Search NASA⌕ Search

Engineering topics

Saunier, Paul

Publications and source records attributed to Saunier, Paul.

K-Band Power Enbedded Transmission Line (ETL) MMIC Amplifiers for Satellite Communication Applications

The design, fabrication, and performance of K-band high-efficiency, linear power pHEMT amplifiers implemented in Embedded Transmission Line (ETL) MMIC configuration with unthinned GaAs substrate and topside grounding are reported. A three-stage amplifier achieved a power-added efficiency of 40.5% with 264 mW output at 20.2 GHz. The linear gain is 28.5 dB with 1-dB gain compression output power of 200 mW and 31% power-added efficiency. The carrier-to-third-order intermodulation ratio is approx. 20 dBc at the 1-dB compression point. A RF functional yield of more than 90% has been achieved.

Tserng, Hua-Quen↗

Ka-Band GaAs FET Monolithic Power Amplifier Development

Over the course of this program, very extensive progress was made in Ka-band GaAs technology. At the beginning of the program, odd-shaped VPE MESFET wafers were used. A breakthrough in power and efficiency was achieved with highly doped (8 x 10(exp 17) cm(exp -3) MBE grown MESFET material. We obtained power of 112 mW with 16 dB gain and 21.6% efficiency at 34 GHz with a monolithic 50-100-250 micron amplifier. The next breakthrough came with the use of heterostructures grown by MBE (AlGaAs/InGaAs where the InGaAs is highly doped). This allowed us to achieve high power density with high efficiency. A benchmark 40% efficiency was achieved with a single-stage 100 micron MMIC at 32.5 GHz. The corresponding three-stage 50-100-250 micron amplifier achieved 180 mW with 23 dB gain and 30.3% efficiency. The next breakthrough came with 3-inch MBE grown PHEMT wafers incorporating an etch-stop layer for the gate recess (using RIE). Again, state-of-the-art performances were achieved: 40% efficiency with 235 mW output power and 20.7 dB gain. The single-stage 2 x 600 micron chip demonstrated 794 mW output power with 5 dB gain and 38.2% power-added efficiency (PAE). The Ka-band technology developed under this program has promise for extensive use: JPL demonstrated 32 GHz phased arrays with a three-stage amplifier developed under this contract. A variation of the three-stage amplifier was used successfully in a 4 x 4 phased array transmitter developed under another NASA contract.

Saunier, Paul↗

Monolithic Three-Stage 32-GHz Power Amplifier

Monolithic three-stage 32-GHz power amplifier compact and offers state-of-the-art performance. Operates at frequencies around 32 GHz. Designed for use aboard communication satellite and is also suitable for terrestrial applications in which moderate power and high efficiency needed.

Saunier, Paul↗

A high efficiency Ka-band monolithic pseudomorphic HEMT amplifier

A monolithic three-stage Ka-band amplifier has been designed and fabricated on a doped channel heterostructure. Devices with gate length of 0.2 micron and gate width of 50, 100, and 250 micron were cascaded. The gate and drain bias networks were also integrated. The small signal gain is 31 dB and the amplifier is capable of an output power of 190 mW with 23 dB gain and 30.2 percent power added efficiency at 31 GHz. This is a record efficiency for a multistage MMIC at this frequency.

Saunier, Paul↗

AlGaAs/InGaAs heterostructures with doped channels for discrete devices and monolithic amplifiers

AlGaAs/InGaAs/GaAs-type heterostructure with one or two doped channels have been used to fabricate both discrete devices and monolithic amplifiers for millimeter-wave operation. Maximum current densities of 1 A/mm and maximum transconductances of 530 mS/mm were obtained. 0.25 x 50 micron discrete devices delivered a power density of 1 W/mm with 2.9-dB gain and 25 percent efficiency at 60 GHz. A 100-micron monolithic one-stage amplifier demonstrated 93 mW (0.93-W/mm power density) at 31.5 GHz with 4.2-dB gain and 29 percent efficiency. A record 34 percent efficiency was achieved with a 53.7-mW output power and 4.8-dB gain.

Saunier, Paul↗

Ku-band high efficiency GaAs MMIC power amplifiers

The development of Ku-band high efficiency GaAs MMIC power amplifiers is examined. Three amplifier modules operating over the 13 to 15 GHz frequency range are to be developed. The first MMIC is a 1 W variable power amplifier (VPA) with 35 percent efficiency. On-chip digital gain control is to be provided. The second MMIC is a medium power amplifier (MPA) with an output power goal of 1 W and 40 percent power-added efficiency. The third MMIC is a high power amplifier (HPA) with 4 W output power goal and 40 percent power-added efficiency. An output power of 0.36 W/mm with 49 percent efficiency was obtained on an ion implanted single gate MESFET at 15 GHz. On a dual gate MESFET, an output power of 0.42 W/mm with 27 percent efficiency was obtained. A mask set was designed that includes single stage, two stage, and three stage single gate amplifiers. A single stage 600 micron amplifier produced 0.4 W/mm output power with 40 percent efficiency at 14 GHz. A four stage dual gate amplifier generated 500 mW of output power with 20 dB gain at 17 GHz. A four-bit digital-to-analog converter was designed and fabricated which has an output swing of -3 V to +/- 1 V.

Tserng, H. Q.↗