Engineering topics

Saray, Mahmoud Tamadoni

Publications and source records attributed to Saray, Mahmoud Tamadoni.

6 records

DOE OSTI2023

A room temperature rechargeable Li 2 O-based lithium-air battery enabled by a solid electrolyte

Lithium-air batteries have scope to compete with gasoline in terms of energy density. However, in most systems, the reaction pathways either involve one- or two-electron transfer, leading to lithium peroxide (Li 2 O 2 ) or lithium superoxide (LiO 2 ), respectively. Kondori et al. investigated a lithium-air battery that uses a ceramic-polyethylene oxide–based composite solid electrolyte and found that it can undergo a four-electron redox reaction through lithium oxide (Li 2 O) formation and decomposition (see the Perspective by Dong and Lu). The composite electrolyte embedded with Li 10 GeP 2 S 12 nanoparticles shows high ionic conductivity and stability and high cycle stability through a four-electron transfer process.

25 ENERGY STORAGE↗

DOE OSTI2022

Understanding intercalation chemistry for sustainable aqueous zinc–manganese dioxide batteries

Rechargeable aqueous Zn-MnO 2 technology combines one of the oldest battery chemistries with favourable sustainability characteristics, including safety, cost and environmental compatibility. However, the ambiguous charge storage mechanism presents a challenge to fulfil the great potential of this energy technology. In this work, we leverage on advanced electron microscopy, electrochemical analysis and theoretical calculations to look into the intercalation chemistry within the cathode material, or α-MnO 2 more specifically. We show that Zn 2+ insertion into the cathode is unlikely in the aqueous system; rather, the charge storage process is dominated by proton intercalation to form α-H x MnO 2 . We further reveal anisotropic lattice change as a result of entering protons proceeding from the surface into the bulk of α-MnO 2 , which accounts for the structural failure and capacity decay of the electrode upon cycling. Our work not only advances the fundamental understanding of rechargeable zinc batteries but also suggests the possibility to optimize proton intercalation kinetics for better-performing cell designs. A rechargeable aqueous Zn-MnO 2 battery features a combination of favourable sustainability characteristics from safety to cost. The authors deploy advanced characterizations and theoretical calculations to provide fresh insight into the charge storage mechanism, which not only closes an ongoing debate but suggests ways forward.

25 ENERGY STORAGE↗

DOE OSTI2022

Efficient electrocatalytic conversion of CO 2 to ethanol enabled by imidazolium-functionalized ionomer confined molybdenum phosphide

An effective electrochemical carbon dioxide reduction reaction (eCO 2 RR) requires the discovery of a catalytic system that is highly active and selective for multi-carbon products together with superior CO 2 diffusion at a catalyst layer to minimize the reduction barriers. Here, we found a catalytic system that uses molybdenum phosphide (MoP) nanoparticles covered by imidazolium-functionalized ionomer (Im) that promotes CO 2 diffusion at the catalyst layer toward the catalyst surface, where CO 2 is reduced to ethanol (C 2 H 5 OH). The electrochemical results with the MoP-Im co-catalyst show a C 2 H 5 OH production Faradaic efficiency and a cathodic energy efficiency of 77.4% and 63.3%, respectively, at a potential as low as - 200 mV vs. RHE. The electrochemical experiments along with our physicochemical characterizations indicate that the Im improves CO 2 diffusion and balances water content resulting in a higher CO 2 -to-water ratio at the catalyst layer and fine-tunes the electronic properties of Mo atoms at the MoP surface. Finally, in-situ Raman spectroscopy reveals that a high number of adsorbed *CO intermediates on the surface and a higher binding strength of *CO intermediates on the Mo surface sites in the presence of imidazolium molecules are the main reasons for a superior C-C coupling and thereby the improved C 2 H 5 OH formation.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2022

Critical Barriers to Successful Implementation of Earth-Abundant, Mn-Rich Cathodes for Vehicle Applications and Beyond: The Effect of Particle Morphology

