Search NASA⌕ Search

Engineering topics

Schiff, L. B.

Publications and source records attributed to Schiff, L. B..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1993

Lateral control at high angles of attack using pneumatic blowing through a chined forebody

Directional control through the use of pneumatic blowing was investigated on a generic subscale model with a chined forebody with blowing through a chine slot in a direction normal to the forebody surface. Comparisons are made with a vertical tail on and off, and with control through rudder deflection. Force and moment data were obtained for various blowing coefficients over a 0-75 deg alpha range, and flow visualization was also conducted in order to see qualitative effects on the flowfield. Blowing through a chined forebody generates yaw moments at large alpha where control surfaces lose their effectiveness; these moments are much larger than obtained by jet thrust alone, since the forebody flowfield is modified through the interaction of the jet with the chine vortices. Directional control increased with angle of attack for a given blowing coefficient until a maximum was reached. Further increases in angle of attack results in a rapid loss of effectiveness. For angles of attack above 60 deg, yaw moments are generated by simple jet thrust effect. The effectiveness of the pneumatic system depended on tail configuration.

Arena, A. S., Jr.↗
NASA NTRS1990

An experimental study of the nonlinear dynamic phenomenon known as wing rock

An experimental investigation into the physical phenomena associated with limit cycle wing rock on slender delta wings has been conducted. The model used was a slender flat plate delta wing with 80-deg leading edge sweep. The investigation concentrated on three main areas: motion characteristics obtained from time history plots, static and dynamic flow visualization of vortex position, and static and dynamic flow visualization of vortex breakdown. The flow visualization studies are correlated with model motion to determine the relationship between vortex position and vortex breakdown with the dynamic rolling moments. Dynamic roll moment coefficient curves reveal rate-dependent hysteresis, which drives the motion. Vortex position correlated with time and model motion show a time lag in the normal position of the upward moving wing vortex. This time lag may be the mechanism responsible for the hysteresis. Vortex breakdown is shown to have a damping effect on the motion.

Arena, A. S., Jr.↗
NASA NTRS1986

Computation of turbulent supersonic flows around pointed bodies having crossflow separation

The numerical method developed by Schiff and Sturek (1980) on the basis of the thin-layer parabolized Navier-Stokes equations of Schiff and Steger (1980) is extended to the case of turbulent supersonic flows on pointed bodies at high angles of attack. The governing equations, the numerical scheme, and modifications to the algebraic eddy-viscosity turbulence model are described; and results for three cones and one ogive-cylinder body (obtained using grids of 50 nonuniformly spaced points in the radial direction between the body and the outer boundary) are presented graphically and compared with published experimental data. The grids employed are found to provide sufficient spatial resolution of the leeward-side vortices; when combined with the modified turbulence model, they are shown to permit accurate treatment of flows with large regions of crossflow separation.

Degani, D.↗
NASA NTRS1986

Visualization and flow surveys of the leading edge vortex structure on delta wing planforms

In the present experimental investigation of thin delta wing vortex breakdown, for the cases of sweep angles of 70, 75, 80, and 85 deg, and smoke flow visualization/laser light sheet technique is used to obtain cross sectional views of the leading edge vortices as they break down. A combination of lateral and longitudinal cross sectional views furnishes data on the three-dimensional character of the vortex before, during, and after breakdown. Velocity measurements conducted with a laser Doppler anemometer on the 70 deg sweep delta, at 30 deg angle-of-attack, indicate that when breakdown occurs the core flow is transformed from a jet-like to a wake-like flow.

Payne, F. M.↗
NASA NTRS1986

Numerical simulation of unsteady, viscous, high-angle-of-attack flows using a partially flux-split algorithm

Viscous separated flow surrounding a hemisphere-cylinder body at angles of attack ranging up to 19 deg in transonic flow has been computed using an implicit, approximately-factored, partially flux-split algorithm. The resulting flowfield structures, including the vortical flow on the leeward side of the body and the three-dimensional separation patterns, have been investigated. The computed results show good qualitative and quantitative agreement with experimental data. Furthermore, visualization of the flowfield patterns has yielded insight into the behavior of the three-dimensional separated flow.

