Engineering topics

Schulte, Kevin L.

Publications and source records attributed to Schulte, Kevin L..

24 records · Page 2

DOE OSTI2021

Improved Contacts for Tandem Cells with Enhanced Effciency Grown by D-HVPE

Dynamic hydride vapor phase epitaxy (D-HVPE) has provided a potential route towards lower cost material growth of III-V photovoltaic devices. A highly doped Ga0.5In0.5P emitter layer is grown in attempt to force passivation at the front of the cell to account for the absence of a suitable window layer in our reactor. Control over dopant diffusion in these materials is thus critical to achieving high-efficiency device performance. Here, we institute a two-step contact layer design that boosts tandem cell efficiencies by minimizing Se diffusion into the underlying emitter layer while still providing sufficiently low contact resistance. Short-circuit current in these devices improves to 8.9 mA/cm2 in an uncoated GaInP/GaAs cell, an improvement of 1.2 mA/cm2 over our previous best cell. Conversion efficiency with the new contact doping scheme is projected to be ~27% with the inclusion of a standard ARC layer.

27 ARPA - Advanced Research Projects Agency-Energy↗

DOE OSTI2020

Inverted Metamorphic AlGaInAs/GaInAs Tandem Thermophotovoltaic Cell Designed for Thermal Energy Grid Storage Application

We demonstrate an inverted metamorphic multijunction (IMM) photovoltaic cell comprising lattice-mismatched 1.2 eV AlGaInAs and 1.0 eV GaInAs junctions optimized for high-temperature thermophotovoltaic (TPV) applications. This device differs from traditional IMM solar cells because the mismatched junctions are grown at a single lattice constant. This architecture enables removal of the compositionally graded buffer that otherwise filters light from the junctions below and absorbs sub-bandgap light via free-carrier absorption. Sub-bandgap absorption dramatically reduces the efficiency of TPV systems using high reflectivity cells to enable band edge spectrum filtering. Three components required development to enable this device: (1) a lattice-mismatched 1.2 eV AlGaInAs junction, (2) a metamorphic contact layer grown after the graded buffer, and (3) a transparent tunnel junction that sits in front of the 1.0 eV GaInAs junction. Growth conditions that minimize oxygen defect incorporation maximize AlGaInAs cell quality, enabling a 0.41 V bandgap open circuit voltage offset at 22 mA/cm2 under AM1.5D. A mismatched GaInAs:Se layer is developed as a low resistance contact. Lastly, we develop a GaAsSb:C/GaInP:Se tunnel junction suitable for high-power densities with more transparency than the GaAsSb:C/GaInAs:Se structure used in past IMM cells. We characterize the tandem device under a high-intensity spectrum that approximates the emission from a 2150°C blackbody radiator and deduce a projected ideal TPV efficiency of 39.9% at ~30% of the blackbody irradiance and 36% ideal TPV efficiency under the full 118 W/cm2 irradiance. Improvements to the back-surface reflectivity and series resistance are expected to increase the ideal TPV efficiency well above 40%.

25 ENERGY STORAGE↗

DOE OSTI2020

High Efficiency 6-Junction Solar Cells for the Global and Direct Spectra

We show 6-junction inverted metamorphic solar cells with high efficiencies under both the global and direct spectrum, and discuss improvements to device components. High voltage AlGaInP subcells are demonstrated on GaAs substrates miscut 2° towards (111)B by using Sb surfactant to reduce atomic ordering. This miscut enables high voltage and low dislocation density GaInAs subcells by using atomically-ordered GaInP-based graded buffers. One-sun efficiencies of 39.2 ± 1.3% under the global spectrum and 39.4 ± 1.1% direct spectrum have been demonstrated by using these high voltage subcell components. For high efficiency under the concentrated direct spectrum, low resistance is also necessary, which requires a challenging and nonintuitive optimization of tunnel junctions and heterobarriers. Increasing the thickness of a (Al)GaInAs spacer layer between the back surface fields (BSF) and tunnel junctions (TJ) of latticemismatched subcells reduces nonlinear resistance, which implies a detrimental interaction between the BSF and TJ. Concentrator devices with optimized spacer layers show reduced effective resistance and maintain fill factor > 75% at 1100 suns. Device efficiencies under the concentrated direct spectrum peak at 47.1 ± 3.2% at 143 suns.

