Search NASA⌕ Search

Engineering topics

Shen, Yuhsyen

Publications and source records attributed to Shen, Yuhsyen.

14 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2020

NASA-ISRO Synthetic Aperture Radar (NISAR) Mission

NISAR is a multi-disciplinary Earth-observing radar mission that makes global measurements of land surface changes that will greatly improve Earth system models. NISAR data will clarify spatially and temporally complex phenomena, including ecosystem disturbances, ice sheet collapse, and natural hazards including earthquakes, tsunamis, volcanoes, and landslides. It provides societally relevant data that will enable better protection of life and property. The mission, a NASA-ISRO partnership, uses two fully polarimetric SARs, one at L-band (L-SAR) and one at S-band (S-SAR), in exact repeating orbits every 12 days that allows interferometric combination of data on repeated passes. NASA provides the L SAR; a shared deployable reflector; an engineering payload that supports mission-specific data handling, navigation and communication functions; science observation planning and L SAR data processing. ISRO provides the S-SAR, spacecraft, launch vehicle, satellite operations, and S-SAR data processing. The mission will be launched from the Satish Dhawan Space Centre, Sriharikota, India. Mission development has addressed many unique challenges and incorporates many “firsts” for a jointly-developed free-flyer radar science mission.

Sarma, C V H S↗
NASA NTRS2017

Comparative View of Antenna/RF Subsystems between SIR-C and NISAR L-band SAR Systems for Wide-Swath Imaging

In 1994, SIR-C demonstrated ScanSAR, a mode of operating the SAR system that has become the “standard” implementation for wide-swath spaceborne imaging SAR systems. The NISAR SAR instruments introducing a new SAR architecture for wide-swath imaging call SweepSAR which is expected to have similar success. This paper compares the Antenna and RF subsystem design and the technology utilization considerations between the SIR-C planar phased array SAR system using the ScanSAR technique and NISAR off-set reflector with phased array feed using the SweepSAR technique.

Shaffer, Scott↗
NASA NTRS2010

The DESDynI Synthetic Aperture Radar Array-Fed Reflector Antenna

DESDynI is a mission being developed by NASA with radar and lidar instruments for Earth-orbit remote sensing. This paper focuses on the design of a largeaperture antenna for the radar instrument. The antenna comprises a deployable reflector antenna and an active switched array of patch elements fed by transmit/ receive modules. The antenna and radar architecture facilitates a new mode of synthetic aperture radar imaging called 'SweepSAR'. A system-level description of the antenna is provided, along with predictions of antenna performance.

Chamberlain, Neil↗
NASA NTRS2000

Shuttle Radar Topography Mission (SRTM) Flight System Design and Operations Overview

This paper provides an overview of the Shuttle Radar Topography Mission (SRTM), with emphasis on flight system implementation and mission operations from systems engineering perspective. Successfully flown in February, 2000, the SRTM's primary payload consists of several subsystems to form the first spaceborne dual-frequency (C-band and X-band) fixed baseline interferometric synthetic aperture radar (InSAR) system, with the mission objective to acquire data sets over 80% of Earth's landmass for height reconstruction. The paper provides system architecture, unique design features, engineering budgets, design verification, in-flight checkout and data acquisition of the SRTM payload, in particular for the C-band system. Mission operation and post-mission data processing activities are also presented. The complexity of the SRTM as a system, the ambitious mission objective, the demanding requirements and the high interdependency between multi-disciplined subsystems posed many challenges. The engineering experience and the insight thus gained have important implications for future spaceborne interferometric SAR mission design and implementation.

Shen, Yuhsyen↗
NASA NTRS1993

Comparison Of Two Methods Of Calibrating Polarimetric SAR

Report presents comparative analysis of two approaches to calibration of synthetic-aperture radar (SAR). Performed in context of NASA/JPL SAR system mounted in DC-8 airplane, also applicable to any polarimetric SAR system of similar design. Demonstrates functional equivalence of two approaches to calibration. In one, known as Klein's approach, SAR data calibrated supplied in scattering-matrix format. Other named after van Zyl, data calibrated supplied in Stokes-matrix (compressed) format.

