Search NASA⌕ Search

Engineering topics

Schwartz, Daniel S.

Publications and source records attributed to Schwartz, Daniel S..

Surface area and particle size distribution of plutonium oxides derived from the direct oxidation of Pu metal (LA-UR-18-22581)

The intent of this paper is to interrogate the physical characteristics of PuO 2 powders and aggregates produced by direct metal oxidation to examine possible relationships between process parameters and the physical characteristics of the product. The majority of the PuO 2 samples considered were generated during the pre-production and production phases of the Advanced Recovery and Integrated Extraction System (ARIES) program at Los Alamos National Laboratory (LANL). Oxide formed passively on Pu metal surfaces at ambient atmospheric conditions is also characterized. Plutonium oxide powders from the ARIES Direct Metal Oxidation (DMO) furnace and muffle furnace process lines are very consistent in terms of their bulk and tapped density, specific surface area (SSA) and particle size distribution (PSD). The SSAs of calcined PuO 2 generated in the ARIES DMO-2 and muffle furnaces are between 0.1 and 0.5 m2/g. Oxides from both the DMO-2 and muffle furnaces also had similar tri-modal PSDs with maxima at 0.73–3.16 μm, 10.9–18.5 μm, and 41.3–63.0 μm. The PSDs of the oxide formed passively on Pu metal surfaces at ambient conditions were unimodal, with near-Gaussian distributions and D50 close to 1 μm. In conclusion, the oxide formed passively at ambient conditions also had significantly higher SSAs (6–8 m 2 /g).

36 MATERIALS SCIENCE↗

Uncertainty in the use of MAMA software to measure particle morphological parameters from SEM images

The MAMA software package developed at LANL is designed to make morphological measurements on a wide variety of digital images of objects. At LANL, we have focused on using MAMA to measure scanning electron microscope (SEM) images of particles, as this is a critical part of our forensic analysis of interdicted radiologic materials. In order to successfully use MAMA to make such measurements, we must understand the level of uncertainty involved in the process, so that we can rigorously support our quantitative conclusions.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Time-dependent local and average structural evolution of δ-phase 239 Pu-Ga alloys

Here, plutonium metal is a very unusual element, exhibiting six allotropes at ambient pressure, between room temperature and its melting point, a complicated phase diagram, and a complex electronic structure. Many phases of plutonium metal are unstable with changes in temperature, pressure, chemical additions, or time. This strongly affects structure and properties, and becomes of high importance, particularly when considering effects on structural integrity over long periods of time [1]. This paper presents a time-dependent neutron total scattering study of the local and average structure of naturally aging δ-phase 239 Pu-Ga alloys, together with preliminary results on neutron tomography characterization.

36 MATERIALS SCIENCE↗

Morphological Comparison of U3O8 Ore Concentrates from Canada Key Lake and Namibia Sources

Uranium ore concentrates from two different sources were examined using scanning electron microscopy (SEM) and energy dispersive spectroscopy (EDS). The ore powders are referred to as Namibia (id. no. 90036, LIMS id. no. 18775) and Canada Key Lake (id. no. 90019, LIMS id. no. 18774). Earlier work identified the ores as the U₃O₈ phase of uranium oxide using x-ray diffraction. Both sets of powders were in the form of dark brown to black powder fines. However, the Canada Key Lake concentrates contained larger chunks of material on the millimeter scale that were easily visible to the unaided eye. The powders were mounted for SEM examination by hand dispersing a small amount onto conductive sticky tape. Two types of applicators were used and compared: a fine-tipped spatula and a foam-tipped applicator. The sticky tape was on a standard SEM “tee” mount, which was tapped to remove loose contamination before being inserted into the SEM.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

