Engineering topics

Sergienko, G.

Publications and source records attributed to Sergienko, G..

4 records

DOE OSTI2022

Characterisation of divertor detachment onset in JET-ILW hydrogen, deuterium, tritium and deuterium–tritium low-confinement mode plasmas

Measurements of the ion currents to and plasma conditions at the low-field side (LFS) divertor target plate in low-confinement mode plasmas in the JET ITER-like wall materials configuration show that the core plasma density required to detach the LFS divertor plasma is independent of the hydrogenic species protium, deuterium and tritium, and a 40 %/60 % deuterium–tritium mixture. This observation applies to a divertor plasma configuration with the LFS strike line connected to the horizontal part of the LFS divertor chosen because of its superior diagnostic coverage. The finding is independent of the operational status of the JET cryogenic pump. The electron temperature (T e ) at the LFS strike line was markedly reduced from 25 eV to 5 eV over a narrow range of increasing core plasma density, and observed to be between 2 eV and 3 eV at the onset of detachment. The electron density (n e ) peaks across the LFS plasma when T e at the target plate is 1 eV, and spatially moves to the X-point for higher core densities. The density limit was found approximately 20 % higher in protium than in tritium and deuterium–tritium plasmas.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

The radiated power limit in impurity seeded JET-ILW plasmas

The total radiated fraction is examined in high density H-mode plasmas (Greenwald fraction of about 85 %) in JET by the variation of the auxiliary heating power of Pheat = 14 MW-29 MW. An achieved radiation fraction of about 75 % at most has been observed in JET-ILW, which is less than the highest achievable (≈90 %) fraction in JET-C during the high radiative power scenarios with N2 seeding. It is shown that the maximal achievable total radiation fraction averaged over ELM cycles has a strong dependence on the radiation efficiency of the ELM energy, $θ_{rad}$: $\gamma^{max}_{rad,total}$ = 1 -$\frac {f_{ELM} x ΔW_{ELM}} {P_heat}$ (1- $θ_{rad}$). About 50 % and 16 % of the ELM induced diamagnetic energy drop (ΔW ELM ) radiates during the ELM in JET-C and JET-ILW, respectively, which corresponds to the maximum total radiated powers of $\gamma^{max}_{rad,JET-C}$ = 0.87 and $\gamma^{max}_{rad,JET-ILW}$ = 0.77. These values of the maximum of the radiative power fractions are in good agreement with $\gamma^{max}_{rad}$ experimentally observed in JET-C (90 %) and JET-ILW (75 %).

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

Experimental study on the role of the target electron temperature as a key parameter linking recycling to plasma performance in JET-ILW*

Changes in global and edge plasma parameters (H98(y,2), dimensionless collisionality ν*, core density peaking, separatrix density ne,sep) with variations in the D2 fueling rate and divertor configuration are unified into a single trend when mapped to $\langle$Te,ot$\rangle$, the spatially averaged spectroscopically derived outer target electron temperature. Dedicated JET with the ITER-like wall (JET-ILW) experiments in combination with an extended JET-ILW database of unseeded low-triangularity H-mode plasmas spanning a wide range of D2 fueling rates, Ip, Bt and heating power have demonstrated the importance of $\langle$Te,ot$\rangle$ as a key physics parameter linking the recycling particle source and detachment with plasma performance. The remarkably robust H98(y,2) trend with $\langle$Te,ot$\rangle$ is connected to a strong inverse correlation between $\langle$Te,ot$\rangle$, ne,sep and ν*, thus directly linking changes in the divertor recycling moderated by $\langle$Te,ot$\rangle$ with the previously established relationship between ν*, core density peaking and core pressure resulting in a degradation in core plasma performance with decreasing $\langle$Te,ot$\rangle$ (increasing ν*). Additionally, a strong inverse correlation between the separatrix to pedestal density ratio, ne,sep/ne,ped, and $\langle$Te,ot$\rangle$ is also established, with the rise in ne,sep/ne,ped saturating at $\langle$Te,ot$\rangle$ > 10 eV. A strong reduction in H98(y,2) is observed as $\langle$Te,ot$\rangle$ is driven from 30 to 10 eV via additional D2 gas fueling, while the divertor remains attached. Consequently, the pronounced performance degradation in attached divertor conditions has implications for impurity seeding radiative divertor scenarios, in which H98(y,2) is already low (~0.7) before impurities are injected into the plasma since moderate gas fueling rates are required to promote high divertor neutral pressure. A favorable pedestal pressure, pe,ped, dependence on Ip has also been observed, with an overall increase in pe,ped at Ip = 3.4 MA as $\langle$Te,ot$\rangle$ is driven down from attached to high-recycling divertor conditions. In contrast, pe,ped is reduced with decreasing $\langle$Te,ot$\rangle$ in the lower Ip branches. Further work is needed to (i) clarify the potential role of edge opacity on the observed favorable pedestal pressure Ip scaling; as well as to (ii) project the global and edge plasma performance trends with $\langle$Te,ot$\rangle$ to reactor-scale devices to improve predictive capability of the coupling between recycling and confined plasma fueling in what are foreseen to be more opaque edge plasma conditions.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2020

Neutral gas analysis for JET DT operation

Neutral gas analysis, the measurement and evaluation of total and partial pressures, is a key technique to study the impact of neutral gas dynamics on retention, recycling and release processes of fuel or impurity species in fusion devices. At JET, the experiment closest to ITER in terms of operating parameters and size, various detectors and techniques for partial pressure and total pressure measurements are deployed together to characterise neutral gas dynamics during and after plasma operation on various toroidal and poloidal locations. An extensive modification of JET's sub-divertor neutral gas diagnostic system aims at retaining and extending established measurement capabilities in the forthcoming Deuterium-Tritium (DT) experiments (DTE2). To achieve DT compatibility, a separation of radiation-sensitive electronics from the sensor and adequate radiation shielding is required, as well as utilisation of a DT compatible differential pumping system with adjustable throughput to account for the strong pressure variation in the sub-divertor region. Finally, the sub-divertor neutral gas diagnostic will be equipped with multiple Residual Gas Analysers (RGAs), utilising quadrupole mass spectrometry and electrostatic ion-trap-principles, all operating with remote electronics located behind the biological radiation shield. These RGAs will record data in a fast selected discrete mass mode during plasma pulses (cycle ~2 s) and will automatically switch back to continuous data recording (cycle ~100 s) afterwards. They will be complemented by a newly improved Penning gauge spectroscopy configuration in particular supporting the He and D 2 separation relevant for DT operation. The distance between these devices and their associated control unit is typically 15m . A newly developed RGA with a cable length of 80 m, compatible with the ITER environment, will also be employed for the first time. Finally, this set-up and its operation in DTE2 will provide vital input to the development of the ITER divertor RGA in the most relevant environment currently available.

47 OTHER INSTRUMENTATION↗