Engineering topics

Schott, Timothy

Publications and source records attributed to Schott, Timothy.

3 records

NASA NTRS2018

Further Development of an Electromagnetic Position Sensor for a Wind Tunnel MSBS

An Electromagnetic Position Sensor (EPS) was successfully developed in the 1960’s for the MIT “6-inch” Magnetic Suspension and Balance System. An updated version remains in use today, based on analog electronics. This paper will review the hardware revisions made to successfully adapt the system for use in sensing 3 degrees-of-freedom motion of small spherical or near-spherical suspended models. Practical challenges related to electrical noise sensitivity and stray coupling paths will be discussed. Preliminary analysis of alternative demodulation approaches, including digital signal processing, will be reviewed.

Britcher, Colin↗

NASA NTRS2018

Static and Dynamic Testing of Blunt Bodies in a Subsonic Magnetic Suspension Wind Tunnel

The MIT 6-inch magnetic suspension wind tunnel is used in two configurations to measure lift forces of two blunt bodies and produce free-to-pitch oscillations driven by capsule static stability and dynamic instabilities. Lift tests show that static aerodynamic data can be measured on a magnetically levitated model without moment control. Free-to- oscillate results show that magnetic suspension balance system (MSBS) can produce capsule dynamics suitable for extracting static and dynamic stability data.

Schoenenberger, Mark↗

NASA NTRS1992

Present status of the MIT/NASA Langley 6-inch MSBS

The latest improvements are described which were made to the MIT/NASA Langley 6 Inch Magnetic Suspension and Balance System and its operational capabilities. Since its relocation from MIT in 1984, the system has suffered from reliability problems with original equipment. System performance is ultimately limited by noise and antiquated power supplies. Although a limited amount of funding and man hours has been expended, some significant improvements were made to the system. The design and implementation of a new electro-magnetic position sensor has significantly reduced system noise and drift. The system was shown fully operational for the first time since its arrival at NASA Langley. An ogive cylinder test model was suspended while running the wind tunnel at its maximum of approx. Mach 0.5. Other aerodynamic models were suspended with wind on. Also, the simulation of low speed cavity store separation using an ogive cylinder test model is described. Methods used for flow visualization for this test are also discussed. The system is ideally suited for this type of low speed testing.

Schott, Timothy↗