As the search for improved and next-generation cathodes continues, it is clear that a deeper understanding of synthesis–structure–electrochemical property relationships is of critical importance. The effects of primary and secondary particle morphologies on various transition metal oxides have been studied, but new findings are still being reported. To date, few studies have focused on the effects of particle morphologies on Li- and Mn-rich oxides (>50% Mn) and even fewer studies have focused on the influence over key properties such as electrode-level impedance. In this study, we report the effects of particle morphologies on the area-specific-impedance (ASI) and thermal behavior of Li- and Mn-rich oxides. Samples with a fixed, layered–layered–spinel (LLS), composition were synthesized with differing primary morphologies and tested under standardized, full-cell protocols. The results suggest that smaller primary particle size (i.e., higher surface area) leads to lower overall ASI, a delay in the increasing impedance at low states-of-charge (SOCs), and surprisingly, improved thermal behavior.

33 ADVANCED PROPULSION SYSTEMS↗

DOE OSTI2021

Critical Barriers to Successful Implementation of Earth-Abundant, Mn-Rich Cathodes for Vehicle Applications and Beyond: A Detailed Study of Low SOC Impedance

We report that earth-abundant, sustainable cathode chemistries based on Mn are increasingly attractive for enabling a broader portfolio of cathode oxides. The well-known class of lithium- and manganese-rich cathodes still represents very viable options. However, despite the important work on understanding the mechanisms of voltage fade, hysteresis, and oxygen activity, relatively little attention has been given to understanding the impedance characteristics of these electrodes. In particular, an anomalous rise in area specific impedance at lower states of charge, as well as overall impedance rise and surface damage due to electrolyte interactions, represent critical barriers to implementation. This work presents a comprehensive study of impedance behavior in cobalt-free, lithium- and manganese-rich electrodes. The use of a robust surface treatment allows for long-term behavior to be probed in the absence of surface damage, capacity loss, and impedance rise due to electrolyte interactions. The anomalous rise in impedance could not be correlated to surface changes, or surface phase formation, but could be directly correlated with the bulk processes of voltage fade and voltage hysteresis. The activated material can be explained as a percolating network of higher-voltage, layered-type sites having facile Li diffusion. Interspersed throughout this network are lower-voltage, disordered sites that represent a significant barrier.

25 ENERGY STORAGE↗

DOE OSTI2020

Kinetically Stable Oxide Overlayers on Mo 3 P Nanoparticles Enabling Lithium–Air Batteries with Low Overpotentials and Long Cycle Life

The main drawbacks of today's state-of-the-art lithium–air (Li–air) batteries are their low energy efficiency and limited cycle life due to the lack of earth-abundant cathode catalysts that can drive both oxygen reduction and evolution reactions (ORR and OER) at high rates at thermodynamic potentials. Here, inexpensive trimolybdenum phosphide (Mo 3 P) nanoparticles with an exceptional activity—ORR and OER current densities of 7.21 and 6.85 mA cm –2 at 2.0 and 4.2 V versus Li/Li + , respectively—in an oxygen-saturated non-aqueous electrolyte are reported. The Tafel plots indicate remarkably low charge transfer resistance—Tafel slopes of 35 and 38 mV dec –1 for ORR and OER, respectively—resulting in the lowest ORR overpotential of 4.0 mV and OER overpotential of 5.1 mV reported to date. Using this catalyst, a Li–air battery cell with low discharge and charge overpotentials of 80 and 270 mV, respectively, and high energy efficiency of 90.2% in the first cycle is demonstrated. Furthermore, a long cycle life of 1200 is also achieved for this cell. Density functional theory calculations of ORR and OER on Mo 3 P (110) reveal that an oxide overlayer formed on the surface gives rise to the observed high ORR and OER electrocatalytic activity and small discharge/charge overpotentials.

25 ENERGY STORAGE↗