Magnus effects on spinning transonic finned missiles
Explore the source record for details and available documents.
Seginer, A.↗
Engineering topics
Seginer, A.
Publications and source records attributed to Seginer, A..
Convergence characteristics of a vortex-lattice method for nonlinear configuration aerodynamics
Explore the source record for details and available documents.
Rusak, Z.↗
Aerodynamics of wraparound fins
Previously cited in issue 07, p. 863, Accession no. A83-21011
Seginer, A.↗
Magnus effects at high angles of attack and critical Reynolds numbers
The Magnus force and moment experienced by a yawed, spinning cylinder were studied experimentally in low speed and subsonic flows at high angles of attack and critical Reynolds numbers. Flow-field visualization aided in describing a flow model that divides the Magnus phenomenon into a subcritical region, where reverse Magnus loads are experienced, and a supercritical region where these loads are not encountered. The roles of the spin rate, angle of attack, and crossflow Reynolds number in determining the boundaries of the subcritical region and the variations of the Magnus loads were studied.
Seginer, A.↗
Magnus effects on spinning transonic missiles
Magnus forces and moments were measured on a basic-finner model spinning in transonic flow. Spin was induced by canted fins or by full-span or semi-span, outboard and inboard roll controls. Magnus force and moment reversals were caused by Mach number, reduced spin rate, and angle of attack variations. Magnus center of pressure was found to be independent of the angle of attack but varied with the Mach number and model configuration or reduced spin rate.
Seginer, A.↗
Numerical calculation of nonlinear aerodynamics of wing-body configurations
Previously cited in issue 07, p. 864, Accession no. A83-21022
Wasserstrom, E.↗
The evaluation of the rolling moments induced by wraparound fins
A possible reason is suggested for the induced rolling moments occurring on wraparound-fin configurations in subsonic flight at zero angle of attack. The subsonic potential flow over the configuration at zero incidence is solved numerically. The body is simulated by a distribution of sources along its axis, and the fins are described by a vortex-lattice method. It is shown that rolling moments can be induced on the antisymmetric fins by the radial flow generated at the base of the configuration, either over the converging separated wake, or over the diverging plume of rocket motor.
Seginer, A.↗
Convergence characteristics of nonlinear vortex-lattice methods for configuration aerodynamics
Nonlinear panel methods have no proof for the existence and uniqueness of their solutions. The convergence characteristics of an iterative, nonlinear vortex-lattice method are, therefore, carefully investigated. The effects of several parameters, including 1) the surface-paneling method, 2) the integration method of the trajectories of the wake vortices, 3) vortex-grid refinement , and 4) the initial conditions for the first iteration on the computed aerodynamic coefficients and on the flow field details are presented. The convergence of the iterative-solution procedure is usually rapid. The solution converges with grid refinement to a constant value, but the final value is not unique and varies with the wing surface-paneling and wake-discretization methods within some range in the vicinity of the experimental result.
Seginer, A.↗
Augmentation of fighter-aircraft performance by spanwise blowing over the wing leading edge
Spanwise blowing over the wing and canard of a 1:35 model of a close-coupled-canard fighter-airplane configuration (similar to the Kfir-C2) was investigated experimentally in low-speed flow. Tests were conducted at airspeeds of 30 m/sec (Reynolds number of 1.8 x 10 to the 5th power based on mean aerodynamic chord) with angle-of-attack sweeps from -8 deg to 60 deg, and yaw-angle sweeps from -8 deg to 36 deg at fixed angles of attack 0 deg, 10 deg, 20 deg, 25 deg, 30 deg, and 35 deg. Significant improvement in lift-curve slope, maximum lift, drag polar and lateral/directional stability was found, enlarging the flight envelope beyond its previous low-speed/maximum-lift limit. In spite of the highly swept (60 deg) leading edge, the efficiency of the lift augmentation by blowing was relatively high and was found to increase with increasing blowing momentum on the close-coupled-canard configuration. Interesting possibilities of obtaining much higher efficiencies with swirling jets were indicated.
Seginer, A.↗
The evaluation of the rolling moments induced by wraparound fins
A possible reason is suggested for the induced rolling moments occurring on wraparound-fin configurations in subsonic flight at zero angle of attack. The subsonic potential flow over the configuration at zero incidence is solved numerically. The body is simulated by a distribution of sources along its axis, and the fins are described by a vortex-lattice method. It is shown that rolling moments can be induced on the antisymmetric fins by the radial flow generated at the base of the configuration, either over the converging separated wake, or over the diverging plume of a rocket motor.
Seginer, A.↗
Convergence characteristics of nonlinear vortex-lattice methods for configuration aerodynamics
Nonlinear panel methods have no proof for the existence and uniqueness of their solutions. The convergence characteristics of an iterative, nonlinear vortex-lattice method are, therefore, carefully investigated. The effects of several parameters, including (1) the surface-paneling method, (2) an integration method of the trajectories of the wake vortices, (3) vortex-grid refinement, and (4) the initial conditions for the first iteration on the computed aerodynamic coefficients and on the flow-field details are presented. The convergence of the iterative-solution procedure is usually rapid. The solution converges with grid refinement to a constant value, but the final value is not unique and varies with the wing surface-paneling and wake-discretization methods within some range in the vicinity of the experimental result.
