Search NASA⌕ Search

Engineering topics

Schoenster, J. A.

Publications and source records attributed to Schoenster, J. A..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1986

Flight research on natural laminar flow nacelles - A progress report

This paper presents a progress report on an ongoing flight experiment for natural laminar flow nacelles. The results given herein were obtained during the first phase of the experiment, in which an instrumented natural laminar flow nacelle fairing was flight tested in the presence of turbofan engine noise and a controlled noise source. The results indicate that with the controlled noise source off, natural laminar flow was measured as far aft as 37 percent of the fairing length. The transition front was irregular in contour, and the extent of natural laminar flow was significantly affected by the relative flow angle for the fairing. In addition to these test results, the paper discusses the results of some recent computational analyses to predict pressure distributions and transition location, and to explain some of the data trends. Comparisons between measured and predicted data indicate that the analytical methods successfully predicted trends for the baseline (no controlled noise source) studies.

Hastings, E. C., Jr.↗
NASA NTRS1986

Natural laminar flow flight experiments on a turbine engine nacelle fairing

Flight experiments are being conducted with the objective to investigate the interactions between acoustic disturbances and laminar flow in the flight environment. In the experiments, the laminar boundary layer on the nacelles will be exposed to discrete and broadband external noises, and the effect of varying noise levels and frequencies on the stability of the laminar flow will be studied. The present paper provides an overview of the complete project and a status report on the results which have been obtained. The flight experiment is conducted with the aid of a modified research aircraft. The phase I flight tests are concerned with a quick and simple determination of natural laminar flow (NLF) behavior on an engine nacelle. Attention is given to instrumentation, the acoustic noise source, flow visualization, and the test results.

Obara, C. J.↗
NASA NTRS1985

Fluctuating pressures on fan blades of a turbofan engine, flight test investigation

Miniature pressure transducers were used to measure the fluctuating pressure on the fan blades of a JT15D engine in flight to aid in understanding fan-noise generation. Although the blade pressures can be considered very useful in determining far-field noise sources in the subsonic fan-blade tip speeds, other mechanisms, and as shock waves in the transonic and supersonic fan-blade tip speeds, limit their usefulness in these higher speed ranges.

Schoenster, J. A.↗
NASA NTRS1983

Fluctuating pressure measurements on the fan blades of a turbofan engine during ground and flight tests

As part of a program to investigate fan noise generated by a turbofan engine, miniature pressure transducers were used to measure the fluctuating pressures on the surface of a fan blade on the JT15D engine. Tests were conducted on the ground, with tunnel and in flight. Using narrowband spectra analysis and signal enhancement techniques, comparisons for these various test conditions are presented. Results on the blade pressures are also presented from a flight test in which 41 rods were placed in front of the fan face to excite a known spinning mode in the duct. Results showed that with care, ground tests can be conducted in which the pressure loading on the blades are similar to those in flight. Comparison of pressure transducers on the blade surface also showed that a single transducer would provide much of the information available from this type of measurement.

Schoenster, J. A.↗
NASA NTRS1982

Fluctuating pressures on fan blades of a turbofan engine: Static and wind-tunnel investigations

To investigate the fan noise generated from turbofan engines, miniature pressure transducers were used to measure the fluctuating pressure on the fan blades of a JT15D engine. Tests were conducted with the engine operating on an outdoor test stand and in a wind tunnel. It was found that a potential flow interaction between the fan blades and six, large support struts in the bypass duct is a dominant noise source in the JT15D engine. Effects of varying fan speed and the forward speed on the blade pressure are also presented.

Schoenster, J. A.↗
NASA NTRS1981

Unsteady fan blade pressure and acoustic radiation from a JT15D-1 turbofan engine at simulated forward speed

Tests have been conducted on a JT15D-1 turbofan engine both statically and at simulated forward speed in the Ames 12 x 24 Meter Wind Tunnel. Both far-field acoustic data and unsteady pressure data from transducers mounted on the fan blades were acquired. Results showed a sound power reduction of about 10 dB in the far-field acoustic levels with simulated forward speed over those measured without forward speed. Blade mounted transducer results showed rotor-turbulence interaction dominated the noise field at very low speeds while an interaction between the rotor and internal struts dominated at higher speeds. Results are presented to show the effects of varying engine rpm, changing the angle-of-attack of the engine inlet to tunnel flow and mounting an aircraft wing to simulate an installation condition on an actual aircraft.

