Search NASA⌕ Search

Engineering topics

Sandoval, Donald Leon

Publications and source records attributed to Sandoval, Donald Leon.

Analytic Method to Determine Angle Suitability

A method is presented for determining if the connector adaptor assembly (CAA) for a particular unit, as determined by Coordinate Measurement Machine (CMM), is suitable for use in an Alternate Configuration (AC).

42 ENGINEERING↗

Resolution of Tolerance Variations

The connector/adapter assembly (CAA) is one component of a higher-level assembly. A simplified representation of the CAA is illustrated in Figure 1. The location of each CAA is required to meet a specific positional requirement. Several CAAs have been measured and found to be out of tolerance. The connector and the adapter are welded to each other such that the cylindrical axes of the two components are coaxial. The positional tolerance condition requires that all points on the outer surface of the CAA must be within a defined maximum diameter, as illustrated in Figure 1. Two different methods have been developed to measure the CAA positions from coordinate measuring machine (CMM) data. One method (RevD) extrapolates the data from two circles approximately midway from the weld region to each end. The second method (RevF) measures points that are much closer to the actual ends.

42 ENGINEERING↗

CMM Sequential Analysis Program

This report documents a design agency (DA) method to evaluate coordinate measuring machine (CMM) data by constructing an algorithm that is equivalent to the production agency (PA) algorithm for processing the raw CMM data. Several refinements of the CMM analyses were implemented at both the PA and the DA to process inherent limitations of the raw data, such as the absence of measurements at the exact ends of the connector-adapter assembly (CAA) and the recovery from these limitations through (worst-case) adjustments to the the positional errors. Also, inherent errors of the CMM measurements were accommodated by introducing a guard band, which effectively lowered the tolerance so that the CMM code could not pass bad parts. The DA and the PA showed remarkable agreement in all areas of analysis. The ultimate comparison is shown in Figures 13a and 13b, where the effect of using a guard band and end adjustments to the CMM measurements were clearly shown.

42 ENGINEERING↗

A Method for Extrapolating CMM Data

This report provides a method for evaluating coordinate measuring machine (CMM) data and extrapolating the data to estimate the dimensions of a cylindrical component beyond the sampled measurements. The theoretical basis is provided, and a calculational method is presented. The report also provides detailed, formatted, printed, and plotted representations.

36 MATERIALS SCIENCE↗

Shock and Release Response of Unreacted Epon 828: Shot 2s-905

This document summarizes the shock and release response of Epon 828 measured in the dynamic impact experiment 2s-905. Experimentally, a thin Kel-F impactor backed by a low impedance foam impacted an Epon 828 target with embedded electromagnetic gauges. Computationally, a one dimensional simulation of the impact event was performed, and tracer particles were located at the corresponding electromagnetic gauge locations. The experimental configuration was such that the Epon 828 target was initially shocked, and then allowed to release from the high-pressure state. Comparisons of the experimental gauge and computational tracer data were made to assess the performance of equation of state (EOS) 7603, a SESAME EOS for Epon 828, on and off the principal shock Hugoniot. Results indicate that while EOS 7603 can capture the Hugoniot response to better that 1%, while the sound speeds at pressure are under-predicted by 6 - 7%.

45 MILITARY TECHNOLOGY, WEAPONRY, AND NATIONAL DEF↗