Saffer, D. M. | Search NASA

DOE OSTI2023

The Role of Clay in Limiting Frictional Healing in Fault Gouges

Abstract Frictional healing is fundamental to the seismic cycle and plays a role in the energy balance, dynamics, and recurrence interval of earthquakes and slow slip events. Although the healing behavior of quartz has been studied extensively, the role of clay content is less understood. We tested synthetic mixtures of quartz and smectite (10%–100% smectite) in a double‐direct shear configuration to measure frictional healing. We show that the magnitude and rate of healing decreases systematically with higher clay content (from 0.008/decade at 10% smectite to 0.002/decade at 100% smectite). Healing scales with both the magnitude of stress relaxation during holds and layer‐normal compaction of the gouge. We suggest this reflects the alignment of clay minerals, leading to saturation of the real area of contact that limits restrengthening during holds. The low healing rates of clay‐rich faults—together with rate‐neutral to rate‐strengthening friction—should promote frequent, small failures or stable sliding.

58 GEOSCIENCES↗

DOE OSTI2022

Frictional Behavior Downdip Along the Subduction Megathrust: Insights From Laboratory Experiments on Exhumed Samples at In Situ Conditions

Subduction megathrusts exhibit a spectrum of slip modes, including catastrophic earthquakes. Although the mechanical and frictional properties of materials sampled from subduction zones have been studied extensively, few datasets have been collected for compositions and at pressure and temperature conditions representative of those in situ. The Nankai subduction zone in southwest Japan is a well-studied margin, and abundant data provide an opportunity to advance our understanding of fault and earthquake physics. Here, we use samples exhumed in the Shimanto and Sanbagawa Belts on Shikoku Island of southwest Japan that represent analogs for materials along the present-day megathrust at depths of ~5–>25 km, and we shear these at their peak in situ pressure-temperature (P-T) conditions. Effective normal stresses range from 28 to 192 MPa, and temperatures from 105°C to 470°C. We used pore fluid pressures of 45–240 MPa, corresponding to fluid overpressure ratios λ of 0.65 and 0.90. Slip velocities of 0.1–100 μm/s were used, in order to focus on the nucleation of instability and earthquakes. We found predominantly velocity-strengthening (inherently stable) behavior under all conditions for λ = 0.65. For λ = 0.90, velocity-weakening behavior was observed at 350°C, with velocity-strengthening behavior at lower and higher temperatures. The rate/state frictional stability parameter (a-b) increases with slip velocity at temperatures up to ~200°C and remains constant or decreases with slip velocity at higher temperatures. Altogether, our results demonstrate the potentially important roles of both temperature and slip velocity in controlling the distribution of stress and frictional rheology along subduction thrusts.

58 GEOSCIENCES↗