Search NASA⌕ Search

Engineering topics

Schlenoff, Joseph B.

Publications and source records attributed to Schlenoff, Joseph B..

Comprehensive Dynamics in a Polyelectrolyte Complex Coacervate

The linear viscoelastic response, LVR, of a hydrated polyelectrolyte complex coacervate, PEC, was evaluated over a range of frequencies, temperatures, and salt concentrations. The PEC was a nearly stoichiometric blend of a quaternary ammonium poly([3-(methacrylamido)propyl]trimethylammonium chloride), PMAPTAC, and poly(2-acrylamido-2-methyl-1-propanesulfonic acid sodium salt), PAMPS, an aliphatic sulfonate, selected because they remain fully charged over the conditions of use. Narrow molecular weight distribution polyelectrolytes were prepared using fractionation techniques. A partially deuterated version of PMAPTAC was incorporated to determine its coil radius of gyration, R g , within PECs using small-angle neutron scattering. Chain dimensions were determined to be Gaussian with a Kuhn length of 2.37 nm, which remained constant from 25 to 65 °C. The LVR for a series of matched molecular weight PECs, mostly above the entanglement threshold, exhibited crossovers of modulus versus frequency classically attributed to the reptation time, relaxation between entanglements, and the relaxation of a Kuhn length of units (the “monomer” time). The scaling for zero shear viscosity, η 0 , versus chain length, N, was η 0 ~ N 3.1 , in agreement with “sticky reptation” theory. The lifetime and activation energy, E p , of a pair between polyanion and polycation repeat units, Pol + Pol – , were determined from diffusion coefficients of salt ions within the PEC. The activation energy for LVR of salt-free PECs was 2E p , showing that the key mechanism limiting the dynamics of undoped PECs is pair exchange. An FTIR technique was used to distinguish whether SCN– acts as a counterion or a co-ion within PECs. Doping of PECs with NaSCN breaks Pol + Pol – pairing efficiently, which decreases effective cross-linking and decreases viscosity. Finally, an equation was derived that quantitatively predicts this effect.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Highly Efficient and Stable Perovskite Solar Cells Enabled by Low‐Cost Industrial Organic Pigment Coating

Abstract Surface passivation of perovskite solar cells (PSCs) using a low‐cost industrial organic pigment quinacridone (QA) is presented. The procedure involves solution processing a soluble derivative of QA, N , N ‐bis(tert‐butyloxycarbonyl)‐quinacridone (TBOC‐QA), followed by thermal annealing to convert TBOC‐QA into insoluble QA. With halide perovskite thin films coated by QA, PSCs based on methylammonium lead iodide (MAPbI 3 ) showed significantly improved performance with remarkable stability. A PCE of 21.1 % was achieved, which is much higher than 18.9 % recorded for the unmodified devices. The QA coating with exceptional insolubility and hydrophobicity also led to greatly enhanced contact angle from 35.6° for the pristine MAPbI 3 thin films to 77.2° for QA coated MAPbI 3 thin films. The stability of QA passivated MAPbI 3 perovskite thin films and PSCs were significantly enhanced, retaining about 90 % of the initial efficiencies after more than 1000 hours storage under ambient conditions.

He, Qingquan↗

Highly Efficient and Stable Perovskite Solar Cells Enabled by Low‐Cost Industrial Organic Pigment Coating

Abstract Surface passivation of perovskite solar cells (PSCs) using a low‐cost industrial organic pigment quinacridone (QA) is presented. The procedure involves solution processing a soluble derivative of QA, N , N ‐bis(tert‐butyloxycarbonyl)‐quinacridone (TBOC‐QA), followed by thermal annealing to convert TBOC‐QA into insoluble QA. With halide perovskite thin films coated by QA, PSCs based on methylammonium lead iodide (MAPbI 3 ) showed significantly improved performance with remarkable stability. A PCE of 21.1 % was achieved, which is much higher than 18.9 % recorded for the unmodified devices. The QA coating with exceptional insolubility and hydrophobicity also led to greatly enhanced contact angle from 35.6° for the pristine MAPbI 3 thin films to 77.2° for QA coated MAPbI 3 thin films. The stability of QA passivated MAPbI 3 perovskite thin films and PSCs were significantly enhanced, retaining about 90 % of the initial efficiencies after more than 1000 hours storage under ambient conditions.

