Engineering topics

Rothman, S. D.

Publications and source records attributed to Rothman, S. D..

4 records

DOE OSTI2023

Crystal plasticity finite element simulation of lattice rotation and x-ray diffraction during laser shock compression of tantalum

Here we present a crystal plasticity model tailored for high-pressure, high-strain-rate conditions that uses a multiscale treatment of dislocation-based slip kinetics. We use this model to analyze the pronounced plasticity-induced lattice rotations observed in shock-compressed polycrystalline tantalum via in situ x-ray diffraction. By making direct comparisons between experimentally measured and simulated texture evolution, we can explain how the details of the underlying slip kinetics control the degree of lattice rotation that ensues. Specifically, we show that only the highly nonlinear kinetics caused by dislocation nucleation can explain the magnitude of the rotation observed under shock compression. We demonstrate a good fit between our crystal plasticity model and x-ray diffraction data and exploit the data to quantify the dislocation nucleation rates that are otherwise poorly constrained by experiment in the dynamic compression regime.

36 MATERIALS SCIENCE↗

DOE OSTI2022

Experimental observation of open structures in elemental magnesium at terapascal pressures

Investigating how solid matter behaves at enormous pressures, such as those found in the deep interiors of giant planets, is a great experimental challenge. Over the past decade, computational predictions have revealed that compression to terapascal pressures may bring about counter-intuitive changes in the structure and bonding of solids as quantum mechanical forces grow in influence. Although this behavior has been observed at modest pressures in the highly compressible light alkali metals, it has not been established whether it is commonplace among high-pressure solids more broadly. We used shaped laser pulses at the National Ignition Facility to compress elemental Mg up to 1.3 TPa, which is approximately four times the pressure at the Earth’s core. By directly probing the crystal structure using nanosecond-duration X-ray diffraction, we found that Mg changes its crystal structure several times with non-close-packed phases emerging at the highest pressures. Our results demonstrate that phase transformations of extremely condensed matter, previously only accessible through theoretical calculations, can now be experimentally explored.

36 MATERIALS SCIENCE↗

DOE OSTI2021

Measurement of the strengths of Be and Pb4Sb by quasi-isentropic compress and release at near 100 GPa

The Ramp-compression experiments have been performed on the “Z” pulsed-power facility to investigate the strengths of Be and lead-antimony alloy. Yield strength and shear stress near peak pressure were obtained from measurements of the sound speed on release and using the Asay self-consistent method. Two S-65 grade Be samples, from batches which showed a significant difference in yield strength at ambient conditions, were found to have near identical yield strengths, which were also in agreement with similar earlier measurements on S-200 grade Be. Yield strength of Pb4Sb alloy at ~120 GPa was 1.35 GPa, while a National Ignition Facility (NIF) experiment by A. Krygier et al. (Phys. Rev. Lett. 123, 205701 (2020)) found 3.8 GPa at ~400 GPa pressure. Our result is intermediate between the ambient value and the Krygier one, but the significantly increased strength is probably not associated with the transition to the high-pressure bcc phase of lead.

42 ENGINEERING↗

DOE OSTI2021

Shock-ramp analysis test problem

Quasi-isentropic (ramp) compression is now a well-established experimental method and so are the analysis techniques to give Lagrangian sound speed, pressure, and density along the sample material's isentrope. A shock followed by ramp compression is a natural extension to investigate, for example, shock melt and refreeze on compression, or isentropes of states off the Hugoniot or principal isentrope. In practice, graded-density impactors produce initial shocks, compression by shaped laser pulses may be unable to produce a smooth pressure increase from zero, and incidental perturbations on the drive pulse may also give rise to shocks, so robust shock-ramp analysis methods will be needed. Appropriate analysis methods are needed for shock-ramp experiments, based on those for quasi-isentropic compression, and these require validation. This paper describes three different analyses of a shock-ramp test problem, including an assessment of their estimated errors. The methods tested were based on hydrodynamic characteristics or integration backward in space. All methods gave the known Lagrangian sound speed to within ~1%, and pressure and volume to within less than 2% and 1%, demonstrating that the analysis methods of isentropic compression experiments can be confidently extended to the analysis of shock and ramp compression.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