Search NASA⌕ Search

Engineering topics

Sartori, R

Publications and source records attributed to Sartori, R.

Progress Testing TRANSP-TORIC Simulations of ICRH in JE

Introduction - Ion Cyclotron Range of Frequency (ICRF) waves are candidates for heating (ICRH), current drive, and possible flow drive in ITER and future tokamaks. There are considerable challenges developing the technology of ICRF systems and the tools for assessing effects on plasma performance. These tools are important both for guiding present experiments and for indicating efforts for future research. This paper addresses some of the tools for simulating ICRH. The TORIC ICRF full-wave code [1] solves the kinetic wave equation in 2D axisymmetric equilibria. TORIC solves Maxwell's Equations for a fixed wave frequency with a linear plasma response in a mixed spectral-finite element basis. The antenna is modelled as a sheet current. A kinetic model for the plasma dielectric response is derived using an Eikonal ansatz.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Progress on the heating and current drive systems for ITER

The electron cyclotron (EC), ion cyclotron (IC), heating-neutral beam (H-NB) and, although not in the day 1 baseline, lower hybrid (LH) systems intended for ITER have been reviewed in 2007/2008 in light of progress of physics and technology in the field. Although the overall specifications are unchanged, notable changes have been approved. Firstly, it has been emphasized that the H&CD systems are vital for the ITER programme. Consequently, the full 73 MW should be commissioned and available on a routine basis before the D/T phase. Secondly, significant changes have been approved at system level, most notably: the possibility to operate the heating beams at full power during the hydrogen phase requiring new shine through protection; the possibility to operate IC with 2 antennas with increased robustness (no moving parts); the possible increase to 2 MW of key components of the EC transmission systems in order to provide an easier upgrading of the EC power as may be required by the project; the addition of a building dedicated to the RF power sources and to a testing facility for acceptance of diagnostics and heating port plugs. Thirdly, the need of a plan for developing, in time for the active phase, a CD system such as LH suitable for very long pulse operation of ITER was recognised. The review describes these changes and their rationale.

08 HYDROGEN↗

H-mode access on JET and Implications for ITER

One of the critical issues for ITER is access to an H-mode regime with good confinement, H98 = 1. The most basic scaling laws for power threshold for the L H transition, Pth, take the variation with plasma density, magnetic field and plasma size into account. However, the large variations in the Pth data from the values estimated with such simple scaling laws indicate other underlying dependencies. Another important consideration for ITER is that H-modes with higher values of energy confinement factors are often obtained with input power values much greater than Pth. This paper presents results from recent studies on JET to assess possible hidden variables for H-mode access over a wide range of plasma conditions. Experimental results demonstrate that sensitivity to the magnetic shaping and divertor geometry could account for some of the scatter in the international power threshold database. Hysteresis in the L H transition Pth has been studied in detail for the first time on JET by comparing values of Pth at the forward and back H-mode transitions over a range of densities. The impact of the edge plasma rotation on H-mode access has also been considered on JET with a toroidal field ripple scan across the L H and H L transitions. Finally, the total input power required relative to the measured value of Pth for access to a steady-state H-mode with H98 = 1 has been examined for a highly shaped magnetic configuration. The implications of these results for the attainment of H-mode with good confinement on ITER are discussed.

plasma h-mode↗