Engineering topics

Sakai, Yuki

Publications and source records attributed to Sakai, Yuki.

8 records

DOE OSTI2026

Structure-property relations of oP32-Ge under pressure

The unit-cell parameters, systematic absences, and atomic parameters of the germanium allotrope oP32-Ge show continuous changes up to 6 GPa as shown by single-crystal diffraction analysis. Peak shape and diffuse scattering features remain about unchanged throughout the experiment. Hence, neither the average nor the defect structure behavior offers a structure-property explanation for pressure-induced superconductivity observed at about 2 GPa [1]. Angle dispersive x-ray diffraction reveals a sluggish transformation of oP32-Ge to the Ge-II polymorph, the transition begins around 8 GPa and is complete at 12 GPa, a behavior similar to that of Ge-I. The reconstructive transition was associated with the breakdown of crystals into a powder that was compressed to 32 GPa. Synchrotron infrared absorption measurements up to 8.5 GPa indicate an increase of the band gap of the oP32-Ge prior to its collapse at 8.5 GPa. We suggest that the onset of superconductivity is not associated with a major structural change or that such a change occurs in specific stress and temperature conditions.

Lavina, Barbara↗

DOE OSTI2024

Significantly Promoting the Thermal Conductivity and Machinability of Negative Thermal Expansion Alloy via In Situ Precipitation of Copper Networks

Rapid advancements in electronic devices yield an urgent demand for high-performance electronic packaging materials with high thermal conductivity, low thermal expansion, and great mechanical properties. However, it is a great challenge for current design philosophies to fulfill all the requirements simultaneously. Here, an effective strategy is proposed for significantly promoting the thermal conductivity and machinability of negative thermal expansion alloy (Zr,Nb)Fe 2 through eutectic precipitation of copper networks. The eutectic dual-phase alloy exhibits an isotropic chips-matched thermal expansion coefficient and a thermal conductivity enhancement exceeding 200% compared with (Zr,Nb)Fe 2 , along with an ultimate compressive strength of 550 MPa. The addition of copper reorganizes the composition of (Zr,Nb)Fe 2 , which smooths the magnetic transition and shifts it toward higher temperature, resulting in linear low thermal expansion in a wide temperature range. The highly fine eutectic copper lamellae construct high thermal conductivity networks within (Zr,Nb)Fe 2 , serving as highways for heat transfer electrons and phonons. The in situ forming of eutectic copper lamellae also facilitates the mechanical properties by enhancing interfacial bonding and bearing additional stress after yielding of (Zr,Nb)Fe 2 . This work provides a novel strategy for promoting thermal conductivity and mechanical properties of negative thermal expansion alloys via eutectic precipitation of copper networks.

36 MATERIALS SCIENCE↗

DOE OSTI2024

Pressure-induced superconductivity in a novel germanium allotrope

High-pressure studies on elements play an essential role in superconductivity research, with implications for both fundamental science and applications. Here we report the experimental discovery of surprisingly low pressure driving a novel germanium allotrope into a superconducting state in comparison to that for α-Ge. Raman measurements revealed structural phase transitions and possible electronic topological transitions under pressure up to 58 GPa. Based on pressure-dependent resistivity measurements, superconductivity was induced above 2 GPa and the maximum T c of 6.8 K was observed under 4.6 GPa. Interestingly, a superconductivity enhancement was discovered during decompression, indicating the possibility of maintaining pressure-induced superconductivity at ambient pressure with better superconducting performance. Density functional theory analysis further suggested that the electronic structure of Ge (oP32) is sensitive to its detailed geometry and revealed that disorder in the β-tin structure leads to a higher T c in comparison to the perfect β-tin Ge.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

DOE OSTI2022

SrV 0.3 Fe 0.7 O 2.8 : A Vacancy-Ordered Fe-Based Perovskite Exhibiting Room-Temperature Magnetoresistance

We report room-temperature (RT) magnetoresistance (MR) in a novel Fe-based perovskite, SrV 0.3 Fe 0.7 O 2.8 . This compound contains ordered oxygen vacancies in every fifth primitive perovskite (111)p plane, leading to a layered structure consisting of triple-octahedral and double-tetrahedral layers. Along with the oxygen vacancies, the transition-metal ions are also ordered: the octahedral sites are occupied by 100% of Fe ions, while the tetrahedral sites are occupied by 25% of Fe ions and 75% of V ions. As a result, SrV 0.3 Fe 0.7 O 2.8 forms a magnetically striped lattice in which the octahedral layers with 100% of magnetic Fe ions are separated by the diluted magnetic layer. Finally, the compound exhibits weak ferromagnetism and shows a large negative MR (-5% at 3 T) at RT, despite the small saturation moment (0.4 μB/Fe atom). Thus, this type of layered compound is promising for further large MR by an increase of magnetization through chemical substitution.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2021

