Search NASA⌕ Search

Engineering topics

Seldner, K.

Publications and source records attributed to Seldner, K..

14 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1980

Performance seeking controls

A performance logic algorithm (PSL) was developed to optimize the performance of propulsion systems for component and sensor degradations by monitoring the performance of the engine system and minimizing thrust specific fuel consumption (TSFC) while retaining a constant engine net thrust. Engine constraints such as surge margin, speed, pressure, and temperature are observed. The PSL algorithm was applied to the quiet, clean, short haul experimental engine. Engine control set points were modified for component degradations in order to restore the nominal net thrust. Results show convergence to the optimum value can be obtained within 60 to 90 seconds, which makes the program acceptable to on line operation with present state of the art minicomputers. Tests indicate that in most cases the PSL algorithm offers some improvement in thrust specific fuel consumption over the manual throttle.

Seldner, K.↗
NASA NTRS1979

A new traffic control design method for large networks with signalized intersections

The paper presents a traffic control design technique for application to large traffic networks with signalized intersections. It is shown that the design method adopts a macroscopic viewpoint to establish a new traffic modelling procedure in which vehicle platoons are subdivided into main stream queues and turning queues. Optimization of the signal splits minimizes queue lengths in the steady state condition and improves traffic flow conditions, from the viewpoint of the traveling public. Finally, an application of the design method to a traffic network with thirty-three signalized intersections is used to demonstrate the effectiveness of the proposed technique.

Leininger, G. G.↗
NASA NTRS1978

Procedures for generation and reduction of linear models of a turbofan engine

A real time hybrid simulation of the Pratt & Whitney F100-PW-F100 turbofan engine was used for linear-model generation. The linear models were used to analyze the effect of disturbances about an operating point on the dynamic performance of the engine. A procedure that disturbs, samples, and records the state and control variables was developed. For large systems, such as the F100 engine, the state vector is large and may contain high-frequency information not required for control. This, reducing the full-state to a reduced-order model may be a practicable approach to simplifying the control design. A reduction technique was developed to generate reduced-order models. Selected linear and nonlinear output responses to exhaust-nozzle area and main-burner fuel flow disturbances are presented for comparison.

Seldner, K.↗
NASA NTRS1977

F100 multivariable control synthesis program: Evaluation of a multivariable control using a real-time engine simulation

The design, evaluation, and testing of a practical, multivariable, linear quadratic regulator control for the F100 turbofan engine were accomplished. NASA evaluation of the multivariable control logic and implementation are covered. The evaluation utilized a real time, hybrid computer simulation of the engine. Results of the evaluation are presented, and recommendations concerning future engine testing of the control are made. Results indicated that the engine testing of the control should be conducted as planned.

Szuch, J. R.↗
NASA NTRS1977

Development and verification of real-time, hybrid computer simulation of F100-PW-100(3) turbofan engine

A real time, hybrid computer simulation of a turbofan engine is described. Controls research programs involving that engine are supported by the simulation. The real time simulation is shown to match the steady state and transient performance of the engine over a wide range of flight conditions and power settings. The simulation equations, FORTRAN listing, and analog patching diagrams are included.

Szuch, J. R.↗
NASA NTRS1977

A computerized traffic control algorithm to determine optimal traffic signal settings

An algorithm was developed to optimally control the traffic signals at each intersection using a discrete time traffic model applicable to heavy or peak traffic. Off line optimization procedures were applied to compute the cycle splits required to minimize the lengths of the vehicle queues and delay at each intersection. The method was applied to an extensive traffic network in Toledo, Ohio. Results obtained with the derived optimal settings are compared with the control settings presently in use.

