On the use of liquid nitrogen droplets as flow tracers in cryogenic flow facilities at NASA Langley Research Center
Explore the source record for details and available documents.
cryogenic wind tunnels↗
Engineering topics
Ross A. Burns
Publications and source records attributed to Ross A. Burns.
Velocity Measurements Across an Oblique Shock Using Pulse-burst Cross-correlation DGV
Pulse-burst cross-correlation Doppler global velocimetry is performed in the NASA Langley Unitary Plan Wind Tunnel. The technique is used to make planar velocity measurements across an oblique shockwave, which is generated by a large splitter plate set at a -2° angle of attack in a Mach 2.4 flow. Assessment of the velocimetry indicates agreement with theoretical velocity values to within 0.6 percent on average. The single-scan spatial velocity precision is measured to be between 0.3 and 0.5 m/s, while the ensemble (1σ) precision of the measurements was within 2.2 percent of the measured velocities. The promising results encountered in this testing campaign indicate that the technique could be useful for studying more complex flow fields.
lasers↗
Evaluation of CFD for Simulation of High-Supersonic Control-Surface Effectiveness
As part of studying the ability of Computational Fluid Dynamics (CFD) to accurately model important flow physics in the high-supersonic Mach number range, control-surface effectiveness on an entry vehicle for Mars exploration was examined. As with several other important flow regimes studied under the CFD as Surrogate for Wind Tunnel Testing at High Supersonic Speeds Project, a combined CFD and wind-tunnel study of a proposed Mars landing configuration was undertaken. The testing was performed in high-speed test section of the NASA Langley Research Center’s Unitary Plan Wind Tunnel. The CFD team was an integral part of the overall evaluation team throughout the model development and test planning process and performed pre-test computations predicting the results of the testing. For the CFD predictions of the model in the wind tunnel, the flow into the test section was imposed as a boundary condition. The imposed inflow was based on a previous flow characterization study and companion CFD simulating the flow from the settling chamber through the test section.
James C. Ross↗
Hybrid pulse-burst / cross-correlation DGV for high-speed flow measurements at 100 kHz
Hybrid pulse-burst Doppler global velocimetry (PB-DGV)/pulse-burst, cross-correlation DGV (PB-CC-DGV) was demonstrated for the first time in the NASA Langley 4-foot Supersonic Unitary Plan Wind Tunnel, allowing simultaneous acquisition of mean and instantaneous high-repetition-rate velocity fields. The technique was used to make planar velocity measurements across an oblique shockwave generated by a large splitter plate set at a -2° angle of attack in a Mach 2.4 flow. Sequences of more than 100 consecutive instantaneous velocity images were obtained at a rate of 100 kHz. Velocity fields from both aspects of the hybrid measurement indicated errors less than 1-percent of anticipated velocities. Likewise, all assessments of measurement precision were approximately 1.6-percent of the local velocities. Additional demonstrations in different flowfields including a subsonic axi-symmetric jet and a supersonic Mars reentry vehicle model further illustrate the utility of the new hybrid method.
laser↗
Characterization of Naturally-Occurring Particles in the Nasa Langley 0.3-m Transonic Cryogenic Tunnel Using PTV
Naturally-occurring particles within the NASA Langley 0.3-m Transonic Cryogenic Tunnel are characterized for their aerodynamic performance using particle tracking velocimetry. Two sets of experiments were conducted to observe different behaviors of the particles. The normal shockwave emanating from the top surface of a supercritical airfoil was used to induce velocity lag in the particles, and the subsequent spatial decay of the velocity was used to estimate the effective diameter of the particles. Mean particle diameters between 1.6 and 1.9 𝝁m were measured, with sizes ranging from 0.2 to 3.5 𝝁m over the entire ensemble. The response of particles to separated flow was investigated. By operating in “high-lift” (low Mach number, high angle of attack) conditions with a semi-span airfoil, the ability of particles to detect separated flow on the upper surface of the airfoil was assessed. Transition from fully attached flow to fully separated flow was observed on the top surface of the airfoil accompanying a variation of angle of attack from 8° to 12°. Examination of velocity distributions indicates less than 10 percent of particle trajectories did not respond to the regions of separated flow. These results are promising, but further facility-specific work is needed to answer the broader question of particle tracking reliability.
Transonic↗
Self-Aligned Focusing Schlieren at the 0.3-M Transonic Cryogenic Tunnel and the National Transonic Facility
The implementation of a self-aligned focusing schlieren (SAFS) system at two cryogenic wind tunnels at NASA Langley Research Center is discussed. Risk-reduction testing of the SAFS system was first performed at the 0.3-M Transonic Cryogenic Tunnel to evaluate the system’s operation in a small-scale characteristic cryogenic facility. Testing was conducted with three models: a three-quarter span 25.4-mm-diameter cylinder, a semi-span 65A006 tapered unswept airfoil, and a full-span SC(3)-0712 airfoil. Testing with the cylinder and semi-span airfoil revealed a highly dynamic shock environment, whereas the shock on the full-span airfoil was stationary, solidifying the usage of this model for a pre-/post-shock particle tracking velocimetry measurement. Temperature-induced polarization-altering window stresses were encountered during low-temperature testing, and were mitigated using a “non-ideal” quartz/quartz Rochon prism that had largely been neglected since the SAFS system’s first introduction in favor of the more favorable “ideal” glass/quartz Rochon prism. The size of the SAFS system was then decreased in order to fit inside an environmentally-controlled camera can enclosure at the National Transonic Facility (NTF) for testing of a sting-mounted aircraft model. The SAFS system was demonstrated to be effective at filtering out the large density gradient flow in the 0.3-M plenum, and the thick, high density turbulent boundary layers on the wind tunnel walls at the NTF. Results of the testing campaigns and improvements to future systems are discussed.
Joshua M. Weisberger↗
Wall-Jet Evolution During Plume-Surface Interaction Using PLIF Imaging
Planar laser-induced fluorescence (PLIF) flow visualization was used to examine the spatial evolution for the wall-jet formed by an impinging supersonic jet in a large-scale vacuum environment. This canonical configuration is representative of the plume-surface interaction induced by a rocket exhaust plume impinging on the planetary surface at lunar-relevant and Martian-relevant environments. PLIF flow visualization of the very low-density environment (as low as ~0.006% of standard atmospheric density) was performed using seeded nitric oxide in a nitrogen flow at three test conditions. Two conditions are representative of the lunar environment, and one is representative of the Martian environment. The combined images from two simultaneous PLIF views were used to construct a 2D slice of the flowfield spanning approximately 150 mm in height (determined by the laser sheet) and 500 mm in width (determined by the camera views). The three test conditions showed different behavior for the wall-jet, largely due to the different levels of lifting above the surface and the appearance of a physical process similar to a Kelvin–Helmholtz instability for the Martian-relevant case, which appeared to create a dramatic expansion of the wall-jet height with increased radial distance.
PSI↗