into prototype cryomodules, several dressed cavities, which include jacketed cavities, high power couplers, and tuners, will be qualified in STC horizontal test bed at Fermilab. After qualification of bare β = 0.9 cavities at Fermilab, several pre-production β = 0.92 and β = 0.61 cavities have been and are being fabricated and qualified. Procurements have also been started for high power couplers and tuners. In this contribution we present the current status of prototype dressed cavity qualification for PIP-II.

43 PARTICLE ACCELERATORS↗
DOE OSTI2020

A Novel Technique for Pulsed Operation of Magnetrons without Modulation of Cathode Voltage

Modern pulsed superconducting accelerators of megawatt beams require efficient RF sources controllable in phase and power. For each Superconducting RF (SRF) cavity is desirable a separate RF source with power up to hundreds of kW with pulse duration in the millisecond range. The efficiency of the traditional RF sources (klystrons, IOTs, solid-state amplifiers) is lower than that of the magnetrons, while the cost of a unit of RF power is much higher. Therefore the magnetron-based RF sources would significantly reduce the capital and operation costs in comparison with the traditional RF sources. A recently developed an innovative technique makes possible the pulsed generation of magnetrons powered below the self-excitation threshold voltage. This technique does not require pulse modulators to form RF pulses. The magnetron operation in this regime is stable, low noise, controllable in phase and power, and provides higher efficiency than other types of RF power sources. It allows operation in pulsed modes with large duty factor. The developed technique and its experimental verification are considered and discussed.

43 PARTICLE ACCELERATORS↗
DOE OSTI2017

Simulation of Multipacting with Space Charge Effect

Here, the electron multiplication on surfaces exposed to an oscillating electromagnetic field causes the phenomenon of multipacting, which can degrade significantly the performance of vacuum RF devices, especially accelerating cavities. It is a serious obstacle to be avoided for normal operation of particle accelerator and their RF components. Many types of room temperature and superconducting accelerating cavities are designed and produced at Fermilab for different projects. The extensive simulations of multipacting in the cavities with updated material properties and comparison of the simulation results with experimental data are routinely performed during electromagnetic design of the cavities. The new advanced computing capabilities made it possible to take the space charge effect into account in the multipacting simulations. The basic new features of multipacting process that appear due to the space charge effect are shown for the classic case of the parallel plates and discussed. As the first practical application of the multipacting simulations with space charge effect the study of multipacting in the low-beta and high-beta 650 MHz elliptical superconducting cavities is also presented.

43 PARTICLE ACCELERATORS↗