Freeman, Anthony↗
NASA NTRS1993

Calibration Of NASA/JPL DC-8 SAR Data

Report describes recent improvements in calibration of data gathered by polarimetric synthetic-aperture-radar (SAR) system operated by NASA's Jet Propulsion Laboratory. Improvements are: relocation of calibration site; JPL POLCAL software; and ANTENCAL software. Presents analysis of calibration performance over number of sites during years 1989 and 1990.

Freeman, Anthony↗
NASA NTRS1992

Calibration of Stokes and scattering matrix format polarimetric SAR data

An equivalence is noted between the backscatter and the polarimetric radar system assumptions for the approaches given by Klein (1992) and van Zyl (1990). It is shown that, to first order in the radar system crosstalk, an exact solution to the Stokes matrix format data calibration problem exists, and that van Zyl's approach can give this first-order solution for appropriately symmetrized polarimetric radar data. If the data are suitably symmetrized, the van Zyl approach can be used to calibrate both scattering matrix and Stokes matrix format data.

Freeman, Anthony↗
NASA NTRS1990

Polarimetric SAR calibration experiment using active radar calibrators

Active radar calibrators are used to derive both the amplitude and phase characteristics of a multichannel polarimetric SAR from the complex image data. Results are presented from an experiment carried out using the NASA/JPL DC-8 aircraft SAR over a calibration site at Goldstone, California. As part of the experiment, polarimetric active radar calibrators (PARCs) with adjustable polarization signatures were deployed. Experimental results demonstrate that the PARCs can be used to calibrate polarimetric SAR images successfully. Restrictions on the application of the PARC calibration procedure are discussed.

Freeman, Anthony↗
NASA NTRS1989

Image understanding and interpretation in microwave diversity imaging

The authors investigate microwave imaging of metallic objects using a diversity method and interpret and predict the reconstructed image from an approach based on analysis of the scattering mechanism and a back-projection algorithm used in image retrieval. The connection between the various scattering mechanisms and the reconstructed images is discussed, what the images represent is interpreted, and a prediction is made as to what the image will look like over given spectral and angular windows. A brief description is given of the microwave diversity imaging system and the formulation of the microwave diversity imaging based on the physical optics approximation. The scattering mechanism of a complex shaped metallic object is then briefly reviewed and an alternate approach to interpreting the reconstructed image based on the understanding of the scattering mechanism and the reconstruction algorithm is given. Several numerical and experimental examples are included to support this interpretation approach.

Li, Hsueh-Jyh↗
NASA NTRS1989

Image interpretation and prediction in microwave diversity imaging

The microwave image of a metallic object is interpreted from a point of view based on the understanding of the interconnection between the scattering mechanisms, the data acquisition system, and the image reconstruction algorithm. From this understanding it is possible to interpret and predict microwave images reconstructed from data collected over specified and angular windows. The connection between a special scattering mechanism, edge diffraction, and its reconstructed image is established. The microwave image of an edge is two bright points whose locations correspond to the end points of the edge if the normal aspect angle is not included in the angular windows; otherwise a line joining the two end points and representing the edge will appear in the image. Experimental images of a trihedral reflector constructed from data collected over different angular windows support this approach to image interpretation and prediction.

Li, Hsueh-Jyh↗
NASA NTRS1989

Range profiles and images of a loaded straight wire

The range-profiles and images of a straight wire without and with lumped impedance loading are discussed and demonstrated. The scattering mechanisms of a straight wire are qualitatively analyzed using the method of moments. Plots of range profiles at different aspect angles show that surface traveling waves are important scattering mechanisms of a straight wire. The presence of traveling wave makes ringlike artifacts appear in the reconstructed images. It was found that lumped impedance loading can effectively distort the range profiles and microwave images of a wire scatterer. In addition, randomly varied reactive loading can generate random peaks in the range profiles.

Li, Hsueh-Jyh↗