Engineering topics
Publications and source records attributed to Schmidt, Andrew.
Solvent extraction and separation of HTL products using naphtha range hydrocarbons was studied with the aim of decreasing operational hazards while improving scalability, reliability, and yields.
Rheological investigation were performed with primary and secondary waste water treatment sludge. Using a rheometer equipped with a high pressure/temperature cell, flow curves were generated over shear rate at 0 to 1000 s-1. Temperature sweeps spanning 25 to 300 C were also performed are are reported here. The original release, PNNL-SA-185826, is being revised. The revision include a revision table, a disclaimer, and the underlying data set is being added.
While wet waste hydrothermal liquefaction technology has a high biofuel yield, a significant amount of the carbon and nitrogen in the feedstock reports to the aqueous-phase product. Pretreatment of this stream before sending to a conventional wastewater plant is essential or at the very least, advisable. In this work, techno-economic and life-cycle assessments were conducted for the state-of-technology baseline and four aqueous-phase product treatment and monetization options based on experimental data. Further, these options can cut minimum fuel selling prices by up to 13 % and life-cycle greenhouse gas emissions by up to 39 % compared to the baseline. These findings highlight the substantial influence of aqueous produce treatment strategies on the entire wet waste hydrothermal liquefaction process, demonstrating the potential for optimizing economic viability and environmental impact through further research and development of milder treatment methods and diversified by-product valorization pathways.