Ying, S. X.↗
NASA NTRS1985

Recent developments in rotary-balance testing of fighter aircraft configurations at NASA Ames Research Center

Two rotary balance apparatuses were developed for testing airplane models in a coning motion. A large scale apparatus, developed for use in the 12-foot Pressure Wind Tunnel primarily to permit testing at high Reynolds numbers, was recently used to investigate the aerodynamics of 0.05-scale model of the F-15 fighter aircraft. Effects of Reynolds number, spin rate parameter, model attitude, presence of a nose boom, and model/sting mounting angle were investigated. A smaller apparatus, which investigates the aerodynamics of bodies of revolution in a coning motion, was used in the 6-by-6 foot Supersonic Wind Tunnel to investigate the aerodynamic behavior of a simple representation of a modern fighter, the Standard Dynamic Model (SDM). Effects of spin rate parameter and model attitude were investigated. A description of the two rigs and a discussion of some of the results obtained in the respective tests are presented.

Malcolm, G. N.↗
NASA NTRS1985

Application of CFD techniques toward the validation of nonlinear aerodynamic models

Applications of computational fluid dynamics (CFD) methods to determine the regimes of applicability of nonlinear models describing the unsteady aerodynamic responses to aircraft flight motions are described. The potential advantages of computational methods over experimental methods are discussed and the concepts underlying mathematical modeling are reviewed. The economic and conceptual advantages of the modeling procedure over coupled, simultaneous solutions of the gas dynamic equations and the vehicle's kinematic equations of motion are discussed. The modeling approach, when valid, eliminates the need for costly repetitive computation of flow field solutions. For the test cases considered, the aerodynamic modeling approach is shown to be valid.

Schiff, L. B.↗
NASA NTRS1985

Recent developments in rotary-balance testing of fighter aircraft configurations at NASA Ames Research Center

Two rotary balance apparatuses were developed for testing airplane models in a coning motion. A large scale apparatus, developed for use in the 12-Foot Pressure Wind tunnel primarily to permit testing at high Reynolds numbers, was recently used to investigate the aerodynamics of 0.05-scale model of the F-15 fighter aircraft. Effects of Reynolds number, spin rate parameter, model attitude, presence of a nose boom, and model/sting mounting angle were investigated. A smaller apparatus, which investigates the aerodynamics of bodies of revolution in a coning motion, was used in the 6-by-6 foot Supersonic Wind Tunnel to investigate the aerodynamic behavior of a simple representation of a modern fighter, the Standard Dynamic Model (SDM). Effects of spin rate parameter and model attitude were investigated. A description of the two rigs and a discussion of some of the results obtained in the respective test are presented.

Malcolm, G. N.↗
NASA NTRS1985

Aerodynamic characteristics of the standard dynamics model in coning motion at Mach 0.6

A wind tunnel test was conducted on the Standard Dynamics Model (a simplified generic fighter aircraft shape) undergoing coning motion at Mach 0.6. Six component force and moment data are presented for a range of angle of attack, sideslip, and coning rates. At the relatively low non-dimensional coning rate employed (omega b/2V less than or equal to 0.04), the lateral aerodynamic characteristics generally show a linear variation with coning rate.

Jermey, C.↗
NASA NTRS1985

Application of CFD techniques toward the validation of nonlinear aerodynamic models

Applications of Computational fluid dynamics (CFD) methods to determine the regimes of applicability of nonlinear models describing the unsteady aerodynamic responses to aircraft flight motions are described. The potential advantages of computational methods over experimental methods are discussed and the concepts underlying mathematical modeling are reviewed. The economic and conceptual advantages of the modeling procedure over coupled, simultaneous solutions of the gasdynamic equations and the vehicle's kinematic equations of motion are discussed. The modeling approach, when valid, eliminates the need for costly repetitive computation of flow field solutions. For the test cases considered, the aerodynamic modeling approach is shown to be valid.

