Engineering topics

Ruoff, A. L.

Publications and source records attributed to Ruoff, A. L..

At least 19 records

NASA NTRS1984

Ultrapressure materials science

Three active areas of research at ultra pressure are pursued, i.e., diffraction studies with the Cornell High Energy Synchrotron Source (CHESS), band gap and absorption edge effects, indentor-anvil experiments and theory and research to attain higher pressures. The range over which X-ray diffraction data and absorption edge data are obtained is extended to 700 kbars. Using the indentor technique pressures of 2.1 Mbars are obtained. Research results and methods are discussed.

Ruoff, A. L.↗

NASA NTRS1984

Etching of diamond with argon and oxygen ion beams

The angular dependences of the sputter yield of (100) single crystal diamond under argon and oxygen ion beams were investigated. For argon ion beams a large increase in the sputter yield was observed as the angle of incidence was increased from the normal, with a maximum occurring at approximately 60 deg from the normal. The magnitude of the increase and the angle at which the maximum was observed were dependent on the ion energy and species. The shape of the yield versus angle of incidence curve indicated the presence of a highly damaged surface layer. Large deviations from this curve were observed where ion incidence was along channeling directions. Studies with oxygen ion beams showed almost no angular dependence for 500 eV ions while at an energy of 1000 eV the angular dependence was similar to that for argon ions. At normal incidence the yield for 500 eV oxygen ions was seven times larger than that for 500 eV argon ions. For 1000 eV oxygen and argon ions the corresponding ratio is only 2.5. Implications for mechanisms of inert and reactive ion etching are discussed. Application of the data to ion beam shaping of diamond tips for ultrahigh pressure research is discussed.

Whetten, T. J.↗

NASA NTRS1983

Pressure-induced phase transition of HgS

The high pressure phase transition of cinnabar (alpha-HgS) was studied by energy dispersive X-ray diffraction using a synchrotron X-ray source. The cinnabar crystal structure was found to transform to the sodium-chloride structure at about 130 kbar. The lattice parameter of the new phase was determined to be 5.070 + or - 0.005 A at 300 kbar. No further phase transition was observed up to 400 kbar.

Huang, T.↗

NASA NTRS1983

New method of determining the onset of ring cracking

A technique is developed for the detection of the onset of circumferential ring cracks in a flat brittle piece of an electrically insulating material. Thin metal films were deposited on both the insulating indentor (diamond) and the insulating brittle flat. The initiation of a ring crack was signified by a step in the monitored electrical contact resistance between the indentor and flat metal films versus the applied force. It was determined by tests performed on polished glass slides using diamond indentors that this technique is both sensitive and reproducible. The onset of crack formation as observed by optical means was found to occur at the same time as the step in the contact resistance when both experiments were carried out simultaneously.

Grzybowski, T. A.↗

NASA NTRS1982

Pressure concentrations due to plastic deformation of thin films or gaskets between anvils

Plastic deformation of either a sample or a gasket between diamond anvils leads to large pressure concentrations, i.e., the maximum pressure can be many times the average pressure. This behavior is discussed using elementary plasticity theory for the case where the pressures are sufficiently low that the yield stress can be assumed not to vary with pressure. It is then shown that the pressure concentration factor can be even much larger when the yield stress of the sample at the highest pressure is much greater than the yield stress at the lowest pressure. This is illustrated with solid xenon where it is shown that the assumption that Nelson and Ruoff made about the pressure distribution in their xenon samples is incorrect. The pressure distribution is shown to be much steeper than assumed. Thus, the pressure they observed electrical conduction in xenon was above 1 Mbar.

Chan, K. S.↗

NASA NTRS1982

Diffraction studies of the high pressure phases of GaAs and GaP

High pressure structural phase transitions of GaAs and GaP have been studied by energy dispersive X-ray diffraction with the radiation from the Cornell High Energy Synchrotron Source. GaAs began to transform at 172 + or - 7 kbar to an orthorhombic structure possibly belonging to space group Fmmm. GaP transformed to a tetragonal beta-Sn type phase at 215 + or - 8 kbar. Although pressure transmitting media were used to minimize shear stresses in the specimens, the high pressure diffraction results were interpreted as showing evidence for planar defects in the specimens.

Baublitz, M., Jr.↗

NASA NTRS1982

X-ray diffraction from high pressure Ge using synchrotron radiation

The high pressure structural phase transition in Ge has been studied using the energy dispersive X-ray diffraction technique and a synchrotron radiation source. Ge was observed to transform to the beta-Sn tetragonal structure in agreement with the earlier results of Jamieson, but the phase transition began at 80 + or - 5 kilobars, a somewhat lower value than generally reported. These experimental diffraction results are compared with the recent self-consistent pseudopotential calculations of Yin and Cohen (1981) and with the observed transition pressure for shock wave loaded Ge.

Baublitz, M., Jr.↗

NASA NTRS1981

The failure strengths of perfect diamond crystals

Finite elasticity analysis is extended to the 110 direction, where off axis strain symmetry is not present, and the third order elastic data are obtained for diamond. The compressive yield strengths of perfect diamond crystals loaded in the 100, 110, and 111 directions are predicted to be 2.2, 5.6, and 2.8 Mbars, respectively, while the corresponding tensile fracture strengths are 1.0, 0.5, and 0.5 Mbars. From these results and from Hertz theory it is predicted that ring fracture of spherically tipped diamonds pressed against a flat will occur at pressures of 1.8-1.9 Mbars, substantially below the yield pressure (above 3 Mbars). Modification of the tip shape leads to a predicted increase in the pressure at which fracture occurs.

