Search NASA⌕ Search

Engineering topics

Rubin, S. G.

Publications and source records attributed to Rubin, S. G..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2001

Segmented Domain Decomposition Multigrid For 3-D Turbomachinery Flows

A Segmented Domain Decomposition Multigrid (SDDMG) procedure was developed for three-dimensional viscous flow problems as they apply to turbomachinery flows. The procedure divides the computational domain into a coarse mesh comprised of uniformly spaced cells. To resolve smaller length scales such as the viscous layer near a surface, segments of the coarse mesh are subdivided into a finer mesh. This is repeated until adequate resolution of the smallest relevant length scale is obtained. Multigrid is used to communicate information between the different grid levels. To test the procedure, simulation results will be presented for a compressor and turbine cascade. These simulations are intended to show the ability of the present method to generate grid independent solutions. Comparisons with data will also be presented. These comparisons will further demonstrate the usefulness of the present work for they allow an estimate of the accuracy of the flow modeling equations independent of error attributed to numerical discretization.

Celestina, M. L.↗
NASA NTRS1993

A three-dimensional pressure flux-split RNS application to sub/supersonic flow in inlets and ducts

The reduced Navier-Stokes (RNS) formulation is combined with a pressure based flux split procedure for the computational analysis of three dimensional flow. Only lowest order diffusion, that is required to satisfy the no-slip boundary condition is retained in this approximation. The governing equations are appropriately differenced such that the physical boundary conditions are closely coupled and combined to form a closed discrete system. No numerical or characteristic type boundary conditions are required. A global pressure relaxation procedure, i.e. multi-sweep PNS, is considered. A sparse matrix direct solver is applied to the crossplane solution. At the outflow boundary only the pressure or pressure gradient is prescribed. The resulting formulation has been applied to the solution of three-dimensional subsonic/supersonic internal flows in inlets and ducts.

Khosla, P. K.↗
NASA NTRS1991

Pressure flux-split viscous solutions for subsonic diffusers

A method for predicting flow in diffusers with inlet swirl has been developed. Solutions of the pressure flux-split Reduced Navier Stokes (RNS) equations are obtained for flows in axisymmetric diffusers. Viscous-Inviscid interactions and flow fields with toroidal recirculation regions are efficiently captured. The computational model is verified by comparision with experimental data and other computations. The extreme sensitivity to grid, turbulent closure model and inlet profiles is discussed.

Pordal, H. S.↗
NASA NTRS1991

A pressure flux-split technique for computation of inlet flow behavior

A method for calculating the flow field in aircraft engine inlets is presented. The phenomena of inlet unstart and restart are investigated. Solutions of the reduced Navier-Stokes (RNS) equations are obtained with a time consistent direct sparse matrix solver that computes the transient flow field both internal and external to the inlet. Time varying shocks and time varying recirculation regions can be efficiently analyzed. The code is quite general and is suitable for the computation of flow for a wide variety of geometries and over a wide range of Mach and Reynolds numbers.

Pordal, H. S.↗
NASA NTRS1991

Solution of three-dimensional afterbody flow using reduced Navier-Stokes equations

The flow over afterbody geometries was investigated using the reduced Navier-Stokes (RNS) approximation. Both pressure velocity flux-split and composites velocity primitive variable formulations were considered. Pressure or pseudopotential relaxation procedures are combined with sparse matrix or coupled strongly implicit algorithms to form a three-dimensional solver for general non-orthogonal coordinates. Three-dimensional subsonic and transonic viscous/inviscid interacting flows were evaluated. Solutions with and without regions of recirculation were obtained.

Almahroos, H. M. H.↗
NASA NTRS1991

Inviscid steady/unsteady flow calculations

The solution of the Euler equations using a flux splitting procedure is considered for low subsonic to high supersonic flows. Steady and unsteady, internal and external flow fields, are computed. For transient flows, a direct sparse matrix solver is applied to compute the flow field at each instant of time. Oscillation free normal and oblique shocks are captured. Unstart and restart of a simplified two-dimensional inlet is investigated.

