CLAS-ACT: Conformal, Lightweight Antennas for Aeronautical Communications Technology
No abstract available
Schoenholz, Bryan↗
Engineering topics
Schoenholz, Bryan
Publications and source records attributed to Schoenholz, Bryan.
Conformal Lightweight Antenna Systems for Aeronautical Communication Technology (CLAS-ACT)
Develop a conformal microwave antenna based on an ultralight aerogel substrate that can conform to an aircraft's contours reducing drag, fuel burn and emissions. The antenna will also provide interference mitigation with electronic control of the radiation pattern.
Downey, James↗
Active Array Measurements using the Portable Laser Guided Robotic Metrology System
In this paper, we will discuss the impact of mounting structures on the installed performance of phased arrays. In particular, performance data for the Conformal, Lightweight Antennas for Aeronautical Communications Technology (CLAS-ACT) antenna will be presented. Performance data from a series of mounting configurations will show that null depth and location is particularly susceptible while the main beam steering angle remain relatively stable. In addition, the Portable Laser Guided Robotic antenna range (PLGR) will be discussed as a suitable instrument for measuring antenna patterns in complex or difficult locations that are challenging for traditional ranges. The PLGR antenna range was recently developed at the National Aeronautics and Space Administration's (NASA) Glenn Research Center (GRC) and deployed to measure in situ antenna patterns.
Piasecki, Marie↗
Active Array Measurements using the Portable Laser Guided Robotic Metrology System
In this paper, we will discuss the impact of mounting structures on the installed performance of phased arrays. In particular, performance data for the Conformal, Lightweight Antennas for Aeronautical Communications Technology (CLAS-ACT) antenna will be presented. Performance data from a series of mounting configurations will show that null depth and location is particularly susceptible to change while the main beam steering angle remains relatively stable. In addition, the Portable Laser Guided Robotic Metrology (PLGRM) system will be discussed as a suitable instrument for measuring antenna patterns in complex or difficult locations that are challenging for traditional ranges. The PLGRM system was recently developed at the National Aeronautics and Space Administration's (NASA) Glenn Research Center (GRC) and deployed to measure in situ antenna patterns.
Piasecki, Marie↗
Bit Error Rate Performance of a Free Space Optical Link Using Double Clad Fibers
Mobile and embedded applications are emerging in the growing field of free space optical links (FSOL). Some mobile applications for FSOL include spacecraft, aircraft, and automotive. These applications by nature require low size weight and power (SWaP) solutions. The main challenge with any FSOL system is the strict pointing requirements. Common solutions to pointing and alignment of FSOL include gimbals, fast steering mirrors, and adaptive optics. All of which provide viable solutions at the cost of increased SWaP. Previously, we presented the use of both large core fibers and double clad fibers (DCF) to interface FSOL transmit and receive optics with small form factor pluggable optical transceivers (SFP). Double clad fibers have been shown to enable a common optical path by transmitting through a single mode core and receiving through a large inner cladding. This enables a single set of symmetric transmit and receive optics, which decreases the SWaP. In addition, using DCF increases the received power stability of the link relative to a multi-mode fiber (MMF) transmitting. To determine the viability of the system, bit error rate performance needs to be investigated. The results of this paper show that at a bit rate of 10 Gbps, double clad fibers offer similar bit error rate performance to single mode fibers when transmitting and multi-mode fibers when receiving enabling a symmetric duplex FSOL reducing SWaP.
Double Clad Fiber↗
Exploration of Double Clad Fibers for Increased Stability of Bidirectional Free Space Optical Links
Bidirectional, high data rate, low size, weight, and power (SWaP), and low cost free space optical links are needed for space communication applications to send and receive large volumes of data. We are exploring design strategies for optical transceivers to reduce SWaP and cost through increased misalignment tolerance (pointing requirement reduction) and sharing the optical transmit and receive paths (imposing optical symmetry). In applications where the detector is fiber coupled, the fiber numerical aperture is the main driver of the pointing accuracy requirement. Unfortunately, reducing the pointing requirement by increasing the fiber numerical aperture symmetrically causes instability in received power over small environmental changes. This paper explores double clad fibers as a solution to both reduce the power instability and increase the pointing accuracy tolerance. Double clad fibers can transmit a Gaussian beam from a single mode fiber and receive in a multi-mode aperture. Results show that double clad fiber have an improved misalignment tolerance and a higher stability for small changes in temperature when compared to single mode fibers and multimode fibers. Also, double clad fibers are shown to match the performance of an asymmetrical link design with a single mode transmit fiber and a multimode receive fiber.
Double Clad fibers↗
Bit Error Rate Performance on Passive Alignment in Free Space Optical Links Using Large Core Fibers
A 20-meter free-space optical link (FSOL) is proposed for data transmission between external ISS payload sites and the main cabin at a target rate of 10 Gbps (gigabits per second). Motion between a payload site and the main cabin is predicted to cause up to 5 cm in lateral misalignment and 0.2 degrees of angular misalignment. Due to the harsh environment of space it is advantageous to locate the optical transceivers inside the spacecraft or in a controlled environment. With the optical components and transceivers in separate locations, a fiber optic cable will be required to carry light between the two. In our past work we found that the use of large-core fibers provide an increased misalignment tolerance for such systems and could eliminate the need for active control of the optics. In that work, it was shown that a 105 ïm core diameter fiber optic cable offered a viable low SWaP (size, weight, and power) solution for the ISS application; however, the effects of modal dispersion were not investigated. This paper will present bit error rate performance of the FSOL using these large-core fibers.
