Search NASA⌕ Search

Engineering topics

Scherrer, Richard

Publications and source records attributed to Scherrer, Richard.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1961

Investigation of an Axisymmetric Internal Compression Inlet at a Mach Number of About 3.8

An idealized axisymmetric, all-internal compression inlet was designed for a Mach number of 3.75. The objective of the design was to obtain a steady, one-dimensional transonic flow and a high over-all total pressure recovery. Boundary-layer removal was employed in the vicinity of the inflection point of the supersonic contour. Static and total-pressure fluctuations were measured in the transonic flow region. A total pressure recovery of about 90 percent was obtained with a boundary-layer-removal mass flow rate of 15 percent of the inlet mass flow rate. The accompanying root-mean-square total pressure fluctuation in the throat region was only 1 percent of the free stream total pressure. The test Mach number was 3.80 and the Reynolds number based on inlet diameter was 2.63 x 10(exp 6).

Lundell, John H.↗
NASA NTRS1951

Damping in a Roll of a Missile Configuration with a Modified Triangular Wing and a Cruciform Tail at a Mach Number of 1.52

The damping-in-Toll stability derivatives of a missile configuration and its components were determined both experimentally and theoretically. The tests were conducted at a Mach number of 1.52 and at a Reynolds number, based on the mean aerodynamic chord of the wing, of 0.82 x 10(exp 6). The experimental damping derivative of the wing-body combination was 67 percent of the theoretical value. The difference is believed to have resulted mainly from the fact that the theory is not strictly applicable when the Mach number normal to the leading edge is almost unity, which was the case in the present investigation. For the tail-body combination the damping derivative was 86 percent of the theoretical value. In this case, the difference is believed to have been caused partially by mutual interference between the tail surfaces and partially by the low Reynolds number of the flow over the tail. It was found that the damping of the complete configuration was not equal to the sum of the damping derivatives of the components because of the effect of the wing downwash on the damping of the tail.

Scherrer, Richard↗
NASA NTRS1951

Comparison of Theoretical and Experimental Heat-Transfer Characteristics of Bodies of Revolution at Supersonic Speeds

An investigation of the three important factors that determine convective heat-transfer characteristics at supersonic speeds, location boundary-layer transition, recovery factor, and heat-transfer parameter has been performed at Mach numbers from 1.49 to 1.18. The bodies of revolution that were tested had, in most cases, laminar boundary layers, and the test results have been compared with available theory. Boundary-layer transition was found to be affected by heat transfer. Adding heat to a laminar boundary layer caused transition to move forward on the test body, while removing heat caused transition to move rearward. These experimental results and the implications of boundary-layer-stability theory are in qualitative agreement.

Scherrer, Richard↗
NASA NTRS1949

Heat-transfer and Boundary-layer Transition on a Heated 20 Degree Cone at a Mach Number of 1.53

Heat-transfer data from supersonic wind-tunnel tests of a heated 20 degree cone are compared with theoretical results obtained by the method for determining the convective heat transfer in laminar boundary layers in a compressible fluid developed by Hantzche and Wendt and with the method presented in NACA TN No. 1300. The experimental data are also compared with the results obtained by Eber at the Kochel Laboratory in Germany and it is found that Eber's results correspond to those obtained with a turbulent boundary layer on the cone. The results provide a qualitative verification of the effect of heat transfer on laminar boundary-layer stability that has been predicted theoretically by Lees in NACA TN No. 1360.

FLOW, TURBULENT↗