Documentation of operational protocol for the use of MAMA software

Image analysis of Scanning Electron Microscope (SEM) micrographs is a complex process that can vary significantly between analysts. The factors causing the variation are numerous, and the purpose of Task 2b is to develop and test a set of protocols designed to minimize variation in image analysis between different analysts and laboratories, specifically using the MAMA software package, Version 2.1. The protocols were designed to be “minimally invasive”, so that expert SEM operators will not be overly constrained in the way they analyze particle samples. The protocols will be tested using a round-robin approach where results from expert SEM users at Los Alamos National Laboratory, Lawrence Livermore National Laboratory, Pacific Northwest National Laboratory, Savannah River National Laboratory, and the National Institute of Standards and Testing will be compared. The variation of the results will be used to quantify uncertainty in the particle image analysis process. The round-robin exercise will proceed with 3 levels of rigor, each with their own set of protocols, as described below in Tasks 2b.1, 2b.2, and 2b.3. The uncertainty will be developed using NIST standard reference material SRM 1984 “Thermal Spray Powder – Particle Size Distribution, Tungsten Carbide/Cobalt (Acicular)” [Reference 1]. Full details are available in the Certificate of Analysis, posted on the NIST website (http://www.nist.gov/srm/).

97 MATHEMATICS AND COMPUTING↗

Analytical Chemistry and Materials Characterization Results for Debris Recovered from Nitrate Salt Waste Drum S855793

Solid debris was recovered from the previously-emptied nitrate salt waste drum S855793. The bulk sample was nondestructively assayed for radionuclides in its as-received condition. Three monoliths were selected for further characterization. Two of the monoliths, designated Specimen 1 and 3, consisted primarily of sodium nitrate and lead nitrate, with smaller amounts of lead nitrate oxalate and lead oxide by powder x-ray diffraction. The third monolith, Specimen 2, had a complex composition; lead carbonate was identified as the predominant component, and smaller amounts of nitrate, nitrite and carbonate salts of lead, magnesium and sodium were also identified. Microfocused x-ray fluorescence (MXRF) mapping showed that lead was ubiquitous throughout the cross-sections of Specimens 1 and 2, while heteroelements such as potassium, calcium, chromium, iron, and nickel were found in localized deposits. MXRF examination and destructive analysis of fragments of Specimen 3 showed elevated concentrations of iron, which were broadly distributed through the sample. With the exception of its high iron content and low carbon content, the chemical composition of Specimen 3 was within the ranges of values previously observed in four other nitrate salt samples recovered from emptied waste drums.

Inorganic, Organic, Physical, & Analytical Chemist↗

Heating-Cooling Asymmetry in the δ-γ Transformation in Plutonium: Clausius-Clapeyron Considerations

Slides discuss the subject under the following topics: Pu phase transformations and features of the γ-δ transformation (heating-cooling asymmetry, cooling rate, effect of impurities); pressure effects in γ-δ transformations; Clausius-Clapeyron analysis; and discussion of heating-cooling asymmetry in the γ-δ transformation. The following conclusions are reached: burst behavior and extended transformation range due to pressure arrest; low slope of P-T curve for γ-δ favors this transformation for pressure arrest; asymmetry w.r.t. direction of transformation likely due to defects.

36 MATERIALS SCIENCE↗

Average Structure Evolution of δ-phase Pu-Ga Alloys

[Full Text] Plutonium metal is a highly unusual element, exhibiting six allotropes at ambient pressure, from room temperature to its melting point. Many phases of plutonium metal are unstable with temperature, pressure, chemical additions, and time. This strongly affects structure and properties, and becomes of high importance, particularly when considering effects on structural integrity over long time periods. The fcc δ-phase deserves additional attention, not only in the context of understanding the electronic structure of Pu, but also as one of the few high-symmetry actinide phases that can be stabilized down to ambient pressure and room temperature by alloying it with trivalent elements. We will present results on recent work on aging of Pu-2at.%Ga and Pu-7at.%Ga alloys

36 MATERIALS SCIENCE↗

Using magnetization measurements to detect small amounts of plutonium hydride formation in plutonium metal

We report the formation of plutonium hydride in 2 at % Ga-stabilized δ-Pu, with 1 atomic % H charging. We show that magnetization measurements are a sensitive, quantitative measure of ferromagnetic plutonium hydride against the nonmagnetic background of plutonium. It was previously shown that at low hydrogen concentrations, hydrogen forms super-abundant vacancy complexes with plutonium, resulting in a bulk lattice contraction. Here we use magnetization, X-ray and neutron diffraction measurements to show that in addition to forming vacancy complexes, at least 30% of the H atoms bond with Pu to precipitate PuH x , largely on the surface of the sample with x ~ 1.9. We observe magnetic hysteresis loops below 40 K with magnetic remanence, consistent with precipitates of ferromagnetic PuH 1.9 .

