Search NASA⌕ Search

Engineering topics

Rynaski, E. G.

Publications and source records attributed to Rynaski, E. G..

14 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1993

Theoretical constraints in the design of multivariable control systems

The theoretical constraints inherent in the design of multivariable control systems were defined and investigated. These constraints are manifested by the system transmission zeros that limit or bound the areas in which closed loop poles and individual transfer function zeros may be placed. These constraints were investigated primarily in the context of system decoupling or non-interaction. It was proven that decoupling requires the placement of closed loop poles at the system transmission zeros. Therefore, the system transmission zeros must be minimum phase to guarantee a stable decoupled system. Once decoupling has been accomplished, the remaining part of the system exhibits transmission zeros at infinity, so nearly complete design freedom is possible in terms of placing both poles and zeros of individual closed loop transfer functions. A general, dynamic inversion model following system architecture was developed that encompasses both the implicit and explicit configuration. Robustness properties are developed along with other attributes of this type of system. Finally, a direct design is developed for the longitudinal-vertical degrees of freedom of aircraft motion to show how a direct lift flap can be used to improve the pitch-heave maneuvering coordination for enhanced flying qualities.

Rynaski, E. G.↗
NASA NTRS1991

Theoretical constraints in the design of multivariable control systems

The research being performed under NASA Grant NAG1-1361 involves a more clear understanding and definition of the constraints involved in the pole-zero placement or assignment process for multiple input, multiple output systems. Complete state feedback to more than a single controller under conditions of complete controllability and observability is redundant if pole placement alone is the design objective. The additional feedback gains, above and beyond those required for pole placement can be used for eignevalue assignment or zero placement of individual closed loop transfer functions. Because both poles and zeros of individual closed loop transfer functions strongly affect the dynamic response to a pilot command input, the pole-zero placement problem is important. When fewer controllers than degrees of freedom of motion are available, complete design freedom is not possible, the transmission zeros constrain the regions of possible pole-zero placement. The effect of transmission zero constraints on the design possibilities, selection of transmission zeros and the avoidance of producing non-minimum phase transfer functions is the subject of the research being performed under this grant.

Rynaski, E. G.↗
NASA NTRS1986

The interpretation of flying qualities requirements for flight control design

The flying requirements of MIL-F-8785(C) are interpreted in terms of command/response configurations, and pilot preference for flight control systems configurations of angle of attack, or pitch rate command, specified independently for the short period and phugoid dynamics, is determined using the Total-In-Flight-Simulator aircraft. The results show that for either command configuration, the short term response applies to the angle of attack response of the vehicle, and that this response must satisfy the omega(n) vs n/alpha requirement. The preference in the long term for angle of attack command indicates that the pilot wants the aircraft to fly in the direction it is pointing, and an attitude hold system is not found to be preferred unless attitude hold results in flight path angle hold.

Rynaski, E. G.↗
NASA NTRS1985

The interpretation of flying qualities requirements for flight control system design

An experimental flight test program was designed for the Total In Flight Simulator (TIFS) directed toward the interface between flying qualities requirements and flight control system design criteria. The eventual goal is to provide an interpretation or translation of flying qualities requirements for use by the flight control system designer. Specifically, an angle of attack and pitch rate command system matrix involving both short term and long term dynamics are specified for evaluation. Flying qualities criteria and flight control system configuration or architecture can be independent was demonstrated. Finally, additional configurations are proposed to evaluate the efficacy of dynamic decoupling.

Rynaski, E. G.↗
NASA NTRS1982

Control concepts for the alleviation of windshears and gusts

Automatic control system design methods for gust and shear alleviation were studied. It is shown that automatic gust/shear alleviation systems can be quite effective if both throttle and elevator are used in harmony to produce the forces and moments required to counter the effects of the windshear. Regulation with respect to ground speed or airspeed results in very similar system designs. The application of the NASA total energy probe in the detection of windshear and criteria for alleviation is considered. The theory and application of robust output observers is extended. Design examples show how implementation of the control laws can be accomplished using observers, and thereby resulting in less complex control system configurations.

