Engineering topics

Shaw, Robert J.

Publications and source records attributed to Shaw, Robert J..

29 records · Page 2

NASA NTRS1992

Comparative study of turbulence models in predicting hypersonic inlet flows

A numerical study was conducted to analyze the performance of different turbulence models when applied to the hypersonic NASA P8 inlet. Computational results from the PARC2D code, which solves the full two-dimensional Reynolds-averaged Navier-Stokes equation, were compared with experimental data. The zero-equation models considered for the study were the Baldwin-Lomax model, the Thomas model, and a combination of the Baldwin-Lomax and Thomas models; the two-equation models considered were the Chien model, the Speziale model (both low Reynolds number), and the Launder and Spalding model (high Reynolds number). The Thomas model performed best among the zero-equation models, and predicted good pressure distributions. The Chien and Speziale models compared wery well with the experimental data, and performed better than the Thomas model near the walls.

Kapoor, Kamlesh↗

NASA NTRS1991

Engine technology challenges for a 21st century high speed civil transport

Recent NASA funded studies by Boeing and Douglas suggest an opportunity exists for a 21st Century High Speed Civil Transport (HSCT) to become part of the international air transportation system. However, before this opportunity for high speed travel can be realized, certain environmental and and economic barrier issues must be overcome. These challenges are outlined. Research activities which NASA has planned to address these barrier issues and to provide a technology base to allow U.S. manufacturers to make an informed go/no go decision on developing the HSCT are discussed.

Shaw, Robert J.↗

NASA NTRS1991

Propulsion challenges for a 21st century economically viable, environmentally compatible High-Speed Civil Transport

Recent NASA funded studies suggest an opportunity exists for a 21st Century High Speed Civil Transport (HSCT) to become part of the international air transportation system. However, before this opportunity for high speed travel can be realized, certain environmental and economic barrier issues must be overcome. These challenges are outlined. Research activities which NASA has planned to address these barrier issues and provide a technology base to allow the U.S. manufacturers to make an informed go/no go decision on developing an HSCT are discussed.

Shaw, Robert J.↗

NASA NTRS1990

The NASA aircraft icing research program

The objective of the NASA aircraft icing research program is to develop and make available to industry icing technology to support the needs and requirements for all-weather aircraft designs. Research is being done for both fixed wing and rotary wing applications. The NASA program emphasizes technology development in two areas, advanced ice protection concepts and icing simulation. Reviewed here are the computer code development/validation, icing wind tunnel testing, and icing flight testing efforts.

Shaw, Robert J.↗

NASA NTRS1989

NASA's program on icing research and technology

NASA's program in aircraft icing research and technology is reviewed. The program relies heavily on computer codes and modern applied physics technology in seeking icing solutions on a finer scale than those offered in earlier programs. Three major goals of this program are to offer new approaches to ice protection, to improve the ability to model the response of an aircraft to an icing encounter, and to provide improved techniques and facilities for ground and flight testing. The following program elements are reviewed: (1) new approaches to ice protection; (2) numerical codes for deicer analysis; (3) measurement and prediction of ice accretion and its effect on aircraft and aircraft components; (4) special wind tunnel test techniques for rotorcraft icing; (5) improvements of icing wind tunnels and research aircraft; (6) ground de-icing fluids used in winter operation; (7) fundamental studies in icing; and (8) droplet sizing instruments for icing clouds.

Reinmann, John J.↗

NASA NTRS1989

NASA's program on icing research and technology

NASA's program in aircraft icing research and technology is reviewed. The program relies heavily on computer codes and modern applied physics technology in seeking icing solutions on a finer scale than those offered in earlier programs. Three major goals of this program are to offer new approaches to ice protection, to improve our ability to model the response of an aircraft to an icing encounter, and to provide improved techniques and facilities for ground and flight testing. This paper reviews the following program elements: (1) new approaches to ice protection; (2) numerical codes for deicer analysis; (3) measurement and prediction of ice accretion and its effect on aircraft and aircraft components; (4) special wind tunnel test techniques for rotorcraft icing; (5) improvements of icing wind tunnels and research aircraft; (6) ground de-icing fluids used in winter operation; (7) fundamental studies in icing; and (8) droplet sizing instruments for icing clouds.

Reinmann, John J.↗

NASA NTRS1989

Predictions of airfoil aerodynamic performance degradation due to icing

An overview of NASA's ongoing efforts to develop an airfoil icing analysis capability is developed. An indication is given to the approaches being followed to calculate the water droplet trajectories past the airfoil, the buildup of ice on the airfoil, and the resultant changes in aerodynamic performance due to the leading edge ice accretion. Examples are given of current code capabilities/limitations through comparisons of predictions with experimental data gathered in various calibration/validation experiments. A brief discussion of future efforts to extend the analysis to handle three-dimensional components is included.

Shaw, Robert J.↗

NASA NTRS1988

NASA's rotorcraft icing research program

The objective of the NASA aircraft icing research program is to develop and make available icing technology to support the needs and requirements of industry for all weather aircraft designs. While a majority of the technology being developed is viewed to be generic (i.e., appropriate to all vehicle classes), vehicle specific emphasis is being placed on the helicopter due to its unique icing problems. In particular, some of the considerations for rotorcraft icing are indicated. The NASA icing research program emphasizes technology development in two key areas: ice protection concepts and icing simulation (analytical and experimental). The NASA research efforts related to rotorcraft icing in these two technology areas will be reviewed.

Shaw, Robert J.↗

NASA NTRS1988

Predictions of airfoil aerodynamic performance degradation due to icing

Shaw, Robert J.↗

NASA NTRS1987

The NASA aircraft icing research program

The objective of the NASA aircraft icing research program is to develop and make available to industry icing technology to support the needs and requirements for all weather aircraft designs. Research is being done for both fixed and rotary wing applications. The NASA program emphasizes technology development in two key areas: advanced ice protection concepts and icing simulation (analytical and experimental). The computer code development/validation, icing wind tunnel testing, and icing flight testing efforts which were conducted to support the icing technology development are reviewed.

Shaw, Robert J.↗

NASA NTRS1987

Particle trajectory computer program for icing analysis of axisymmetric bodies - A progress report

Aircraft exposed to an atmospheric icing environment can accumulate ice, resulting in a sharp increase in drag, a reduction in lift, control surface fouling, and engine damage all of which result in a hazardous flight situation. NASA Lewis Research Center (LeRC) has conducted a program to examine, with the aid of high-speed computer codes, how the trajectories of particles contribute to the ice accumulation on airfoils and engine inlets. For this effort, a computer code was developed to calculate icing particle trajectories and impingement limits for axisymmetric inlets. The original research-oriented NASA code was upgraded and modified to meet the requirements of the design engineer. The improved code is capable of performing trajectory calculations for any atmospheric conditions and droplet sizes. It can handle single droplets or a distribution of various droplet sizes. The four programs that comprise the code are described and the results of a test case using flight conditions for a Fokker F100 icing tunnel test are presented.

Maltezos, Dimitrios G.↗