Seginer, A.↗
Interaction of multiple supersonic jets with a transonic flow field
The influence of multiple high pressure, supersonic, radial or tangential jets, that are injected from the circumference of the base plane of an axisymmetric body, on its longitudinal aerodynamic coefficients in transonic flow is studied experimentally. The interaction of the jets with the body flow field increases the pressures on the forebody, thus altering its lift and static stability characteristics. It is shown that, within the range of parameters studied. This interaction has a stabilizing effect on the body. The contribution to lift and stability is significant at small angles of attack and decreases nonlinearly at higher angles when the crossflow mechanism becomes dominant.
Seginer, A.↗
Augmentation of Fighter-Aircraft Performance by Spanwise Blowing over the Wing Leading Edge
Spanwise blowing over the wing and canard of a 1:35 model of a close-coupled-canard fighter airplane configuration (similar to the Kfir-C2) was investigated experimentally in low-speed flow. Tests were conducted at airspeeds of 30 m/sec (Reynolds number of 1.8 x 10 to the 5th power based on mean aerodynamic chord) with angle-of-attack sweeps from -8 to 60 deg, and yaw-angle sweeps from -8 to 36 deg at fixed angles of attack 0, 10, 20, 25, 30, and 35 deg. Significant improvement in lift-curve slope, maximum lift, drag polar and lateral/directional stability was found, enlarging the flight envelope beyond its previous low-speed/maximum-lift limit. In spite of the highly swept (60 deg) leading edge, the efficiency of the lift augmentation by blowing was relatively high and was found to increase with increasing blowing momentum on the close-coupled-canard configuration. Interesting possibilities of obtaining much higher efficiencies with swirling jets were indicated.
Seginer, A.↗
Chordwise and compressibility corrections for arbitrary planform slender wings
The Lomax and Sluder method for adapting slender-wing theory to delta or rectangular wings by making chordwise and compressibility corrections is extended to cover wings of any arbitrary planform in subsonic and supersonic flows. The numerical accuracy of the present work is better than that of the Lomax-Sluder results. Comparison of the results of this work with those of the vortex-lattice method and Kernel function method for a family of Gothic and arrowhead wings shows good agreement. A universal curve is proposed for the evaluation of the lift coefficient of a low aspect ratio wing of an arbitrary planform in subsonic flow. The location of the center of pressure can also be estimated.
Levin, D.↗
Calculation of transonic flow over supercritical airfoil sections
Two numerical methods for calculating the transonic flow, including viscous effects over lifting airfoil sections and experimental data are compared for turbulent flow over a supercritical airfoil. In addition, results for a NACA 64A010 airfoil at nonzero angle of attack are compared to demonstrate the applicability of the numerical methods to classical, lifting airfoils. One numerical method is a solution to the time-averaged Navier-Stokes equations throughout the entire flow field. The other is a hybrid method that combines inviscid, boundary-layer, and Navier-Stokes equations in appropriate regions of the flow field. Both methods adequately predict the surface pressures and flow field about the 64A010 airfoil at M = 0.8 and alpha = 2 deg when an appropriate turbulence model is used. The methods are not as successful for the supercritical airfoil.
Rose, W. C.↗
An approximate calculation of the strong interaction on a transonic airfoil
This paper describes an interactive computational scheme that calculates the transonic flow field over an airfoil. The inviscid flow, the turbulent boundary layer in the weak interaction region, and the elliptic flow in the strong interaction region are computed separately, and the solutions are matched iteratively in a direct, second-order interaction scheme. The pressure distribution, obtained from a transonic, small-perturbation solution, is prescribed on the boundary layer and the Navier-Stokes equations and the ensuing displacement thicknesses are used to modify the inviscid flow. The best overall results are obtained by using a turbulence model that eliminates the eddy viscosity in the strong interaction region. Computed pressure distributions are compared with experimental data and with Navier-Stokes solutions. In weak interactions, the agreement with experimental data is very good, as it is also in strong interactions except for the pressures in the separated-flow region. There the agreement is qualitative only, and the pressure recovery is too high. The results in both cases are superior or equal to those of the Navier-Stokes solutions, and the present method is significantly faster.
Seginer, A.↗
A numerical solution of the flow field over a transonic airfoil including strong-shock-induced flow separation
An approximate numerical method has been developed for computing the entire transonic flow field over an airfoil, including the boundary layer, the shock-wave/boundary-layer interaction, and the shock-induced-separation. The inviscid flow, the turbulent boundary layer in the weak interaction zone, and the strong interaction elliptic region are solved separately. The inviscid flow is represented by the solution of the transonic small-disturbance equation, while the boundary layer is solved by the generalized Galerkin method, and the strong interaction region (including the wake) is computed from the time-averaged Navier-Stokes equations. A second-order interaction is computed iteratively using the inviscid pressure distribution as a boundary condition for the boundary layer and Navier-Stokes codes, and the viscous displacement thickness to modify the airfoil geometry for the inviscid computation. The computed pressure distributions and shock-wave profiles are compared with experimental data. Agreement is very good except that the pressure recovery on the trailing edge is greater than the experimental data.
Seginer, A.↗
Laminar supersonic flow over a backstep - A numerical solution at higher Reynolds numbers
The Allen-Cheng solution of the flow over a backward facing step is extended to Reynolds numbers up to 16,000 and to inflow boundary-layer height ratios as low as 0.1 by moving the downstream boundary into the recompression region and by smoothing the resulting errors. The boundary conditions in the supersonic outer flow and the downstream boundary conditions in the wake are determined by an extrapolation procedure. Computational results are compared with relevant experimental data. Fair agreement is found between the calculated base pressures and the experimental values, whereas agreement between heat transfer rates appears to be qualitative only.
Kronzon, Y.↗