36 MATERIALS SCIENCE↗

Quantification and Uncertainty in Particle Morphological Analysis

A key part of forensic analysis of interdicted nuclear materials is examining the microstructure of the materials, which are frequently in the form of particulates. We are developing methods for quantifying the morphology of particle sets imaged using scanning electron microscopy. In order to use this data effectively, we need to understand the uncertainties involved in measuring the morphology of particles. This presentation discusses the sources of uncertainty in scanning electron microscopy, and presents the results of an internal user test of the MAMA software package being developed under a DHS Transformational and Applied Research program. The steps required to establish morphological standards similar to NIST standards are discussed.

36 MATERIALS SCIENCE↗

INFL Guideline On X-Ray Diffraction (XRD)

X-Ray Diffraction (XRD) is an analytical technique used to identify crystalline compounds. It is a bulk technique, though the volume of material sampled is relatively small (approximately 0.01 cm3 ). Specimens are typically examined in the form of powders or solid pieces. XRD data gives precise information about the crystal structure of the material examined, which can be compared to large open databases of crystal structures. The quality of matches of the analyte data to the database can be rigorously quantified. In the case of mixtures of compounds, the relative amounts of each compound can be calculated, although significant errors may exist. In general, XRD is a rapid, easy to use, and robust way to identify materials. It is a widely used and mature technology, with considerable flexibility.

36 MATERIALS SCIENCE↗

Thermophysical Properties of Plutonium Alloys

The unusual thermal expansion behavior of plutonium and plutonium alloys is one of the many fascinating properties of these materials. Thermal expansion is one of the best ways to monitor the allotropic phase transformations of pure plutonium.

36 MATERIALS SCIENCE↗

Pu doped with Hydrogen: Magnetic Properties

The magnetic properties of plutonium (Pu) metal remain an enigmatic problem based on our understanding of common magnetic compounds and understanding of coordination chemistry that explains and predicts the magnetic state of metals. The 5ƒ occupancy of Pu is believed to be fluctuating at very fast (fempto-second) time scales. As a result of occupancy fluctuations the average number of electrons to occupy the 5ƒ energy level of Pu is expected to be more than 5.3 electrons on average. This explanation provides a solution to the non-magnetic state observed in pure Pu metal. Despite the intellectual effort that has been deployed to provide an explanation to the “missing magnetism” in Pu metal it has been known since the 1950s that Uranium Hydride (UH 2 ) has a ferromagnetic ground state and similarly since the 1960s, that PuH 2 has a ferromagnetic ground state at moderate to low temperatures. The contrast in non-magnetic ground state observed in Pu metal and the ferromagnetic ground state of PuH 2 may provide further insight into the behavior of Pu metal and its electronic configuration and fluctuations.

36 MATERIALS SCIENCE↗

H-Pu-Vacancy Measurements [Slides]

Pu-H solubility data strongly indicates a SAV phenomenon. Lattice parameter contraction with H/D in solution at 0.01-0.02 atom ratio H or D/Pu indicates the SAV phenomenon. H loaded lattice showed short range order/structure. Bulk vs. X-ray densities indicate a high vacancy concentration. The data indicates a room temperature vacancy concentration of ~10 -3 at H/Pu=0.01. H/Pu concentrations greater than 0.001 (0.1%) will result in vacancy formation. This is a factor of 10 9 greater than a thermal concentration and therefore SuperAbundant.

36 MATERIALS SCIENCE↗