Schiff, L. B.↗
NASA NTRS1985

Wind-tunnel investigation of the aerodynamic characteristics of the Standard Dynamics Model in coning motion at Mach 0.6

A series of wind-tunnel tests have been conducted on the Standard Dynamics Model (a simplified generic fighter-aircraft shape) undergoing coning motion at Mach 0.6. Six-component force and moment data are presented for a range of angles of attack, sideslip and coning rates. At the relatively low nondimensional coning rates employed, the lateral aerodynamic charactersitics generally show a linear variation with coning rate.

Jermey, C.↗
NASA NTRS1984

Mathematical modeling of the aerodynamic characteristics in flight dynamics

Basic concepts involved in the mathematical modeling of the aerodynamic response of an aircraft to arbitrary maneuvers are reviewed. The original formulation of an aerodynamic response in terms of nonlinear functionals is shown to be compatible with a derivation based on the use of nonlinear functional expansions. Extensions of the analysis through its natural connection with ideas from bifurcation theory are indicated.

Tobak, M.↗
NASA NTRS1984

Modeling of the aerodynamic response to arbitrary aircraft maneuvres - A numerical validation

The regime of validity of an aerodynamic mathematical model, applicable to describe the nonlinear aerodynamic reactions to a delta wing maneuvering at high angles of attack is investigated. An unsteady vortex-lattice method is used to compute the unsteady flowfields, and thus to evaluate the aerodynamic data required by the model, in terms of specified characteristic motions. Time-histories of the aerodynamic responses to complex motions are generated by means of the model and the evaluated aerodynamic data, and are compared with baseline aerodynamic responses obtained from direct vortex-lattice computations. The validity of the mathematical modeling approach for the maneuvering delta wing is demonstrated by the close agreement of the force and moment responses obtained from the two approaches.

Katz, J.↗
NASA NTRS1983

Nonlinear aerodynamic modeling of flap oscillations in transonic flow - A numerical validation

The regime of validity of a nonlinear aerodynamic force and moment formulation, based on concepts from nonlinear functional analysis and applicable to a transonic airfoil with a deflecting flap, is investigated. A time-dependent finite difference technique is used to evaluate the aerodynamic data of the formulation in terms of specified, characteristic motions. Flap-motion histories are generated from the flap inertial equations of motion, with aerodynamic reactions specified by the moment formulation. The motion histories depicting the cases of decaying and growing flap oscillations are compared with histories generated through simultaneous, coupled solution of the fluid-dynamic equations and flap inertial equations of motion. The range of applicability of the formulation is discussed.

Chyu, W. J.↗
NASA NTRS1983

Computation of supersonic viscous flows around pointed bodies at large incidence

A recently reported parabolized Navier-Stokes method has been extended to compute turbulent supersonic flows around cones and an ogive-cylinder body at large incidence. The algebraic eddy-viscosity turbulence model contained in the code was modified to properly account for the large regions of cross-flow separation that occur in these flows. Extensive comparisons between computed results and experimentally measured flow fields are presented. The results show good agreement for viscous-layer profiles and details of the external leeward-side vortex structure at angles of attack up to three times the cone half angles. Details of the modified turbulence model are presented and discussed.

Degani, D.↗
NASA NTRS1982

Numerical simulation of steady supersonic flow over spinning bodies of revolution

A recently reported parabolized Navier-Stokes code has been employed to compute the supersonic flowfield about a spinning cone and spinning and nonspinning ogive cylinder and boattailed bodies of revolution at moderate incidence. The computations were performed for flow conditions where extensive measurements for wall pressure, boundary-layer velocity profiles, and Magnus force had been obtained. Comparisons between the computational results and experiment indicate excellent agreement for angles of attack up to 6 deg. At angles greater than 6 deg discrepancies are noted which are tentatively attributed to turbulence modeling errors. The comparisons for Magnus effects show that the code accurately predicts the effects of body shape for the selected models.

Sturek, W. B.↗