Seldner, K.↗
NASA NTRS1976

Stimulation of a turbofan engine for evaluation of multivariable optimal control concepts

The development of control systems for jet engines requires a real-time computer simulation. The simulation provides an effective tool for evaluating control concepts and problem areas prior to actual engine testing. The development and use of a real-time simulation of the Pratt and Whitney F100-PW100 turbofan engine is described. The simulation was used in a multi-variable optimal controls research program using linear quadratic regulator theory. The simulation is used to generate linear engine models at selected operating points and evaluate the control algorithm. To reduce the complexity of the design, it is desirable to reduce the order of the linear model. A technique to reduce the order of the model; is discussed. Selected results between high and low order models are compared. The LQR control algorithms can be programmed on digital computer. This computer will control the engine simulation over the desired flight envelope.

Seldner, K.↗
NASA NTRS1976

Simulation of a turbofan engine for evaluation of multivariable optimal control concepts

This paper describes the development and use of a real-time simulation of the F100-PW-100 turbofan engine. The simulation is being used in a multi-variable optimal controls research program using linear quadratic regulatory theory. The simulation is used to generate linear engine models at selected operating points and evaluate the control algorithm. The paper discusses a technique to reduce the order of the model and compares selected results between high and low order models.

Seldner, K.↗
NASA NTRS1975

Real-time simulation of F100-PW-100 turbofan engine using the hybrid computer

A real-time hybrid computer simulation of the F100-PW-100 augmented turbofan is presented. The digital portion of the hybrid computer is used to perform the bivariate function generation associated with modeling the performance of the engine's rotating components. The remaining calculations are performed on the analog computer. Steady state simulation data along with sea level, static, transient data are presented to show that the real-time simulation matches baseline digital simulation results over a wide range of power settings and flight conditions. Steady state simulation data are compared with sea level, experimental data to show that the real-time hybrid and baseline digital simulations do adequately predict the performance of the actual engine. FORTRAN listings and analog patching diagrams are provided.

Szuch, J. R.↗
NASA NTRS1975

Prediction of axial-flow instabilities in a turbojet engine by use of a multistage compressor simulation on the digital computer

A method of estimating the undistorted stall line for an axial-flow compressor by using the digital computer is presented. The method involves linearization of nonlinear dynamic equations about an operating point on a speed line, and then application of the first method of Lyapunov to determine the stability of the nonlinear system from the stability of the linear system. The method is applied to a simulation of the J85 compressor, which utilizes stage stacking and lumped volume techniques for the interstage regions to simulate steady-state and dynamic compressor performance. The stability boundary predicted by the digital simulation compares quite well with the stall line predicted by a dynamic simulation of the J85 compressor programmed on the analog computer. Since previous studies have shown that the analog-predicted stall line agrees well with the stall line of the compressor, the digital method presented is also a good means of estimating the stall line.

Daniele, C. J.↗
NASA NTRS1972

Performance and control study of a low-pressure-ratio turbojet engine for a drone aircraft

The results of analog and digital computer studies of a low-pressure-ratio turbojet engine system for use in a drone vehicle are presented. The turbojet engine consists of a four-stage axial compressor, single-stage turbine, and a fixed area exhaust nozzle. Three simplified fuel schedules and a generalized parameter fuel control for the engine system are presented and evaluated. The evaluation is based on the performance of each schedule or control during engine acceleration from a windmill start at Mach 0.8 and 6100 meters to 100 percent corrected speed. It was found that, because of the higher acceleration margin permitted by the control, the generalized parameter control exhibited the best dynamic performance.

Seldner, K.↗
NASA NTRS1972

Generalized simulation technique for turbojet engine system analysis

A nonlinear analog simulation of a turbojet engine was developed. The purpose of the study was to establish simulation techniques applicable to propulsion system dynamics and controls research. A schematic model was derived from a physical description of a J85-13 turbojet engine. Basic conservation equations were applied to each component along with their individual performance characteristics to derive a mathematical representation. The simulation was mechanized on an analog computer. The simulation was verified in both steady-state and dynamic modes by comparing analytical results with experimental data obtained from tests performed at the Lewis Research Center with a J85-13 engine. In addition, comparison was also made with performance data obtained from the engine manufacturer. The comparisons established the validity of the simulation technique.

Seldner, K.↗