41 EE - Solar Energy Technologies Office (EE-4S)↗

DOE OSTI2020

Effect of hydride vapor phase epitaxy growth conditions on the degree of atomic ordering in GaInP

We report a systematic study of CuPt-type ordering in hydride vapor phase epitaxy (HVPE)-grown Ga 0.5 In 0.5 P. Selected-area electron diffraction reveals ordering in samples grown on (001) GaAs substrates offcut toward (1$\overline{1}$1)B. The ordering is single-variant, occurring only on (1$\overline{1}$1)B planes and not on ($\overline{1}$11)B. Quantitative analysis of the order parameter by high-resolution x-ray diffraction (HRXRD) indicates that ordering increases with deposition temperature in samples grown at 600–700 °C with a constant gas-phase V/III ratio ~3. Ordering increases with V/III ratio in the range of 1.3–6.7 at a constant deposition temperature of 650°C. Photoluminescence measurements correlate the order parameter with Ga0.5In0.5P bandgap contraction, though the contraction is larger than expected based on the magnitude of order parameters measured by HRXRD. A possible reason for this discrepancy is that the photoluminescence emission occurs in the lower bandgap ordered domains, which are small and evenly dispersed throughout the material. We also show that the degree of ordering decreases with growth rate, disappearing at ~60 µm/h. The HVPE-grown material exhibits a generally weaker ordering than organometallic vapor phase epitaxy (OMVPE)-grown material, likely due to the moderate V/III ratios employed, in contrast to the V/III ratios in the 100s typical of OMVPE. However, the tendency for ordering to increase with V/III ratio suggests that the same dimer-induced stress mechanism used to explain the occurrence of ordering in OMVPE-grown material also applies to HVPE. The tendencies for ordering to increase with deposition temperature and decrease with growth rate show that kinetics limit the degree of ordering, also in agreement with OMVPE trends.

74 ATOMIC AND MOLECULAR PHYSICS↗

DOE OSTI2020

GaAs growth rates of 528 μm/h using dynamic-hydride vapor phase epitaxy with a nitrogen carrier gas

Herein we demonstrate record GaAs growth rates approaching 530 μm/h using nitrogen carrier gas and 400 μm/h using hydrogen carrier gas in a dynamic-hydride vapor phase epitaxy reactor. We measured root mean square surface roughness below 1 nm using a 1 μm × 1 μm atomic force microscopy scan for GaAs growth rates up to 483 μm/h using a nitrogen carrier gas and 400 μm/h using a hydrogen carrier gas. We performed computational fluid dynamics modeling to study the effect of the carrier gas choice on the thermal profile within the reactor and how that influences the degree of AsH 3 decomposition. The modeling suggests that the lower thermal conductivity of the nitrogen carrier gas minimizes the amount of AsH 3 that thermally decomposes before reaching the wafer surface and the heavier atomic mass decreases the likelihood that AsH 3 will reach the heated reactor walls, leading to a growth rate enhancement relative to the hydrogen carrier case in a hydride-enhanced growth regime.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

DOE OSTI2020

Six-junction III–V solar cells with 47.1% conversion efficiency under 143 Suns concentration

Single-junction flat-plate terrestrial solar cells are fundamentally limited to about 30% solar-to-electricity conversion efficiency, but multiple junctions and concentrated light make much higher efficiencies practically achievable. Until now, four-junction III–V concentrator solar cells have demonstrated the highest solar conversion efficiencies. Here, we demonstrate 47.1% solar conversion efficiency using a monolithic, series-connected, six-junction inverted metamorphic structure operated under the direct spectrum at 143 Suns concentration. Furthermore, when tuned to the global spectrum, a variation of this structure achieves a 1-Sun global efficiency of 39.2%. Nearly optimal bandgaps for six junctions were fabricated using alloys of III–V semiconductors. To develop these junctions, it was necessary to minimize threading dislocations in lattice-mismatched III–V alloys, prevent phase segregation in metastable quaternary III–V alloys and understand dopant diffusion in complex structures. Further reduction of the series resistance within this structure could realistically enable efficiencies over 50%.

14 SOLAR ENERGY↗