Observation of novel charge ordering and spin reorientation in perovskite oxide PbFeO 3

Pb M O 3 ( M = 3 d transition metals) family shows systematic variations in charge distribution and intriguing physical properties due to its delicate energy balance between Pb 6 s and transition metal 3 d orbitals. However, the detailed structure and physical properties of PbFeO 3 remain unclear. Herein, we reveal that PbFeO 3 crystallizes into an unusual 2 a p × 6 a p × 2 a p orthorhombic perovskite super unit cell with space group Cmcm . The distinctive crystal construction and valence distribution of Pb 2+ 0.5 Pb 4+ 0.5 FeO 3 lead to a long range charge ordering of the -A-B-B- type of the layers with two different oxidation states of Pb (Pb 2+ and Pb 4+ ) in them. A weak ferromagnetic transition with canted antiferromagnetic spins along the a -axis is found to occur at 600 K. In addition, decreasing the temperature causes a spin reorientation transition towards a collinear antiferromagnetic structure with spin moments along the b -axis near 418 K. Our theoretical investigations reveal that the peculiar charge ordering of Pb generates two Fe 3+ magnetic sublattices with competing anisotropic energies, giving rise to the spin reorientation at such a high critical temperature.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

DOE OSTI2020

Stabilized Charge, Spin, and Orbital Ordering by the 6s 2 Lone Pair in Bi 0.5 Pb 0.5 MnO 3

Bi and Pb ions with charge degree of freedom depending on 6s 2 and 6s 0 electronic configurations were combined with the Mn ion in a perovskite oxide. Comprehensive theoretical and experimental investigations revealed the Bi 3+ 0.5 Pb 2+ 0.5 Mn 3+ 0.5 Mn 4+ 0.5 O 3 charge ordered state with CE-type spin and dz 2 orbital orderings as observed in La 0.5 Ca 0.5 MnO 3 , Nd 0.5 Sr 0.5 MnO 3 , and Bi 0.5 Sr 0.5 MnO 3 . Finally, the charge and orbital orderings were preserved above 500 K owing to the stereochemical activity of Bi 3+ and Pb 2+ ions which stabilized the structural distortion.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2020

Chemical and steric effects in simulating noncontact atomic force microscopy images of organic molecules on a Cu (111) substrate

Noncontact mode of atomic force microscopy (nc-AFM) employing a CO-functionalized tip is a very powerful tool for studying molecular structures. However, interpreting nc-AFM images for nonplanar molecules can sometimes be problematic. To illustrate and resolve the nature of such problematic systems, we employ real-space pseudopotentials constructed within density functional theory to simulate nc-AFM images. In this work, we focus on several representative nonplanar organic molecules (pentacene, naphthanthrone, olympicene, and 6-phenylhexa-1,3,5-triynybenzene (PHTB)) on a typical substrate: the Cu (111) surface. This substrate results in significant distortions in the molecular geometries of pentacene and naphthanthrone. Including these distortions in simulated nc-AFM imaging notably improves the agreement between the simulated and measured images. In naphthanthrone, the relatively large interaction between the O atom and the Cu substrate offers a straightforward explanation for the absence of the C = O bond in the measured image. Nonplanar features such as tilting or twisting are also apparent in olympicene and PHTB. A “triangular” bright feature associated with the –CH 2 group in olympicene appears in simulated and measured nc-AFM images. This feature is directly related to the tilting angle of the molecule with respect to the Cu substrate. The “defective” benzene ring feature and the faint ellipsoidal C ≡ C feature in PHTB can be ascribed to its twisted nature. The ability to simulate such subatomic images in nc-AFM reflects the accuracy and efficiency of calculating quantum forces in real space.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

DOE OSTI2020

Heavy boron doping in superconducting carbon materials

Here we examine physical properties of heavily boron-doped sp 3 -hybridized carbon allotropes: cubic diamond, hexagonal diamond, and body centered tetragonal C 4 . The structural similarity between cubic diamond and hexagonal diamond leads to similar responses to substitutional boron doping. On the other hand, body centered tetragonal C 4 exhibits distinct structural and electronic properties because of its characteristic structure. Our study also shows that the superconducting transition temperatures up to 60 K are possible in heavily doped carbon materials despite their various atomistic structures.

36 MATERIALS SCIENCE↗