Search NASASearch

Engineering topics

Scott Jones

Publications and source records attributed to Scott Jones.

Mission and Vehicle-Level Updates for the Parallel Electric-Gas Architecture with Synergistic Utilization Scheme (PEGASUS) Concept Aircraft

NASA created the PEGASUS concept with the goal of lowering mission energy (a surrogate for operating cost) compared to other regional aircraft by leveraging electrified aircraft propulsion (EAP). Since its inception, researchers have explored multiple facets of PEGASUS in varying fidelity but have not completed a rigorous, integrated design. The goal of this memorandum is to provide an updated design using recent studies and improved methods. This memorandum explores the initial vehicle concept and concept of operations, while considering ways to improve both the mission concept of operations and the integrated vehicle-level performance. Additionally, the design and analysis methodologies for EAP-enabled aircraft concepts are improved in several areas. This research incorporates new propulsion-airframe integration and wing weight surrogates to model the impacts of wingtip propulsors on the configuration. Detailed weight and balance calculations enable calculating dynamic stability and flight qualities within the conceptual design environment. Ultimately, the vehicle is optimized to reduce "well-to-wake" equivalent CO2, CO2e, rather than minimizing either fuel (or total energy) consumption or maximum takeoff weight. Using fuel/energy or takeoff weight leads to conflicting optima for hybrid-electric aircraft. Two aircraft are developed to provide points of comparison for PEGASUS: an advanced conventional turboprop vehicle and a hybrid-electric variant. The results show that the PEGASUS concept can reduce CO2e relative to the advanced turboprop or a hybrid-electric propulsion architecture, albeit with an increase in maximum takeoff weight. PEGASUS's maximum takeoff weight is 55% heavier than the advanced conventional turboprop but releases 18% less CO2e for a 400 nmi mission. Over the same mission, PEGASUS's maximum takeoff weight is 47% heavier than the comparator hybrid-electric vehicle but releases 12% less CO2e. This study shows that the PEGASUS configuration reduces CO2e through its use of wingtip propulsors and that its benefit is not solely a result of switching to a hybrid-electric propulsion architecture. PEGASUS achieves this reduction in CO2e while maintaining satisfactory Level 1 or 2 flight qualities for all of its longitudinal- and lateral-directional modes.

Hybrid-electric

Final Report for Creative 3D Plant Optimization (C3PO) System

Utah State University (USU) and the University of Alabama’s (UA) X-Hab design project created a 3D printed substrate to facilitate plant growth in a microgravity environment. The design team proposed a 3D printed substrate that would allow the plants to have a root support matrix, necessary oxygen flow, and a passive water and nutrient delivery system. This substrate was designed to easily integrate into NASA’s Veggie and Advanced Plant Habitat platforms. 3D printed components are easily replaceable at a relatively low cost. In addition, since research and development has moved to using 3D printers in space, any needed garden components for the blocks could be easily re-printed while in orbit.

Timothy Taylor