Preisser, J. S.↗
NASA NTRS1979

Experimental study of acoustic loads on an upper-surface-blown STOL airplane configuration

Fluctuating pressure levels were measured on the flap and fuselage of an upper-surface-blown jet-flap airplane configuration in a wind tunnel. The model tested had turbofan engines with a bypass ratio of 3 and a thrust rating of 10 kN. Rectangular nozzles were mounted flush with the upper surface at 35 percent of the wing chord. Test parameters were flap deflection angle, jet impingement angle, angle of attack, free-stream velocity, spanwise location of the engine, and jet dynamic pressure. Load levels were high throughout the jet impingement region, with the highest levels (about 159 dB) occurring on the fuselage and near the knee of the flap. The magnitude of the forward-velocity effect appeared to depend upon the ratio of free-stream and jet velocities. Good agreement was obtained between fluctuating pressure spectra measured at jet dynamic pressures of 7 and 22 kPa when the spectra were scaled by nondimensional functions of dynamic pressure, velocity, and the empirical relationship between dynamic pressure and overall fluctuating pressure level.

Willis, C. M.↗
NASA NTRS1979

An experimental study of propeller-induced structural vibration and interior noise

This paper presents results of tests conducted to study fuselage sidewall dynamics and their effects on the cabin interior noise of a twin-engine, propeller-driven, light aircraft. Data on the dynamic behavior were obtained by slowly sweeping the RPM of one of the engines while the aircraft was stationary on the ground. This technique allowed frequency response plots of the sidewall structural accelerations to be obtained. These accelerations are compared to similar results from a test using a mechanical shaker in order to evaluate the structural dynamic response caused by the harmonics of the propeller blade passage tone. The dynamic response of the fuselage sidewall is also discussed as a noise transmission mechanism. A second mechanism for noise transmission through the fuselage sidewall was investigated by opening the copilot's window. The results illustrate the complex nature of the noise transmission mechanisms and the importance of correctly assessing noise paths.

Howlett, J. T.↗
NASA NTRS1977

Acoustic loads on upper-surface-blown powered-lift systems

Powered-lift concepts are utilized in aircraft currently under development for STOL application. One of the concepts, upper surface blowing, places the jet exit just above the upper surface of the wing to produce powered lift from the jet exhaust blowing over the deflected flap. New data are presented to show the effects of airspeed, angle of attack, and angle of jet impingement. Scaling relationships are investigated concerning their applicability for extrapolating data to a different model size. The effects of a number of test parameters are examined and full-scale spectra are predicted from model data. It is concluded that scale models are an effective means for obtaining fluctuating pressure spectra for use in aircraft design. The prediction of full-scale loads from model data will require geometrically accurate models and closely spaced measurement locations.

Willis, C. M.↗
NASA NTRS1977

Fluctuating loads on the flap surfaces of an externally-blown-flap configuration

An experimental program to obtain the fluctuating loads on the surfaces of a triple-slotted externally-blown-flap powered-lift STOL configuration was conducted. A large model of a wing/flap system and a TF-34 medium bypass ratio engine was investigated. Measurements of the fluctuating pressure, static pressure, and surface temperature resulting from the jet impingement were obtained at several locations on the surfaces of the second and third flaps. Fluctuating pressure data include overall level, power-spectral density (PSD), cross-correlation coefficient, coherency, and phase angle of the cross power-spectral density. These data indicate that more than one mechanism contributes to the fluctuating pressure levels on the flaps. In the immediate area above the intersection of the engine centerline and the flap, low frequency pressures dominate the overall fluctuating pressure levels. In other areas, such as below this intersection and outboard on the flaps, the PSD curve reaches a peak value at a Strouhal number ranging from 0.22 to 0.45.