Rynaski, E. G.↗
NASA NTRS1980

Identification of flexible aircraft from flight data

This paper describes a frequency-domain method for the estimation of the aeroelastic equations of motion of an aircraft using discrete sinusoidal inputs to the control surface actuators. The theory of estimation of the signal inputs and outputs is described as well as the method of obtaining accurate transfer functions from the resulting Bode plots. Methods of quantifying the accuracy of the results from more than one control input are discussed along with ways to obtain state-space and reduced-order models from the transfer function estimates. Presented is a summary of the results obtained in using the technique to develop a model of the USAF Total In-Flight Simulator (TIFS) aircraft which includes five symmetrical elastic modes of motion of the aircraft.

Eulrich, B. J.↗
NASA NTRS1979

Gust alleviation using direct turbulence measurements

The research reported upon in this paper describes an effective method of gust alleviation using direct measurements of atmospheric turbulence to drive the aircraft control surfaces in a way that attempts to directly counter or cancel those forces and moments produced on the aircraft by gusts. The method yields a feedforward or open loop control law, simple to mechanize and relatively insensitive to changes in flight condition. When applied directly, the resulting control law effectively gust-alleviates in the low frequency phugoid and short period range but has a tendency to amplify structural mode vehicle motions due to the phase lag of the actuators. A method of design based upon the use of a diagonal or Jordan form of the equations of motion enables the designer to avoid this problem of structural mode excitation.

Rynaski, E. G.↗
NASA NTRS1979

Gust alleviation - Criteria and control laws

The relationships between criteria specified for aircraft gust alleviation and the form of the control laws that result from the criteria are considered. Open-loop gust alleviation based on the linearized, small perturbation equations of aircraft motion is discussed, and an approximate solution of the open-loop control law is presented for the case in which the number of degrees of freedom of the aircraft exceeds the rank of the control effectiveness matrix. Excessive actuator lag is compensated for by taking into account actuator dynamics in the equations of motion, resulting in the specification of a general load network. Criteria for gust alleviation when output motions are gust alleviated and the closed-loop control law derived from them are examined and linear optimal control law is derived. Comparisons of the control laws reveal that the effectiveness of an open-loop control law is greatest at low aircraft frequencies but deteriorates as the natural frequency of the actuators is approached, while closed-loop methods are found to be more effective at higher frequencies.

Rynaski, E. G.↗
NASA NTRS1978

Identification of the stability parameters of an aeroelastic airplane

The problem of the parameter identification of large scale dynamic systems involving a system matrix characterized by approximately 200 elements is addressed. By using phase variable transformations, a mathematical model of an aeroelastic airplane is described in a form that is amenable to partial or piecemeal acceptance of parameters estimated from flight data. A mathematical model of the U.S. Air Force Total In-Flight Simulator was computed using the FLEXSTAB digital computer program. As data became available during the progress of the flight test program, this data was processed and substituted in the mathematical model for parameters analytically obtained from the FLEXSTAB program. The results tend to show a progressive and orderly transition from an analytically defined mathematical model to one obtained from the flight tests of the actual aircraft.

Rynaski, E. G.↗
NASA NTRS1978

Identification of the stability parameters of an aeroelastic airplane

Phase variable transformations are used to construct the mathematical model of an aeroelastic aircraft in a form that is amenable to partial or piecemeal acceptance of parameters estimated from flight data. The problem is one of parameter identification of large scale dynamic systems involving a system matrix characterized by about 200 elements. A mathematical model of the USAF Total In-Flight Simulator was computed using the FLEXSTAB program. As data became available during the progress of the flight test program, it was processed and substituted in the mathematical model for parameters obtained from the FLEXSTAB program. Results tend to show a progressive and orderly transition from an analytically defined mathematical model to one obtained from the flight tests of the actual aircraft.

Rynaski, E. G.↗