He, Qingquan↗

Scattering Neutrons along the Polyelectrolyte Complex/Coacervate Continuum

The coil size of narrow molecular weight distribution deuterated poly(styrenesulfonate), PSS, within a polyelectrolyte complex doped with KBr was tracked across the continuum from solid to coacervate to solution using small-angle neutron scattering. Here, while PSS alone in solution exhibited the familiar and pronounced “polyelectrolyte effect” of coil shrinkage with increasing [KBr], the radius of gyration R g of the PSS in the complex remained surprisingly constant up to 1.4 M KBr, which is close to the transition between complex and coacervate behavior. Thereafter, R g decreased with increasing KBr, remaining slightly larger than R g for PSS in KBr alone. Upturns in the scattering at low angle, seen for complexes in lower [KBr], are consistent with porosity, observed macroscopically as whitening of the bulk complex—a universal property of polyelectrolyte complexes. Reasons for this porosity, imaged by scanning electron microscopy, are discussed. At high q ranges, a correlation peak between deuterated coils of PSS was observed.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Polyelectrolyte Complex Films Influence the Formation of Polycrystalline Micro-Structures

Silica-carbonate biomorphs are inorganic materials composed of thousands of crystalline nanorods that assemble complex morphologies such as helices, vessels, and sheets. We investigate the effect on biomorph crystallization of polyelectrolyte complex films that are prepared using the layer-by-layer deposition technique and post-processed to obtain three stable, chemically distinct films. Biomorph growth on poly(diallyldimethylammonium)-dominated substrates (cationic) shows polycrystalline helical and sheet structures bounded by large witherite prisms. Crystallization on poly(styrenesulfonate)-dominated (anionic) and stoichiometric substrates follows a qualitatively different pathway. We observe islands of radial mineral films that over several days extend at a remarkably constant velocity of 0.48 µm/h and eventually mineralize the whole substrate. Our work opens exciting avenues for the use of polyelectrolyte films as tunable substrates for biomimetic crystallization.

Nakouzi, Elias↗

Collective epithelial cell sheet adhesion and migration on polyelectrolyte multilayers with uniform and gradients of compliance

Polyelectrolyte multilayers (PEMUs) are tunable thin films that could serve as coatings for biomedical implants. PEMUs built layer by layer with the polyanion poly(acrylic acid) (PAA) modified with a photosensitive 4-(2-hydroxyethoxy) benzophenone (PAABp) group and the polycation poly(allylamine hydrochloride) (PAH) are mechanically tunable by UV irradiation, which forms covalent bonds between the layers and increases PEMU stiffness. PAH-terminated PEMUs (PAH-PEMUs) that were uncrosslinked, UV-crosslinked to a uniform stiffness, or UV-crosslinked with an edge mask or through a neutral density optical gradient filter to form continuous compliance gradients were used to investigate how differences in PEMU stiffness affect the adhesion and migration of epithelial cell sheets from scales of the fish Poecilia sphenops (Black Molly) and Carassius auratus (Comet Goldfish). During the progressive collective cell migration, the edge cells (also known as ‘leader’ cells) in the sheets on softer uncrosslinked PEMUs and less crosslinked regions of the gradient formed more actin filaments and vinculin-containing adherens junctions and focal adhesions than formed in the sheet cells on stiffer PEMUs or glass. During sheet migration, the ratio of edge cell to internal cell (also known as ‘follower’ cells) motilities were greater on the softer PEMUs than on the stiffer PEMUs or glass, causing tension to develop across the sheet and periods of retraction, during which the edge cells lost adhesion to the substrate and regions of the sheet retracted toward the more adherent internal cell region. These retraction events were inhibited by the myosin II inhibitor Blebbistatin, which reduced the motility velocity ratios to those for sheets on the stiffer PEMUs. Blebbistatin also caused disassembly of actin filaments, reorganization of focal adhesions, increased cell spreading at the leading edge, as well as loss of edge cell-cell connections in epithelial cell sheets on all surfaces. Interestingly, cells throughout the interior region of the sheets on uncrosslinked PEMUs retained their actin and vinculin organization at adherens junctions after treatment with Blebbistatin. Like Blebbistatin, a Rho-kinase (ROCK) inhibitor, Y27632, promoted loss of cell-cell connections between edge cells, whereas a Rac1 inhibitor, NSC23766, primarily altered the lamellipodial protrusion in edge cells. Compliance gradient PAH-PEMUs promoted durotaxis of the cell sheets but not of individual keratocytes, demonstrating durotaxis, like plithotaxis, is an emergent property of cell sheet organization. - Highlights: • Fish scale cell sheets migrate on PAH-PAABp polyelectrolyte multilayers. • Sheets migrating on softer PEMUs periodically retract. • Sheets durotax on modulus gradients. • Myosin II inhibitors inhibit sheet integrity and migration.

60 APPLIED LIFE SCIENCES↗