Pordal, H. S.↗
NASA NTRS1990

Transient behavior of supersonic flow through inlets

A solution technique to compute inlet flow behavior is presented. The phenomena of inlet unstart and restart are investigated using a flux-split procedure applied to the Euler and Reduced Navier Stokes (RNS) equations. A time consistent direct sparse matrix solver in conjunction with a domain decomposition strategy is applied to compute the transient flow behavior both internal and external to the inlet. Time varying shocks and time varying recirculation regions are efficiently analyzed. The code is quite general and is suitable for the computation of flow for a wide variety of geometries and over a wide range of Mach and Reynolds numbers.

Pordal, H. S.↗
NASA NTRS1990

Global pressure relaxation for laminar two-dimensional internal flow

This study extends the reduced Navier-Stokes (RNS) global pressure relaxation procedure developed by Rubin and co-workers for external flow to internal flow applications. The streamwise pressure gradient is split into a backward-differenced or initial value component, as in boundary layer marching, and a forward-differenced or boundary value component that represents the elliptic downstream effects. The streamwise convection terms are upwind-differenced and all other streamwise derivatives are backward-differenced. A standard boundary layer marching technique imbedded in a conventional line relaxation technique is obtained. For compressible flow the pressure iteration determines the interior flow interaction as well as the inlet mass flux that is consistent with the outflow pressure boundary condition. Results have been computed for incompressible flow in both rectangular and curved channels, and for subsonic compressible flow in the simulation of an aerofoil in a wind tunnel. Converged solutions were obtained over a range of Reynolds numbers generating small to moderately large separation bubbles.

Rosenbaum, D.↗
NASA NTRS1990

A flux-split solution procedure for unsteady inlet flows

The unstart and restart of an axisymmetric inlet is investigated using a flux-split procedure applied to the Euler and Reduced Navier Stokes (RNS) equations. A time consistent direct sparse matrix solver is applied to compute the transient flow field both internal and external to the inlet. Time varying oblique and normal shocks are captured. The code is quite general and is applicable for subsonic, transonic and supersonic free streams. The current analysis is concerned with supersonic flight conditions.

Pordal, H. S.↗
NASA NTRS1990

A flux-split solution procedure for unsteady flow calculations

The solution of reduced Navier Stokes (RNS) equations is considered using a flux-split procedure. Unsteady flow in a two dimensional engine inlet is computed. The problems of unstart and restart are investigated. A sparse matrix direct solver combined with domain decomposition strategy is used to compute the unsteady flow field at each instant of time. Strong shock-boundary layer interaction, time varying shocks and time varying recirculation regions are efficiently captured.

Pordal, H. S.↗
NASA NTRS1990

A review of reduced Navier-Stokes computations for compressible viscous flows

A reduced form of the Navier-Stokes equations, defined by a single composite of the Euler, boundary layer, and triple deck approximations, is considered for the computation of viscous interacting flows. Global pressure or pseudopotential relaxation methods are integrated with coupled sparse matrix direct solvers or coupled strongly implicit ILU algorithms to efficiently capture sharp shocks and regions of recirculation. Solutions are obtained for a variety of 2D and 3D geometries and for Mach numbers (M) spanning the range from incompressible (M = 0) to supersonic (M = 6) flow.

Rubin, S. G.↗
NASA NTRS1989

Transonic flow solutions using a composite velocity procedure for potential, Euler and RNS equations

Solutions for transonic viscous and inviscid flows using a composite velocity procedure are presented. The velocity components of the compressible flow equations are written in terms of a multiplicative composite consisting of a viscous or rotational velocity and an inviscid, irrotational, potential-like function. This provides for an efficient solution procedure that is locally representative of both asymptotic inviscid and boundary layer theories. A modified conservative form of the axial momentum equation that is required to obtain rotational solutions in the inviscid region is presented and a combined conservation/nonconservation form is applied for evaluation of the reduced Navier-Stokes (RNS), Euler and potential equations. A variety of results is presented and the effects of the approximations on entropy production, shock capturing, and viscous interaction are discussed.