Whitlock, J.↗

NASA NTRS1981

Behavior of sulfur at high pressures and low temperatures

A new type of high-pressure apparatus for low-temperature experiments was built, which allows loading and measuring the load in situ at low temperature (1.5 K). It uses the diamond anvil in the flat-indentor configuration. It was used to investigate the high-conductivity state of sulfur at low temperatures. For pressures in the 50-GPa range, sulfur is still a semiconductor or at best a two phase semiconductor-metal system. As the temperature is lowered at 50 GPa, the resistance drops slightly, reaches a minimum around 230 deg K, and then increases dramatically.

Golopentia, D. A.↗

NASA NTRS1981

Apparatus for high-pressure and low-temperature experiments

A new type of apparatus for high-pressure experiments at low temperature (1.5 K) is presented. It uses a flat diamond anvil with a spherical indentor. It utilizes a load ring placed under the sample, so that the load (and hence pressure) can be measured in situ at low temperature. The apparatus was successfully used to investigate the high-conductivity state of sulphur. It can be used to investigate other thin film samples.

Golopentia, D. A.↗

NASA NTRS1980

Estimation of uncertainty in isotherms deduced from Hugoniots resulting from shockwave generated defects

The problem of how defect concentrations produced in a shock experiment affect the isothermal equation of state is considered. From the few experimental results available that bear directly on this question, it appears the effect could be substantial, i.e., the pressure in material free of defects may be 10-25% lower at a given volume than the isothermal pressure deduced from Hugoniot data on the assumption that defects are negligible in the shocked material. This correction caused by the presence of defects is called the defect pressure.

Ruoff, A. L.↗

NASA NTRS1979

Analysis of resistance-versus-pressure relations for the diamond indentor-anvil system

Pressures in excess of 1.4 Mbars have been attained by Ruoff and Wanagel (1977) by pressing tiny spherical diamond indentors (tip radius of 2 microns or less) against a diamond anvil. This system has been used for resistance-vs-pressure measurements as follows. A thin (200 A) coherent layer of a conductor, e.g., palladium, can be sputtered on the tip and on the anvil and electrical leads can then be attached to these at points remote from the contact area. Then a thin layer of the sample to be studied can be evaporated, sputtered, or placed on the anvil. When the indentor is pressed against the sample, the resistance changes as the pressure increases and as the contact radius increases. This paper analyzes the resistance-vs-pressure relationship for three different types of resistivity-vs-pressure behavior.

Ruoff, A. L.↗

NASA NTRS1979

The relation of the yield stress of high-pressure anvils to the pressure attained at yielding and the ultimate attainable pressure

A sensitive microprofilometer was used to determine the onset of yielding in the anvils of a supported opposed anvil device for the case of 3% cobalt-cemented tungsten carbide as the anvil material. In addition, it is shown how the commencement of yielding in boron carbide pistons, the yield strength being known, can be used to obtain the transition pressure to a conducting phase in gallium phosphide. The transition pressures of bismuth and gallium phosphide are obtained and it is found that these transitions are extremely close to the maximum attainable pressure in, respectively, a maraging steel and a 3% cobalt-cemented tungsten carbide.

Panda, P. C.↗

NASA NTRS1979

Static compression of Al2O3 to 1.2 Mbars /120 GPa/

Pressures up to 120 GPa were generated when a diamond indentor of radius 10.0 micrometers was pressed against a very thin sample of Al2O3 on a diamond flat. The thin film of Al2O3 was prepared by sputtering of aluminum in an oxygen atmosphere. From the measurement of the electrical resistance of Al2O3 as a function of pressure it was found that Al2O3 remains an insulator at the highest pressure studied, namely, 120 GPa.

Gupta, M. C.↗

NASA NTRS1979

Status of equation of state of solids

The results of equation of state (pressure-volume-temperature) measurements for the rare gas solids, alkali metals and alkali halides are reviewed. The precision and errors associated with the techniques most commonly used to obtain measurements of volume as a function of pressure, including piston volume displacement, ultrasonic, shock wave, and Brillouin scattering techniques, length change measurement, and combined length change and ultrasonic transit techniques, are presented. The various equations of state which are normally used to represent these measurements are discussed.

Ruoff, A. L.↗

NASA NTRS1979

Studies of the high pressure transition in sulfur

High-pressure transition in crystalline orthorhombic sulfur has been investigated, using a diamond indentor pressed against a diamond flat to produce pressures up to 300 kbar and an opposed-anvil apparatus to obtain lower pressures. The first indication of sulfur transition using the indentor technique was seen when resistance measured 3 times 10 to the 12th ohm. Transition was found to be sluggish and highly time-dependent.

Ruoff, A. L.↗

NASA NTRS1979

Linear ruby scale and one megabar

The accuracy and validity of certain techniques used in studying high-pressure transitions have been investigated. Experiments which place upper limits of about 20 GPa and about 50 GPa on pressures practically attainable using uniaxial supported opposed anvil devices with tungsten carbide pistons and uniaxial opposed flat anvil diamond devices, respectively, are reported. Direct static determinations of the transition pressures of GaP by two different methods are described. The values obtained indicate that the linear ruby scale increasingly overestimates the transition pressure as the pressure rises above 10 GPa. It is further shown that the use of shock-based marker materials, such as silver, as the basis of pressure measurement in X-ray diffraction studies leads to bulk moduli of cubic carbides which are in extreme disagreement with expected values.

Ruoff, A. L.↗

NASA NTRS1979

Transformation pressure of ZnS by a new primary pressure technique

An experiment designed to measure the transformation pressure of zinc sulfide by a primary pressure method using an indentor-anvil system made of single-crystal diamond is discussed. A nonsorting electrode-grid which can be applied directly to the anvil using optical lithography is described, together with the procedures used for positioning.

Ruoff, A. L.↗