Free Space Optical Link↗
Bit Error Rate Performance on Passive Alignment in Free Space Optical Links Using Large Core Fibers
A 20-meter free-space optical link (FSOL) is proposed for data transmission between external ISS payload sites and the main cabin at a target rate of 10 Gbps (gigabits per second). Motion between a payload site and the main cabin is predicted to cause up to 5 cm in lateral misalignment and 0.2 degrees of angular misalignment. Due to the harsh environment of space it is advantageous to locate the optical transceivers inside the spacecraft or in a controlled environment. With the optical components and transceivers in separate locations, a fiber optic cable will be required to carry light between the two. In our past work we found that the use of large-core fibers provide an increased misalignment tolerance for such systems and could eliminate the need for active control of the optics. In that work, it was shown that a 105 ïm core diameter fiber optic cable offered a viable low SWaP (size, weight, and power) solution for the ISS application; however, the effects of modal dispersion were not investigated. This paper will present bit error rate performance of the FSOL using these large-core fibers.
Optical Bit Error Rate Testing↗
SCaN Transportable Communication Platform (STCP)
NASA Glenn Research Center required a satellite communication trailer that served dual purposes; 24/7 Emergency Communication Services (ECS) in the event of a natural or manmade disaster that disrupted conventional communications, and a Ka Band NASA TDRS capability providing a research capability for over the air evaluations/characterizations. The trailer was to be field deployable, environmentally controlled and self-contained providing local area networks (LANs) and Wide Area Networks (WAN's) with user access both wired (Ethernet) and wireless (802.11) supporting VoIP, Internet Web access and Email. The TDRSS terminal included a 200W TWT amplifier mounted on the feed boom, individual up and down converters, and custom integrated waveguide and a supporting feed system. Other features such as a mast, generator, electrical, lighting, surveillance, and storage capabilities were also required. The Trailer was developed and demonstrated these original requested capabilities. New Requirements are defined and the trailer is now being evolved and upgraded to be a backup for the Near- Earth Network (NEN) Stations at KSC that will support the launch phase of EM-1. This paper presents the current and future capabilities of the trailer and additional options that will make it a valuable deployable asset to support remote operations from any launch from location.
Ka Band↗
Study of Lateral Misalignment Tolerance of a Symmetric Free-Space Optical Link for Intra International Space Station Communication
This paper describes the study of lateral misalignment tolerance of a symmetric high-rate free-space optical link (FSOL) for use between International Space Station (ISS) payload sites and the main cabin. The link will enable gigabit per second (Gbps) transmission of data, which is up to three orders of magnitude greater than the current capabilities. This application includes 10-20 meter links and requires minimum size, weight, and power (SWaP). The optical power must not present an eye hazard and must be easily integrated into the existing ISS infrastructure. On the ISS, rapid thermal changes and astronaut movement will cause flexure of the structure which will potentially misalign the free space transmit and receive optics 9 cm laterally and 0.2 degrees angularly. If this misalignment is not accounted for, a loss of the link or degradation of link performance will occur. Power measurements were collected to better understand the effect of various system design parameters on lateral misalignment. Parameters that were varied include: the type of small form pluggable (SFP) transceivers, type of fiber, and transmitted power level. A potential solution was identified that can reach the lateral misalignment tolerance (decenter span) required to create an FSOL on the ISS by using 105 m core fibers, a duplex SFP, two channels of light, and two fiber amplifiers.
free space↗
Study of Lateral Misalignment Tolerance of a Symmetric Free-Space Optical Link for Intra International Space Station Communication
This paper describes the study of lateral misalignment tolerance of a symmetric high-rate free-space optical link (FSOL) for use between International Space Station (ISS) payload sites and the main cabin. The link will enable gigabit per second (Gbps) transmission of data, which is up to three orders of magnitude greater than the current capabilities. This application includes 10-20 meter links and requires minimum size, weight, and power (SWaP). The optical power must not present an eye hazard and must be easily integrated into the existing ISS infrastructure. On the ISS, rapid thermal changes and astronaut movement will cause flexure of the structure which will potentially misalign the free space transmit and receive optics 9 cm laterally and 0.2 degrees angularly. If this misalignment is not accounted for, a loss of the link or degradation of link performance will occur. Power measurements were collected to better understand the effect of various system design parameters on lateral misalignment. Parameters that were varied include: the type of small form pluggable (SFP) transceivers, type of fiber, and transmitted power level. A potential solution was identified that can reach the lateral misalignment tolerance (decenter span) required to create an FSOL on the ISS by using 105 m core fibers, a duplex SFP, two channels of light, and two fiber amplifiers.
optical communications↗