Electrostatic Work Causes Unexpected Reactivity in Ionic Photoredox Catalysts in Low Dielectric Constant Solvents
Not Available
37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
Engineering topics
Rumbles, Garry (ORCID:0000000307761462)
Publications and source records attributed to Rumbles, Garry (ORCID:0000000307761462).
Free-Charge Carrier Generation in Homojunction Non-Polymeric Organic Semiconductor Films - The Role of the Optical Frequency Dielectric Constant
Engineering the dielectric constant (..epsilon..) to lower the exciton binding energy of the light-absorbing semiconductor can improve organic photovoltaic (OPV) device performance. Here, a series of materials are reported with 2-(3-oxo-2,3-dihydro-1H-inden-1-ylidene)malononitrile (INCN) acceptor end groups and a central glycolated bis(4H-cyclopenta[2,1-b:3,4-b']dithiophene) unit with large low-frequency (..epsilon..lf = 7.4-7.9 at 0.1-0.2 MHz) and optical-frequency (..epsilon..opt up to 6.6 at 2 x 1014 Hz) dielectric constants. The INCN end groups differed in whether they were protonated, chlorinated, or fluorinated, with the latter having the highest ..epsilon..opt. An ..epsilon..opt of 6.6 is predicted to lead to a low exciton binding energy of ~0.04 eV. Time-resolved microwave conductivity measurements showed a temperature-dependent yield-mobility product, with it increasing linearly from 340 K. The onset temperature was near that required to overcome the calculated exciton binding energy and indicates increased free charge generation in a homojunction film. Room temperature transient absorption spectroscopy revealed that photoexcitation rapidly converted to a lower energy state that was consistent with the formation of polarons or a charge transfer state. This work provides experimental evidence of the importance of ..epsilon..opt for the generation of free charges, and a strategy for development of efficient single chromophore homojunction OPV devices.
charge generation↗
The Driving Force Controls Charge Separation Distance in Solid-State Organic Donor/Acceptors
In this work, charge pairs of varying separation distance are interpreted from photoinduced absorption detected magnetic resonance (PADMR) spectroscopy of organic, small molecule dilute donor/acceptor thin films. We report that a donor/acceptor film that generates few free charges at room temperature yet has a relatively large, calculated driving force for electron transfer generates a large concentration of tightly bound CT states when measured with PADMR. These states are markedly absent in films with smaller driving forces yet higher free charge yields which instead only show charge-separated state signals with weaker spin coupling. We interpret this result to be in support of a hypothesis where a larger reorganization energy associated with charge transfer to tightly bound CT states means that they are primarily generated in systems far from the Marcus optimum for free charge yield. And the highest free charge yielding systems instead predominantly undergo long-range charge separation into the acceptor host.
charge separation↗
Observing Charge Separation Distance in Organic Donor-Acceptors with Photoinduced Absorption Detected Magnetic Resonance Spectroscopy
The debatable role of charge transfer states in photoinduced charge separation to useful free carriers has been a long-standing controversy in the field of organic solar cells. In this work, varying charge-pair distances are measured in sensitized donor-acceptor thin films using a photoinduced absorption-detected magnetic resonance (PADMR) technique where nearest-neighbor charge transfer states are identified by their strong magnetic dipole-coupling relative to more distant charges. Correlation with the direct measurement of free carriers using time-resolved microwave conductivity has corroborated a distributed-range electron transfer model in which charges generated at longer distances become free carriers, while shorter transfer distances give only bound charge transfer states that cannot separate to generate photocurrent.
charge transfer↗
Metal–Carbodithioate-Based 3D Semiconducting Metal–Organic Framework: Porous Optoelectronic Material for Energy Conversion
Solar energy conversion requires the working compositions to generate photoinduced charges with high potential and the ability to deliver charges to the catalytic sites and/or external electrode. These two properties are typically at odds with each other and call for new molecular materials with sufficient conjugation to improve charge conductivity but not as much conjugation as to overly compromise the optical band gap. In this work, we developed a semiconducting metal-organic framework (MOF) prepared explicitly through metal-carbodithioate"(-CS 2 ) n M" linkage chemistry, entailing augmented metal-linker electronic communication. The stronger ligand field and higher covalent character of metal-carbodithioate linkages-when combined with spirofluorene-derived organic struts and nickel-(II) ion-based nodes-provided a stable, semiconducting 3D-porous MOF, Spiro-CS 2 Ni. This MOF lacks long-range ordering and is defined by a flexible structure with non-aggregated building units, as suggested by reverse Monte Carlo simulations of the pair distribution function obtained from total scattering experiments. The solvent-removed "closed pore"material recorded a Brunauer-Emmett-Teller area of similar to 400m 2 /g, where the "open pore" form possesses90 wt % solvent-accessible porosity. Electrochemical measurements suggest that Spiro-CS 2 Ni possesses a band gap of 1.57 eV(sigma = 10 -7 S/cm at -1.3 V bias potential),which can be further improved by manipulating the d-electron configuration through an axial coordination (ligand/substrate), the latter of which indicates usefulness as an electrocatalyst and/or a photoelectrocatalyst(upon substrate binding). Transient-absorption spectroscopy reveals a long-lived photo-generated charge-transfer state (τ CR = 6.5 mu s) capable of chemical transformation under a biased voltage. Spiro-CS 2 Ni can endure a compelling range of pH(1-12 for weeks) and hours of electrochemical and photoelectrochemical conditions in the presence of water and organic acids. We believe this work provides crucial design principles for low-density, porous,light-energy-conversion materials.
36 MATERIALS SCIENCE↗
Ion-Pair Reorganization Regulates Reactivity in Photoredox Catalysts
Cyclometalated and polypyridyl complexes of d6 metals are promising photoredox catalysts, using light to drive reactions with high kinetic or thermodynamic barriers via the generation of reactive radical intermediates. However, while tuning of their redox potentials, absorption energy, excited-state lifetime and quantum yield are well-known criteria for modifying activity, other factors could be important. Here we show that dynamic ion-pair reorganization controls the reactivity of a photoredox catalyst, [Ir[dF(CF3)ppy]2(dtbpy)]X. Time-resolved dielectric-loss experiments show how counter-ion identity influences excited-state charge distribution, evincing large differences in both the ground- and excited-state dipole moment depending on whether X is a small associating anion (PF6-) that forms a contact-ion pair versus a large one that either dissociates or forms a solvent-separated pair (BArF4-). These differences correlate with the reactivity of the photocatalyst toward both reductive and oxidative electron transfer, amounting to a 4-fold change in selectivity toward oxidation versus reduction. These results suggest that ion pairing could be an underappreciated factor that modulates reactivity in ionic photoredox catalysts.
catalysis↗
Sustainable Energy & Fuels: 2022 and Beyond
Welcome to the first issue of volume 6 of Sustainable Energy & Fuels (SEF).
ENERGY PLANNING, POLICY, AND ECONOMY↗