Engineering topics

Scheinberg, N.

Publications and source records attributed to Scheinberg, N..

5 records

NASA NTRS1981

A modified adaptive delta modulator

This paper presents the results of a study in data compression of adaptive delta modulated video signals. The Song mode ADM is first investigated at a sampling rate of 16 Mbits/s and shown not to produce enough redundancy to warrant entropy encoding. A modified adaptive delta modulator algorithm is presented that operates at a sampling rate of 16 Mbits/s and does produce sufficient redundancy to yield a 40-50 percent data compression by using a simple code on 4 bit data blocks. Other techniques such as field interpolation and direct substitution are shown to increase the possible data compression further without noticeable degradation in the two input images used in this investigation. The effects of channel errors in the transmission of packet video over a computer network are considered. A leaky integrator is used to reduce the effects of channel errors in the data bits. It is shown that the effects of channel errors can be reduced by field interpolating those packets that can be shown to contain errors.

Barba, J.↗

NASA NTRS1981

Entropy encoding applied to a video DM bit stream

This paper investigates bandwidth compression of delta modulated video signals using a variety of novel techniques. The video signal is encoded at 16 MHz with an adaptive delta modulator (ADM) using the Song video mode algorithm. One method of achieving bandwidth compression is through the detection and reduction of steady state patterns in the DM bit stream. Further reduction is obtained by deleting the horizontal and vertical drive information. Finally, a modified ADM algorithm is introduced to increase the frequency of steady state patterns. When the modified ADM is combined with entropy coding a 30-50% data compression can be realized.

Barba, J.↗

NASA NTRS1978

Video encoding using adaptive delta modulation

Research work is described that was carried out to develop adaptive delta modulators (ADM) capable of encoding black-and-white and color video signals in the presence of high bit error rates. These were a one-dimensional ADM capable of encoding black-and-white pictures and transmitting digitally encoded voice without increase in bandwidth; an ADM capable of encoding color video signals; and an ADM capable of encoding field-sequential color. For each of these three units, the bit rate could be adjusted within the range from 6 to 24 Mbits/sec. The effects of the bit rate and channel errors on the response of the picture are examined.

Schilling, D. L.↗

NASA NTRS1977

Adaptive delta modulation systems for video encoding

This paper describes several adaptive delta modulators designed to encode video signals. One- and two-dimensional ADM algorithms are discussed and compared. Results are shown for bit rates of 2 bits/pixel, 1 bit/pixel and 0.5 bits/pixel. Pictures showing the difference between the encoded-decoded pictures and the original pictures are presented. Results are also presented to illustrate the effect of channel errors on the reconstructed picture. A two-dimensional ADM using interframe encoding is also presented. This system operates at the rate of 2 bits/pixel and produces excellent quality pictures when there is little motion. We also describe and illustrate the effect of large amounts of motion on the reconstructed picture.

Lei, T.-L. R.↗

NASA NTRS1976

Techniques for correcting transmission errors in video adaptive delta modulation channels

We investigated the effects of channel errors on an adaptive delta modulator used to encode video signals. The investigation revealed that channel errors caused a permanent shift in the dc level of the delta modulator's estimate. Errors in the step size, on the other hand, were transitory and had no noticeable effect on the received pictures. We then presented three error correction schemes to minimize the visibility of the channel errors in the received picture. The first scheme required the transmitter to periodically send the correct dc level of the estimate to the receiver. The second method employed a leaky integrator, and the third method used line-to-line interpolation

Scheinberg, N.↗