Engineering topics

Schaubert, Daniel H.

Publications and source records attributed to Schaubert, Daniel H..

4 records

NASA NTRS1998

A Dual-Band Dual-Polarized Array for Spaceborne SAR

Future synthetic aperture radar antennas will be significantly more sophisticated than their earlier counterparts, requiring enhanced electrical capabilities such as operation at multiple frequencies with multiple polarization ability, as well as desirable non-electrical features such as light weight, easy and reliable deployability, and low cost. The present paper describes the results of a prototype SAR array developed with these considerations in mind. This paper will describe the development of a dual-frequency array operating at L and C bands, with dual linear polarization capability at both bands. Unlike most earlier dual-band arrays, this array shares the same radiating aperture for both bands and both polarizations, resulting the smallest possible aperture area for a given gain specification. A critical constraint in this project was a requirement for an extremely light weight package, leading to the use of foam substrates with thin dielectric membranes for metalizations of the radiating elements and feed networks.

Pozar, David M.↗

NASA NTRS1991

Development of theoretical models of integrated millimeter wave antennas

Extensive radiation patterns for Linear Tapered Slot Antenna (LTSA) Single Elements are presented. The directivity of LTSA elements is predicted correctly by taking the cross polarized pattern into account. A moment method program predicts radiation patterns for air LTSAs with excellent agreement with experimental data. A moment method program was also developed for the task LTSA Array Modeling. Computations performed with this program are in excellent agreement with published results for dipole and monopole arrays, and with waveguide simulator experiments, for more complicated structures. Empirical modeling of LTSA arrays demonstrated that the maximum theoretical element gain can be obtained. Formulations were also developed for calculating the aperture efficiency of LTSA arrays used in reflector systems. It was shown that LTSA arrays used in multibeam systems have a considerable advantage in terms of higher packing density, compared with waveguide feeds. Conversion loss of 10 dB was demonstrated at 35 GHz.

Yngvesson, K. Sigfrid↗

NASA NTRS1987

Analysis of the tapered slot antenna

A method for calculating the radiation pattern of end-fire tapered slot antennas with or without dielectric substrate is presented. The method involves a two-step procedure: (1) determine the field distribution of a traveling wave along the tapered slot, and (2) compute the radiation from this slot field by using the half-plane Green's function to account for termination effects. Acceptable estimates of the slot field usually can be obtained from a stepped approximation to the tapered geometry. The method has been verified by comparisons to measured patterns for various dielectric substrates and antenna dimensions. However, the effect of lateral truncation has not yet been successfully modeled. Experimental patterns showing this effect are presented.

Janaswamy, Ramakrishna↗

NASA NTRS1986

Near millimeter wave imaging/multi-beam integrated antennas

Some preliminary results on a mixer design which is suitable for integration with tapered slot antennas have been obtained and published. This mixer design was tested both in a 4 to 10 GHz model, and (slightly modified) at 94 GHz. The latter utilized the same Hewlett-Packard beam-lead diodes which were used as detector diodes in the linearly tapered slot antennas (LTSA) arrays. These diodes are the most rugged to be found, and generally survive well on the flexible Kapton substrates. The 4 to 10 GHz version of this mixer has less than 6 dB conversion loss over an octave bandwidth. It uses a slot ring in a balanced configuration, and requires the LO to be fed through a separate port. A different design for a mixer which may be integrated with an LTSA antenna element is discussed. This mixer was tested at 38 GHz with the same HP beam-lead diodes, and has less than 10 dB conversion loss. Further work on mixers has emphasized theoretical modeling, using a computer program, which takes into account the effect of excess noise of Schottky-barrier diodes for the first time. Calculated results agree quantitatively with measured results on millimeter wave mixers.

Yngvesson, K. Sigfrid↗