Gordnier, R. E.↗
NASA NTRS1989

3-D composite velocity solutions for subsonic/transonic flows

A composite velocity procedure for the three-dimensional reduced Navier-Stokes equations is developed. In the spirit of matched asymptotic expansions, the velocity components are written as a combination multiplicative and additive composite of viscouslike velocities and pseudopotential or inviscid velocities. The solution procedure is then consistent with both asymptotic inviscid flow and boundary layer theory. For transonic flow cases, the Enquist-Osher flux biasing scheme developed for the full potential equation is used. A quasi-conservation form of the governing equations is used in the shock region to capture the correct rotational shock with the standard nonconservation form of the equations used in nonshock regions. The consistent coupled strongly implicit procedure coupled with a plane relaxation procedure is used to solve the discretized equations.

Gordnier, R. E.↗
NASA NTRS1988

Consistent boundary conditions for Reduced Navier-Stokes (RNS) scheme applied to 3-dimensional internal viscous flows

A consistent and efficient set of boundary conditions is developed for the multi-sweep space-marching pressure-elliptic Reduced Navier-Stokes (RNS) scheme as applied for 3-D internal viscous flow problems. No-slip boundary conditions are directly imposed on the solid walls. There is no iteration procedure required in the cross plane to ensure mass conservation across each marching plane. The finite difference equations forming the coefficient matrix are ordered such that the surface normal velocity is specified on all the solid walls; unlike external flows, a pressure boundary condition in the cross plane is not required. Since continuity is directly satisfied at all points in the flow domain, the first order momentum equations can be solved directly for the pressure without the need for a Poisson pressure correction equation. The procedure developed herein can also be applied with periodic boundary conditions. The analysis is given for general compressible flows. Incompressible flow solutions are obtained, for straight and curved ducts of square cross section, to validate the procedure. These solutions are used to demonstrate the applicability of the RNS scheme, with the improved boundary conditions for internal flows with strong interaction, as would be encountered in ducts and turbomachinery geometries.

Reddy, D. R.↗
NASA NTRS1988

Consistent boundary conditions for reduced Navier-Stokes (RNS) scheme applied to three-dimensional internal viscous flows

Three-dimensional internal viscous flow problems are presently addressed by a consistent and efficient set of boundary conditions for the multisweep space-marching, pressure-elliptic Reduced Navier-Stokes scheme. Since continuity is by this means directly satisfied at all points in the flow domain, the first-order momentum equations are directly solvable for pressure without the requirement for a Poisson pressure-correction equation. Incompressible flow solutions are obtained for straight and curved ducts of square cross section, in order to validate the procedure. Usefulness is demonstrated for internal flows with strong interactions, as would be found in turbomachine geometries.

Reddy, D. R.↗
NASA NTRS1986

Transonic flow solutions using a composite velocity procedure for potential, Euler and RNS equations

Solutions for transonic viscous and inviscid flows using a composite velocity procedure are presented. The velocity components of the compressible flow equations are written in terms of a multiplicative composite consisting of a viscous or rotational velocity and an inviscid, irrotational, potential-like function. This provides for an efficient solution procedure that is locally representative of both asymptotic inviscid and boundary layer theories. A modified conservative form of the axial momentum equation that is required to obtain rotational solutions in the inviscid region is presented and a combined conservation/nonconservation form is applied for evaluation of the reduced Navier-Stokes (RNS), Euler and potential equations. A variety of results is presented and the effects of the approximations on entropy production, shock capturing, and viscous interaction are discussed.

Gordnier, R. E.↗
NASA NTRS1984

Incompressible Navier-Stokes and parabolized Navier-Stokes formulations and computational techniques

The differential formulations and computational techniques currently used for the incompressible Navier-Stokes (NS) and parabolic Navier-Stokes (PNS) equations are reviewed. In particular, attention is given to problems associated with the choice of difference equations, the method of solution and the choice of algorithm, the coupling of dependent variables and discretized equations, the application of boundary conditions, and grid generation. A new composite velocity NS and PNS formulation in (u,v,p) variables is presented, and the applicability of a 'forward' difference global pressure iteration for the (u,v,p) PNS system is demonstrated.

Rubin, S. G.↗