Schoenster, J. A.↗
NASA NTRS1976

Acoustic-loads research for powered-lift configurations

Data presented from large-scale model tests with jet engines having thrusts of 9 kN (2000 lb) and 36 kN (8000 lb) include acoustic loads for an externally blown wing and flap induced by a TF34 jet engine, an upper surface blown (USB) aircraft model in a wind tunnel, and two USB models in static tests. Comparisons of these results with results from acoustic loads studies on configurations of other sizes are made and the implications of these results on interior noise and acoustic fatigue are discussed.

Schoenster, J. A.↗
NASA NTRS1975

Comparison of vibrations of a combination of solid-rocket launch vehicle and payload during a ground firing and launching

The results of a study into the environmental vibrations of a payload mounted on the Nike rocket launch vehicle were presented. Data were obtained during the flight acceptance test of the payload, the firing of the total vehicle in a special test stand, and the powered and unpowered flights of the vehicle. The vibrational response of the structure was measured. Data were also obtained on the fluctuating pressure on the outside surface of the vehicle and inside the forward and after ends of the rocket chamber. A comparison of the data from the three test conditions indicated that external pressure fluctuations were the major source of vibrations in the payload area, and pressure fluctuations within the rocket motor were the major source of vibrations contiguous to the payload area.

Schoenster, J. A.↗
NASA NTRS1975

Fluctuating pressures on aircraft wing and flap surfaces associated with powered-lift systems

The present work presents results from two research studies that provide information on the fluctuating pressures generated by the use of powered-lift systems in STOL aircraft. Data are given for several chordwise and spanwise locations on large-scale models of an externally blown flap (EBF) configuration and an upper surface blown flap (USB) configuration in which actual jet engines were used. Pressure levels were high enough to indicate that special design effort will be required to avoid acoustic fatigue failures of wing and flap sturctures. The observation that pressure levels did not decrease very much with increased distance from the engine exhaust center line suggests that a STOL aircraft fuselage, which is in relatively close proximity to the engines for aerodynamic reasons, will be subjected to unusually high external overall fluctuating pressure levels (OAFPLs) that may cause difficulty in control of the cabin noise level.

Mixson, J. S.↗
NASA NTRS1974

Acoustic loads on an externally blown flap system due to impingement of a TF-34 jet engine exhaust

One of the powered lift systems currently being considered for use on STOL vehicles obtains additional lift by impinging the flow of a jet exhaust on the flaps and turning it downward. This direct impingement subjects large areas of the flap to the fluctuating pressure loads of the turbulent jet flow; these loads have the potential for causing high vibration levels and sonic fatigue failures. A test was conducted on a full-scale mockup of an externally blown flap system, which consisted of a TF-34 engine and a section of a wing having a triple-slotted flap. Data were obtained and evaluated on the fluctuating pressures on the flaps and it is the purpose of this paper to present some of the results describing the loads.

Schoenster, J. A.↗
NASA NTRS1973

A sinusoidal-vibration analysis program for experimental data

A program is described for obtaining resonant frequencies, modal amplitudes, and damping of a structure from a sinusoidal force-controlled vibration test. Presented are the theoretical basis for the analysis (the Kennedy-Pancu method), recommendations for a test procedure based on experience with several earlier test programs, and an outline of the data analysis technique. Although the program was developed for structural vibration problems, variations for processing any sinusoidal data are available.

Schoenster, J. A.↗
NASA NTRS1972

Effects of experimentally measured pressure oscillations on the vibration of a solid rocket motor

Results are presented of firing a Nike rocket against a backstop for the purpose of obtaining pressure fluctuations in the rocket case and determining their relationship to structural vibrations of the case. Special care was required to obtain these pressure fluctuations because of the much higher static pressure generated in the rocket. Very small pressure fluctuations within the rocket case can cause significant vibration levels. A previously observed high frequency was shown to decrease with time before completely disappearing at about 1 second of burning time. The vibration of the case itself is probably related to the longitudinal structural modes at frequencies below 500 Hz and is dependent on local structural conditions at frequencies above this value.

Schoenster, J. A.↗